Wisconsin CDL study: Doubles/Triples questions
All 45 doubles/triples questions are in one deck, with 10 free and explained. Drill coupling until the order is automatic, then dollies and rearward amplification. Once you can walk through a second trailer hookup, take doubles/triples run 1.
Free Doubles/Triples questions questions for the Wisconsin CDL test
Plain-text version of this question set
A converter dolly used in doubles and triples is:
- A. A piece of cargo-handling equipment carried under the trailer
- B. A coupling device that converts a semitrailer to a full trailer
- C. A storage container for spare tires
- D. A type of brake controller
Hint: It converts a semi into a full trailer.
Explanation: A converter dolly is a coupling device of one or two axles and a fifth wheel by which a semitrailer can be coupled to the rear of a tractor-trailer combination, forming a double or triple bottom rig.
When uncoupling a set of doubles, the FIRST step is usually to:
- A. Disconnect the air lines
- B. Pull the dolly away from the rear trailer
- C. Park safely and apply the parking brakes
- D. Lower the landing gear
Hint: Stop motion first - then disassemble.
Explanation: Before uncoupling, park the rig in a straight line on firm, level ground. Apply the parking brakes so the rig won't move.
When making lane changes with doubles or triples, the driver should:
- A. Make quick, sharp lane changes in order to clear the traffic
- B. Use only the right lane
- C. Make slow, gradual lane changes
- D. Honk before each lane change
Hint: Sudden inputs amplify down the train.
Explanation: Steer gently and smoothly when pulling trailers. If you make a quick lane change, the crack-the-whip effect can turn the last trailer over.
The 'B-train' configuration uses:
- A. Two dollies in series
- B. A second fifth wheel on the lead trailer, no dolly
- C. A single trailer
- D. A flatbed trailer fitted with multiple cargo decks
Hint: Built-in fifth wheel - no dolly.
Explanation: A B-train has the second fifth wheel mounted on the frame of the lead trailer; the second trailer couples to it directly with its kingpin. No dolly is required between trailers.
When making turns with a double or triple, the driver should:
- A. Make sharper turns because the trailers will follow
- B. Swing wide to allow for rear-trailer off-tracking
- C. Cross the centerline to give more room
- D. Always make a U-turn instead
Hint: Rear trailers cut tighter than the tractor.
Explanation: Doubles and triples have more off-tracking than single trailers, meaning the rear trailer follows a tighter path than the tractor. The driver must swing wider and watch the rear trailer to avoid hitting curbs, signs, or other vehicles.
The supply (red) air line on a tractor-trailer combination:
- A. Sends only electrical signals, and no air at all
- B. Supplies the trailer tanks and emergency brakes
- C. Carries diesel fuel back to the trailer tanks
- D. Is optional on trailers under 40 feet long
Hint: Red = emergency supply.
Explanation: The supply line (red), or emergency line, supplies air to the trailer's air tanks and controls the emergency brakes. The service line (blue) carries air controlled by the foot brake or the trailer hand brake.
If a converter dolly's air tank gauge shows low pressure, you should:
- A. Drive at low speed to the next stop
- B. Disconnect the air supply line
- C. Ignore it - dolly air pressure is not important
- D. Locate the cause before driving
Hint: Low air = unsafe to drive.
Explanation: If air pressure on a dolly's tank is low, find and fix the cause before driving. Low air pressure may indicate a leak that would prevent the dolly's brakes from working properly.
When coupling a tractor to the lead trailer of a double, the fifth-wheel jaws should:
- A. Close around the head of the kingpin but not the shank
- B. Remain open until movement begins
- C. Close around the shank of the kingpin
- D. Lock only after the trailer is raised
Hint: Around the shank, not just the head.
Explanation: Check the fifth-wheel jaws have closed around the shank of the kingpin (not just the head). Use a flashlight if needed to look under the trailer.
When pulling a double or triple, you notice the second trailer is swaying significantly. You should:
- A. Accelerate to straighten it out
- B. Slow gradually with the foot brake
- C. Use the trailer hand valve to slow the rear
- D. Apply the parking brake
Hint: Smooth deceleration calms sway.
Explanation: If a trailer begins to sway, do not use the trailer hand valve. Slow gradually with the foot brake and avoid sudden steering inputs to dampen the sway.
When inspecting a double or triple, the dolly tow bar eye should be:
- A. Cracked or worn, since that keeps them flexible
- B. Rusted to indicate age
- C. Free of cracks, with the pintle hook latched
- D. Painted any color
Hint: Cracks or unlatched hooks lead to breakaways.
Explanation: Inspect the tow bar eye for cracks or other damage, and make sure the pintle hook is latched and the safety latch is closed. A failed pintle hook or damaged tow bar eye can cause the rear trailer to break loose.
Coupling dominates this 45-question pool, with about three times as many questions as any other subtopic. Converter dollies, pintle hooks, rearward amplification, uncoupling, configurations and air lines fill out the rest. There are no Wisconsin-only questions in the section.
The central idea is the rear trailer. It snaps harder than the one ahead, so it is the likeliest to roll over in a quick lane change; the heavier trailer goes directly behind the tractor; and the converter dolly needs its brakes set or wheels chocked before you couple. You confirm air reaches the last trailer by opening the emergency line valve at its rear.
Winter in Wisconsin multiplies these risks. Slippery roads are a run 1 subtopic, and the general knowledge pool's black ice and skid questions apply here twice over: smooth steering and early, light braking keep a set of doubles from whipping.
Key Topics
- Triples not allowed in Wisconsin
- $5 upgrade plus $10 issuance
- Coupling the second trailer
- Converter dollies and pintle hooks
- Slippery roads and rearward amplification