Pennsylvania CDL study: Pre-Trip Inspection questions
The 51 Pennsylvania pre-trip questions are in one deck, with 10 free and explained. Read them with your vehicle in mind, front to back, since the real inspection follows its layout. Then check your recall with pre-trip run 1.
Free Pre-Trip Inspection questions questions for the Pennsylvania CDL test
Plain-text version of this question set
During an air brake check, at what psi range should the low air pressure warning signal activate?
- A. 25 psi
- B. 40 psi
- C. 60 psi
- D. 80 psi
Hint: The tested number is the ceiling the warning must not fall below.
Explanation: The low air pressure warning signal must come on before air pressure drops below 60 psi. On a dual air system the warning follows whichever tank has the lower pressure.
During a pre-trip inspection, what should you check when inspecting the brake drums and linings?
- A. Drums painted in the manufacturer's original color
- B. Cracked drums and linings that are too thin
- C. Drums that feel cold to the touch before driving
- D. Linings that match the color of the seat upholstery
Hint: Brake component inspection focuses on structural integrity and material condition, not cosmetic appearance.
Explanation: You must check that brake drums are not cracked and that brake linings are not dangerously thin, worn, or oil-soaked. Defective brakes can lead to catastrophic failure, especially on Pennsylvania's steep mountain grades.
Which step of the FMCSA seven-step inspection is the parking brake and service brake test?
- A. Step 2 - Engine compartment
- B. Step 7 - Start the engine and check the brake system
- C. Step 3 - Start engine and inspect inside the cab
- D. Step 5 - Walk-around inspection
Hint: It is the last step, where you confirm the vehicle can stop and steer safely before pulling out.
Explanation: Step 7 is the final brake-system check. With the wheels chocked, you test the parking brake by tugging gently against it in gear, then test the service brake for stopping action and for pull. Steering wheel free play is checked earlier, in step 3, inside the cab.
When inspecting mirrors and windshield during the in-cab check, what is the standard requirement?
- A. Mirrors must be tinted to reduce sun glare
- B. Only the driver-side mirror must be checked
- C. Windshields may have any size crack as long as it is not in the driver's line of sight
- D. Mirrors and glass must be clean, adjusted, and undamaged
Hint: If you cannot see clearly out of it, it is a defect.
Explanation: All mirrors and glass surfaces must be clean and properly adjusted, with no damage or obstructions that impair the driver's view.
What is the minimum legal tread depth for STEERING (front) axle tires on a commercial motor vehicle?
- A. 4/32 inch
- B. 2/32 inch
- C. 6/32 inch
- D. 8/32 inch
Hint: Steering tires need DOUBLE the tread of other tires because they handle directional control.
Explanation: Steering-axle tires must have at least 4/32 inch of tread in every major groove.
While checking the wheels and rims, which of the following indicates a defect?
- A. Cracked rims, missing or loose lug nuts, or rust trails
- B. Lug nuts that are clean and tightened to the specified torque
- C. A rim with a uniform painted finish
- D. Wheel hubs that show no signs of oil leakage
Hint: Rust streaks from lug nuts are a classic warning sign on the skills test.
Explanation: Rim cracks, missing or loose lug nuts, and rust streaks radiating from lug nuts (which indicate the nut is loose and moving) are all defects requiring immediate attention.
During a static air-leak test on a COMBINATION vehicle (tractor + trailer), the maximum allowable air-pressure loss with brakes released is:
- A. 2 psi per minute
- B. 4 psi per minute
- C. 3 psi per minute
- D. 6 psi per minute
Hint: Combinations have more hoses, so they are allowed slightly more leakage.
Explanation: A combination vehicle has more air lines and fittings, so the federal limit is 3 psi per minute (brakes released). Brakes applied raises it to 4 psi per minute.
Which color is the GLAD HAND coupler for the trailer SERVICE air line, and which color is the EMERGENCY (supply) line?
- A. Service = red, Emergency = blue
- B. Service = blue, Emergency = red
- C. Service = green, Emergency = yellow
- D. Service = yellow, Emergency = green
Hint: Emergency is the color of an emergency light.
Explanation: By convention, the service line is BLUE and the emergency (supply) line is RED. Crossing them prevents the trailer brakes from working correctly.
What is required on the rear, sides, and front of most trailers for visibility?
- A. Decorative paint and chrome trim
- B. Only a single red reflector mounted in the center of the rear bumper
- C. Reflective tape or reflectors plus working marker and clearance lights
- D. Mud flaps only
Hint: Reflective tape plus required lighting.
Explanation: Trailers 80 inches or wider must have red-and-white conspicuity tape and marker/clearance/identification lights so they are visible at night and from the sides.
What is a Driver Vehicle Inspection Report (DVIR), and when must one be prepared?
- A. A weekly summary of mileage and fuel use, prepared every Friday for the office
- B. A document filed only when an accident occurs
- C. A written report of vehicle condition and defects, done at each day's end
- D. A fuel-purchase log; prepared at each fuel stop
Hint: It is a daily written record of the vehicle's condition.
Explanation: At the end of each driving day, you must write a DVIR for each vehicle you drove. It must list any defects that affect safe driving, or say that none were found.
Almost the whole pool, 47 of 51 questions, covers the walk-around itself, with one each on air brake checks, tires, brakes and general inspection. Three are written with Pennsylvania drivers in mind: when the low air warning must come on during the air brake check, the minimum tread depth for front tires compared with the others, and what to look for on brake drums and linings, such as cracks and linings worn too thin or soaked with oil.
On test day, saying what you check matters as much as checking it. Name each item, point to it, and say what a defect looks like: a cracked drum, a leaking hose, a loose lug nut. Practice in the same vehicle you will test in, since the order follows its layout.
If the permit runs out before you pass, or it was already renewed once and needs another renewal, PennDOT sends you back to the knowledge tests, so book your skills dates with room to spare.
Key Topics
- Modernized skills test at PennDOT and third-party sites
- Pennsylvania low air warning and tire tread questions
- Brake drums, linings and slack adjusters
- Engine compartment and leaks
- Coupling and lights walk-around