Skip to content

Wisconsin CDL study: Safe driving, vehicle control and cargo

Two decks cover general knowledge: safe driving and cargo with 70 questions, and rules and licensing with 38. Ten in each are free with explanations. Winter driving lives in the first deck, OWI and crash reporting in the second. Then check yourself in run 1.

1/10·0 done

Question Map

Correct Wrong Unseen

10 of 70 questions are free. The rest are in Pro.

When placing reflective triangles after a commercial vehicle breakdown on a divided Wisconsin highway, where should they be placed?

Free Safe driving, vehicle control and cargo questions for the Wisconsin CDL test

Plain-text version of this question set

  1. When placing reflective triangles after a commercial vehicle breakdown on a divided Wisconsin highway, where should they be placed?

    • A. All three directly behind the vehicle
    • B. 10 feet, 50 feet, and 100 feet behind the vehicle
    • C. 10, 100, and 200 feet toward approaching traffic
    • D. Only one triangle 50 feet behind

    Hint: On a divided road every device goes behind you, and the farthest is 200 feet.

    Explanation: On a divided or one-way road, put all three warning devices behind the truck, facing oncoming traffic: one within 10 feet, one about 100 feet back, and one about 200 feet back. All traffic comes from the same direction, so none go in front. The devices must be out within 10 minutes of stopping.

  2. Where must you go to take the CDL skills test in Wisconsin?

    • A. A WisDOT-authorized CDL testing location
    • B. Any police station in the county
    • C. Any high school parking lot after hours
    • D. A federal DOT field office

    Hint: Wisconsin's transportation department authorizes specific locations for CDL testing.

    Explanation: CDL skills tests in Wisconsin must be taken at a WisDOT-authorized testing location. WisDOT (Wisconsin Department of Transportation) oversees all CDL testing and licensing in the state.

  3. What should you do if your low air pressure warning comes on while driving?

    • A. Continue driving but avoid using the brakes until pressure rebuilds
    • B. Increase engine speed to help the compressor build pressure faster
    • C. Stop and safely park as soon as possible
    • D. Turn off the air dryer and switch to manual mode

    Hint: A low air pressure warning while driving requires immediate action to prevent complete brake failure.

    Explanation: If the low air pressure warning activates, you should stop and safely park as soon as possible. Continued driving risks losing braking ability entirely if pressure drops further, which would engage the spring brakes uncontrollably.

  4. The longer the combination vehicle, the more the trailer will off-track. What should a driver do when making a right turn with a long trailer?

    • A. Speed up through the turn to reduce off-tracking
    • B. Turn the steering wheel quickly to complete the turn faster
    • C. Turn from the far right lane to minimize the turning arc
    • D. Swing wide to the left before turning right

    Hint: Longer vehicles have more severe off-tracking, requiring a specific turning technique.

    Explanation: With longer combination vehicles, drivers should swing wide or use a jug handle turn, moving slightly to the left before turning right to give the trailer wheels room to clear the curb and any objects on the inside of the turn.

  5. Which of the following is an out-of-service condition that would prevent you from driving the vehicle?

    • A. A small crack in the windshield on the passenger side
    • B. Brake drums cracked through the wall
    • C. One burned-out clearance marker light
    • D. A missing mud flap on the rear axle

    Hint: Certain defects are so severe that the vehicle cannot legally be driven until they are repaired.

    Explanation: Cracked brake drums that have cracks extending through the drum wall are a critical out-of-service violation. The vehicle cannot be driven until the brake drums are replaced.

  6. What is the maximum weight allowed on a single axle under federal bridge law?

    • A. 20,000 lbs
    • B. 15,000 lbs
    • C. 34,000 lbs
    • D. 25,000 lbs

    Hint: Federal bridge law sets specific weight limits for individual axles to protect road infrastructure.

    Explanation: Federal bridge law limits a single axle to 20,000 lbs and a tandem axle to 34,000 lbs. The total gross vehicle weight is limited to 80,000 lbs on interstate highways.

  7. When transporting hazardous materials, placards must be placed on which sides of the vehicle?

    • A. Front and back only
    • B. Only on the side facing oncoming traffic
    • C. All four sides: front, rear, and both sides
    • D. Only on the rear of the vehicle

    Hint: Placards must be visible from all directions to warn emergency responders approaching from any angle.

    Explanation: Hazmat placards must be displayed on all four sides of the vehicle, front, rear, and both sides, so that they are visible from any direction. Each placard must be at least 10 3/4 inches square.

  8. Where must hazardous materials shipping papers be kept while driving?

    • A. In the glove compartment
    • B. In the trailer with the cargo
    • C. In a pouch on the driver's door
    • D. In a locked box mounted behind the cab

    Hint: Shipping papers for hazmat must be immediately accessible to the driver and to emergency responders.

    Explanation: Shipping papers for hazardous materials must be kept in a pouch on the driver's door or in clear view and within the driver's reach while the seat belt is fastened. This allows quick access in an emergency.

  9. At a railroad crossing, a bus carrying passengers must:

    • A. Stop between 15 and 50 feet from the nearest rail
    • B. Slow down to 10 mph and proceed if the tracks are clear
    • C. Only stop if warning lights are flashing
    • D. Honk the horn and proceed across quickly

    Hint: Buses carrying passengers must follow stricter rules at railroad crossings than regular vehicles.

    Explanation: Buses carrying passengers must stop at railroad crossings no closer than 15 feet and no farther than 50 feet from the nearest rail. The driver must look and listen for trains before crossing.

  10. When driving a large commercial vehicle down a long, steep downgrade, you should:

    • A. Place the vehicle in neutral to reduce wear on the engine
    • B. Ride the brakes continuously to maintain a safe speed
    • C. Use a low gear and apply brakes intermittently with firm pressure
    • D. Accelerate slightly to maintain momentum

    Hint: Going down a long grade in a heavy vehicle requires a specific technique to prevent brake failure from overheating.

    Explanation: On long downgrades, use a low gear to let the engine help slow the vehicle and apply brakes with firm, intermittent pressure. Riding the brakes continuously causes them to overheat and fade, potentially resulting in total brake failure.

This pool holds 108 questions, and 38 of them were written for Wisconsin. Winter is the big theme. Expect questions on driving in lake effect snow, handling black ice, what to do when you start to skid on a winter road, and why combination vehicles jackknife on icy highways.

Wisconsin freight shows up too: liquid surge in a dairy tanker, keeping refrigerated cheese at a steady temperature, and the congestion and construction on the busy Milwaukee to Chicago interstate corridor. Licensing items cover OWI, Wisconsin's term for drunk driving, with one question on a first offense in a CMV and another on a second, plus leaving the scene of a crash, filing a written crash report with WisDOT, and the radius that limits farm exemptions.

Some state questions repeat federal numbers such as hours of service and placard thresholds. Learn the reason behind each answer, not just the figure.

Key Topics

  • Lake effect snow, black ice and winter skids
  • OWI and other Wisconsin disqualifications
  • Dairy and refrigerated loads
  • Crash reports and roadside out-of-service orders
  • Hours of service and cargo securement