Oregon CDL study: Pre-Trip Inspection questions
One deck holds all 51 Oregon pre-trip questions; 10 are free. Read them in the order you would circle your vehicle, and say each check aloud as you would for the examiner. Then test yourself with pre-trip run 1.
Free Pre-Trip Inspection questions questions for the Oregon CDL test
Plain-text version of this question set
During the air brake check, with the engine off and the brakes fully applied, what is the maximum air pressure loss rate allowed per minute for a single vehicle?
- A. 1 psi
- B. 2 psi
- C. 3 psi
- D. 4 psi
Hint: Applied is looser than released, and a combination is looser than a single. The applied combination limit is the highest of the four.
Explanation: With the system fully charged and the engine off, hold the foot brake down for one minute and watch the gauge. On this applied test the pressure may not drop more than 3 psi in a minute for a single vehicle or 4 psi for a combination vehicle. The released test, taken with the parking brake pushed in and the brakes off, is stricter: 2 psi for a single vehicle and 3 psi for a combination.
What document must a CDL driver review during the pre-trip inspection if another driver previously operated the vehicle?
- A. The previous driver's inspection report
- B. The vehicle title and current registration
- C. The company's liability insurance policy
- D. The most recent fuel purchase receipt
Hint: A specific document created by the previous driver helps you identify known vehicle issues.
Explanation: Drivers must review the previous driver's vehicle inspection report (DVIR) to check for any reported defects and ensure they have been repaired or noted.
During an air brake check on a dual air system, the air pressure should build from 85 to 100 psi within how long?
- A. 60 seconds
- B. 30 seconds
- C. 90 seconds
- D. 45 seconds
Hint: During an air brake check, there is a specific time limit for the air pressure to build from 85 to 100 psi.
Explanation: Air pressure in a dual air system should build from 85 to 100 psi within 45 seconds. If it takes longer, the air compressor or the system may have a problem.
Per FMCSA, how often must a CDL driver inspect their commercial vehicle?
- A. Once per week
- B. Before every trip and after every trip
- C. Only at the start of each day
- D. Only when the vehicle has been flagged for a defect
Hint: Inspection is not a one-time event; safety checks bracket every shift and continue while driving.
Explanation: Federal regulations require a pre-trip inspection before driving, en-route monitoring, and a post-trip inspection with a written DVIR at the end of each day.
When inspecting mirrors and windshield during the in-cab check, what is the standard requirement?
- A. Mirrors must be tinted to reduce sun glare
- B. Only the driver-side mirror must be checked
- C. Windshields may have any size crack as long as it is not in the driver's line of sight
- D. Mirrors and glass must be clean, adjusted, and undamaged
Hint: If you cannot see clearly out of it, it is a defect.
Explanation: All mirrors and glass surfaces must be clean and properly adjusted, with no damage or obstructions that impair the driver's view.
What is the minimum legal tread depth for STEERING (front) axle tires on a commercial motor vehicle?
- A. 4/32 inch
- B. 2/32 inch
- C. 6/32 inch
- D. 8/32 inch
Hint: Steering tires need DOUBLE the tread of other tires because they handle directional control.
Explanation: Steering-axle tires must have at least 4/32 inch of tread in every major groove.
While checking the wheels and rims, which of the following indicates a defect?
- A. Cracked rims, missing or loose lug nuts, or rust trails
- B. Lug nuts that are clean and tightened to the specified torque
- C. A rim with a uniform painted finish
- D. Wheel hubs that show no signs of oil leakage
Hint: Rust streaks from lug nuts are a classic warning sign on the skills test.
Explanation: Rim cracks, missing or loose lug nuts, and rust streaks radiating from lug nuts (which indicate the nut is loose and moving) are all defects requiring immediate attention.
During a static air-leak test on a COMBINATION vehicle (tractor + trailer), the maximum allowable air-pressure loss with brakes released is:
- A. 2 psi per minute
- B. 4 psi per minute
- C. 3 psi per minute
- D. 6 psi per minute
Hint: Combinations have more hoses, so they are allowed slightly more leakage.
Explanation: A combination vehicle has more air lines and fittings, so the federal limit is 3 psi per minute (brakes released). Brakes applied raises it to 4 psi per minute.
What component on a tractor-trailer fifth-wheel coupling locks around the kingpin?
- A. The locking jaws
- B. The release handle for the lock
- C. The trailer skid plate
- D. The frame mounting bracket
Hint: Their name describes what they do.
Explanation: The locking jaws inside the fifth wheel close around the kingpin to secure the trailer. After coupling, you must visually confirm the jaws are fully closed around the kingpin.
Which color is the GLAD HAND coupler for the trailer SERVICE air line, and which color is the EMERGENCY (supply) line?
- A. Service = red, Emergency = blue
- B. Service = blue, Emergency = red
- C. Service = green, Emergency = yellow
- D. Service = yellow, Emergency = green
Hint: Emergency is the color of an emergency light.
Explanation: By convention, the service line is BLUE and the emergency (supply) line is RED. Crossing them prevents the trailer brakes from working correctly.
Of the 51 questions in this pool, 45 are about the pre-trip itself, and 5 are written for Oregon. Those Oregon items cover the applied air brake leak check with the engine off, minimum tread depth on steer tires compared with the others, exhaust leaks and loose mounts, reading the previous driver's inspection report before you roll, and checking every light, from brake and turn signals to clearance markers.
If a segment goes wrong, the Oregon manual lets you retake the failed segment and any other required segments as early as the next day, as long as an examiner is available. Third-party testers still need their 48 hours. Results stay valid for six months, and after a third-party pass you pay a $40 DMV fee for the certificate of test completion and wait one business day before getting your CDL. Practice on the vehicle you plan to test in, and name each item and the defect you are looking for out loud.
Key Topics
- Oregon skills test providers and scheduling
- Air brake leak check and tread depth
- Engine compartment and exhaust
- Lights, cab and previous inspection report
- Walk-around: tires, wheels and coupling