Tennessee CDL study: Pre-Trip Inspection questions
All 50 Tennessee pre-trip questions sit in one deck, and 10 are free. Read them in the order you will walk your truck, saying each check out loud. Then test yourself on pre-trip run 1.
Free Pre-Trip Inspection questions questions for the Tennessee CDL test
Plain-text version of this question set
After beginning a trip, how often should a CDL driver inspect their cargo securement?
- A. Every 50 miles or every hour, whichever comes first
- B. Every 100 miles or every 2 hours, whichever comes first
- C. Only when stopping for fuel
- D. Within the first 50 miles, then every 150 miles or 3 hours
Hint: Cargo inspection timing involves an early first check followed by regular intervals throughout the trip.
Explanation: CDL drivers must inspect cargo within the first 50 miles after beginning a trip, and then recheck it every 150 miles or every 3 hours (whichever comes first).
During a pre-trip inspection, how can you test the service brakes on a vehicle with air brakes?
- A. Pump the brake pedal 10 times rapidly
- B. Only a certified mechanic can test brakes
- C. Move slowly and apply the brakes firmly
- D. Rev the engine and listen for unusual sounds
Hint: Service brake testing requires the vehicle to be moving slowly so you can feel how the brakes respond.
Explanation: To test service brakes during a pre-trip inspection, allow the vehicle to move forward slowly (about 5 mph) and apply the brakes firmly. The vehicle should stop promptly without pulling to one side.
During an air brake check on a dual air system, the air pressure should build from 85 to 100 psi within how long?
- A. 60 seconds
- B. 30 seconds
- C. 90 seconds
- D. 45 seconds
Hint: During an air brake check, there is a specific time limit for the air pressure to build from 85 to 100 psi.
Explanation: Air pressure in a dual air system should build from 85 to 100 psi within 45 seconds. If it takes longer, the air compressor or the system may have a problem.
Which step of the FMCSA seven-step inspection is the parking brake and service brake test?
- A. Step 2 - Engine compartment
- B. Step 7 - Start the engine and check the brake system
- C. Step 3 - Start engine and inspect inside the cab
- D. Step 5 - Walk-around inspection
Hint: It is the last step, where you confirm the vehicle can stop and steer safely before pulling out.
Explanation: Step 7 is the final brake-system check. With the wheels chocked, you test the parking brake by tugging gently against it in gear, then test the service brake for stopping action and for pull. Steering wheel free play is checked earlier, in step 3, inside the cab.
Per FMCSA, how often must a CDL driver inspect their commercial vehicle?
- A. Once per week
- B. Before every trip and after every trip
- C. Only at the start of each day
- D. Only when the vehicle has been flagged for a defect
Hint: Inspection is not a one-time event; safety checks bracket every shift and continue while driving.
Explanation: Federal regulations require a pre-trip inspection before driving, en-route monitoring, and a post-trip inspection with a written DVIR at the end of each day.
When inspecting mirrors and windshield during the in-cab check, what is the standard requirement?
- A. Mirrors must be tinted to reduce sun glare
- B. Only the driver-side mirror must be checked
- C. Windshields may have any size crack as long as it is not in the driver's line of sight
- D. Mirrors and glass must be clean, adjusted, and undamaged
Hint: If you cannot see clearly out of it, it is a defect.
Explanation: All mirrors and glass surfaces must be clean and properly adjusted, with no damage or obstructions that impair the driver's view.
What is the minimum legal tread depth for STEERING (front) axle tires on a commercial motor vehicle?
- A. 4/32 inch
- B. 2/32 inch
- C. 6/32 inch
- D. 8/32 inch
Hint: Steering tires need DOUBLE the tread of other tires because they handle directional control.
Explanation: Steering-axle tires must have at least 4/32 inch of tread in every major groove.
During a static air-leak test on a COMBINATION vehicle (tractor + trailer), the maximum allowable air-pressure loss with brakes released is:
- A. 2 psi per minute
- B. 4 psi per minute
- C. 3 psi per minute
- D. 6 psi per minute
Hint: Combinations have more hoses, so they are allowed slightly more leakage.
Explanation: A combination vehicle has more air lines and fittings, so the federal limit is 3 psi per minute (brakes released). Brakes applied raises it to 4 psi per minute.
What component on a tractor-trailer fifth-wheel coupling locks around the kingpin?
- A. The locking jaws
- B. The release handle for the lock
- C. The trailer skid plate
- D. The frame mounting bracket
Hint: Their name describes what they do.
Explanation: The locking jaws inside the fifth wheel close around the kingpin to secure the trailer. After coupling, you must visually confirm the jaws are fully closed around the kingpin.
Which color is the GLAD HAND coupler for the trailer SERVICE air line, and which color is the EMERGENCY (supply) line?
- A. Service = red, Emergency = blue
- B. Service = blue, Emergency = red
- C. Service = green, Emergency = yellow
- D. Service = yellow, Emergency = green
Hint: Emergency is the color of an emergency light.
Explanation: By convention, the service line is BLUE and the emergency (supply) line is RED. Crossing them prevents the trailer brakes from working correctly.
Almost every one of the 50 questions here is about the inspection itself: the engine compartment, cab checks, lights, brakes, coupling and the walk-around. Three are Tennessee questions, asking the minimum tread for front tires, how often to recheck cargo securement after you leave, and how to test the service brakes on an air brake vehicle (move slowly and brake firmly).
General Knowledge adds a Tennessee question on what to check in the engine compartment: oil, coolant, steering fluid, belts, hoses and leaks. Say each one out loud as you point at it, since the examiner scores what you name.
Before you book, ask the Driver Services Center or your third-party tester what the skills test costs and how soon you can retest after a failed segment. Practice the inspection in the vehicle you will test in, because at a Driver Services Center that vehicle is yours to supply.
Key Topics
- Tennessee skills test booking and the 45-day rule
- Engine compartment checks
- Air brake and service brake tests
- Tires, wheels and front tread
- Cargo securement checks