Skip to content

Virginia CDL study: Safe driving, vehicle control and cargo

General knowledge is split into two decks here: safe driving and cargo with 68 questions, and rules and licensing with 37. Each shows 10 free with explanations. Do the licensing deck first if you are new to Virginia rules, then test yourself on run 1.

1/10·0 done

Question Map

Correct Wrong Unseen

10 of 68 questions are free. The rest are in Pro.

What should you do if your air brake system's air compressor stops working while driving on I-81 in the Shenandoah Valley?

Free Safe driving, vehicle control and cargo questions for the Virginia CDL test

Plain-text version of this question set

  1. What should you do if your air brake system's air compressor stops working while driving on I-81 in the Shenandoah Valley?

    • A. Continue driving to the next exit
    • B. Pump the brakes repeatedly to build pressure
    • C. Shift to a lower gear and coast to a stop
    • D. Pull over and stop safely as soon as possible

    Hint: Without the compressor, each brake application uses up stored air with no way to replenish it.

    Explanation: If the air compressor fails, you have limited brake applications available. Pull over and stop safely as soon as possible before air pressure drops too low to brake effectively.

  2. What is the most common cause of jackknifing a combination vehicle on Virginia's mountain roads?

    • A. Turning too sharply at low speed
    • B. Braking too hard on slippery surfaces
    • C. Driving too slowly uphill
    • D. Using the engine brake in first gear

    Hint: The drive wheels lose traction first, causing the tractor to swing sideways relative to the trailer.

    Explanation: Jackknifing most commonly occurs when the drive wheels lock up due to excessive braking, especially on slippery surfaces. Virginia's mountain roads along the Blue Ridge require extra caution.

  3. The longer the combination vehicle, the more the trailer will off-track. What should a driver do when making a right turn with a long trailer?

    • A. Speed up through the turn to reduce off-tracking
    • B. Turn the steering wheel quickly to complete the turn faster
    • C. Turn from the far right lane to minimize the turning arc
    • D. Swing wide to the left before turning right

    Hint: Longer vehicles have more severe off-tracking, requiring a specific turning technique.

    Explanation: With longer combination vehicles, drivers should swing wide or use a jug handle turn, moving slightly to the left before turning right to give the trailer wheels room to clear the curb and any objects on the inside of the turn.

  4. Which of the following is an out-of-service condition that would prevent you from driving the vehicle?

    • A. A small crack in the windshield on the passenger side
    • B. Brake drums cracked through the wall
    • C. One burned-out clearance marker light
    • D. A missing mud flap on the rear axle

    Hint: Certain defects are so severe that the vehicle cannot legally be driven until they are repaired.

    Explanation: Cracked brake drums that have cracks extending through the drum wall are a critical out-of-service violation. The vehicle cannot be driven until the brake drums are replaced.

  5. What is the maximum weight allowed on a single axle under federal bridge law?

    • A. 20,000 lbs
    • B. 15,000 lbs
    • C. 34,000 lbs
    • D. 25,000 lbs

    Hint: Federal bridge law sets specific weight limits for individual axles to protect road infrastructure.

    Explanation: Federal bridge law limits a single axle to 20,000 lbs and a tandem axle to 34,000 lbs. The total gross vehicle weight is limited to 80,000 lbs on interstate highways.

  6. When transporting hazardous materials, placards must be placed on which sides of the vehicle?

    • A. Front and back only
    • B. Only on the side facing oncoming traffic
    • C. All four sides: front, rear, and both sides
    • D. Only on the rear of the vehicle

    Hint: Placards must be visible from all directions to warn emergency responders approaching from any angle.

    Explanation: Hazmat placards must be displayed on all four sides of the vehicle, front, rear, and both sides, so that they are visible from any direction. Each placard must be at least 10 3/4 inches square.

  7. Where must hazardous materials shipping papers be kept while driving?

    • A. In the glove compartment
    • B. In the trailer with the cargo
    • C. In a pouch on the driver's door
    • D. In a locked box mounted behind the cab

    Hint: Shipping papers for hazmat must be immediately accessible to the driver and to emergency responders.

    Explanation: Shipping papers for hazardous materials must be kept in a pouch on the driver's door or in clear view and within the driver's reach while the seat belt is fastened. This allows quick access in an emergency.

  8. When should a bus driver evacuate passengers?

    • A. When there is a fire or the bus cannot be safely moved
    • B. Whenever the bus breaks down
    • C. Only when instructed by emergency services
    • D. Only when the destination has been reached and the door cannot open

    Hint: Bus evacuation is a last resort that should only be initiated when remaining on the bus is more dangerous.

    Explanation: Passengers should be evacuated if there is a fire or danger of fire, or if the bus is in a position that makes staying inside dangerous and the bus cannot be safely moved.

  9. When driving a large commercial vehicle down a long, steep downgrade, you should:

    • A. Place the vehicle in neutral to reduce wear on the engine
    • B. Ride the brakes continuously to maintain a safe speed
    • C. Use a low gear and apply brakes intermittently with firm pressure
    • D. Accelerate slightly to maintain momentum

    Hint: Going down a long grade in a heavy vehicle requires a specific technique to prevent brake failure from overheating.

    Explanation: On long downgrades, use a low gear to let the engine help slow the vehicle and apply brakes with firm, intermittent pressure. Riding the brakes continuously causes them to overheat and fade, potentially resulting in total brake failure.

  10. When stopping at a railroad crossing in a CMV that is required to stop, the driver must stop between what distances from the nearest rail?

    • A. 5 to 25 feet
    • B. 10 to 30 feet
    • C. 15 to 50 feet
    • D. 25 to 75 feet

    Hint: The stopping distance at railroad crossings has specific minimum and maximum limits.

    Explanation: Commercial vehicles required to stop at railroad crossings must stop no closer than 15 feet and no farther than 50 feet from the nearest rail. The driver must then look and listen for approaching trains before proceeding.

This pool holds 105 questions, and 35 of them were written for Virginia. Some cover licensing rules you will see in the state's own material: the separate age floors for intrastate and interstate driving, how long a first DUI in a commercial vehicle disqualifies you and what a second one costs, and the penalty for using a hand-held phone behind the wheel of a CMV.

Others put general rules on Virginia roads. You get questions on truck restrictions, HOV bans and low bridges in the Northern Virginia part of the DC metro area, on spacing warning triangles around a truck disabled on an interstate shoulder in the Shenandoah Valley, on slowing in fog near the Chesapeake Bay, and on weight distribution for loads leaving the Port of Virginia in Norfolk.

A common trap is reading the numbers in these questions as Virginia law. Many are federal rules, so learn why each answer is right, not only the figure.

Key Topics

  • Virginia age, DUI and phone-use rules
  • Northern Virginia truck restrictions and low bridges
  • Cargo securement and weight distribution
  • Hours of service and emergency triangles
  • Mountain grades, fog and night driving