Skip to content

Oregon CDL study: Safe driving, vehicle control and cargo

Two decks cover the 104-question Oregon General Knowledge pool: safe driving and cargo, with 70 questions, and rules and licensing, with 34. Ten in each are free, each shown with its explanation. Finish a deck, then check yourself on General Knowledge run 1.

1/10·0 done

Question Map

Correct Wrong Unseen

10 of 70 questions are free. The rest are in Pro.

What should you do if your air brakes fail while driving on a steep Cascade mountain grade?

Free Safe driving, vehicle control and cargo questions for the Oregon CDL test

Plain-text version of this question set

  1. What should you do if your air brakes fail while driving on a steep Cascade mountain grade?

    • A. Shift to neutral and coast downhill
    • B. Look for a truck escape ramp and downshift
    • C. Use the emergency brake only to stop
    • D. Turn off the engine immediately to stop

    Hint: Oregon's mountain passes have special infrastructure designed for brake failure emergencies.

    Explanation: On Oregon's steep Cascade mountain grades, truck escape ramps are placed for brake failure emergencies. Downshift to use engine braking and look for an escape ramp. Never shift to neutral.

  2. What is the best way to regain control during a drive-wheel skid on wet Oregon roads?

    • A. Brake hard immediately
    • B. Stop braking and steer where you want to go
    • C. Accelerate to power through the skid
    • D. Turn the wheel in the opposite direction of the skid

    Hint: Recovering from a skid requires allowing the wheels to regain traction before steering.

    Explanation: In a drive-wheel skid, stop braking to allow the wheels to regain traction, then steer in the direction you want the front of the vehicle to go. Oregon's frequent wet roads make skid control an essential CDL skill.

  3. Air brakes have a delay before they begin working after you press the brake pedal. What causes this delay?

    • A. The hydraulic fluid must warm up before flowing
    • B. The brake controller must process the electronic signal
    • C. Air takes time to reach the brake chambers
    • D. The engine must disengage before brakes can be applied

    Hint: Unlike hydraulic brakes that respond instantly, air brakes have a physical delay caused by air travel time.

    Explanation: Air brakes have a brake lag of about half a second because it takes time for the air to travel through the lines to the brakes. This adds to the total stopping distance compared to hydraulic brakes.

  4. The longer the combination vehicle, the more the trailer will off-track. What should a driver do when making a right turn with a long trailer?

    • A. Speed up through the turn to reduce off-tracking
    • B. Turn the steering wheel quickly to complete the turn faster
    • C. Turn from the far right lane to minimize the turning arc
    • D. Swing wide to the left before turning right

    Hint: Longer vehicles have more severe off-tracking, requiring a specific turning technique.

    Explanation: With longer combination vehicles, drivers should swing wide or use a jug handle turn, moving slightly to the left before turning right to give the trailer wheels room to clear the curb and any objects on the inside of the turn.

  5. When inspecting tires during a pre-trip inspection, which condition would require the tire to be replaced before driving?

    • A. A minor scuff mark on the sidewall
    • B. Tread depth of less than 2/32 of an inch on a steer tire
    • C. A tread depth of 5/32 of an inch on a drive tire
    • D. Slightly uneven tread wear across the tire

    Hint: Steer tires have stricter tread depth requirements than drive or trailer tires because they control the vehicle's direction.

    Explanation: Front (steer) tires must have at least 4/32 of an inch tread depth and all other tires at least 2/32. A steer tire with less than 2/32 tread depth is well below the legal minimum and must be replaced immediately.

  6. Where should the heaviest cargo generally be placed in a trailer?

    • A. On the floor, as close to the center of the trailer as possible
    • B. At the front of the trailer near the cab
    • C. At the rear of the trailer, to improve drive-wheel traction
    • D. On top of lighter cargo to compress it

    Hint: Proper cargo placement affects the vehicle's center of gravity and stability.

    Explanation: The heaviest cargo should be placed as low as possible and centered (side to side and front to back) to keep the center of gravity low and balanced. This reduces the risk of rollover and improves handling.

  7. When transporting hazardous materials, placards must be placed on which sides of the vehicle?

    • A. Front and back only
    • B. Only on the side facing oncoming traffic
    • C. All four sides: front, rear, and both sides
    • D. Only on the rear of the vehicle

    Hint: Placards must be visible from all directions to warn emergency responders approaching from any angle.

    Explanation: Hazmat placards must be displayed on all four sides of the vehicle, front, rear, and both sides, so that they are visible from any direction. Each placard must be at least 10 3/4 inches square.

  8. Where must hazardous materials shipping papers be kept while driving?

    • A. In the glove compartment
    • B. In the trailer with the cargo
    • C. In a pouch on the driver's door
    • D. In a locked box mounted behind the cab

    Hint: Shipping papers for hazmat must be immediately accessible to the driver and to emergency responders.

    Explanation: Shipping papers for hazardous materials must be kept in a pouch on the driver's door or in clear view and within the driver's reach while the seat belt is fastened. This allows quick access in an emergency.

  9. How many passengers must a vehicle be designed to carry (including the driver) to require a CDL with a P endorsement?

    • A. 16 or more
    • B. 10 or more
    • C. 12 or more
    • D. 20 or more

    Hint: The passenger threshold that triggers the CDL P endorsement requirement includes the driver in the count.

    Explanation: A CDL with a Passenger (P) endorsement is required to operate any vehicle designed to carry 16 or more passengers, including the driver.

  10. When driving a large commercial vehicle down a long, steep downgrade, you should:

    • A. Place the vehicle in neutral to reduce wear on the engine
    • B. Ride the brakes continuously to maintain a safe speed
    • C. Use a low gear and apply brakes intermittently with firm pressure
    • D. Accelerate slightly to maintain momentum

    Hint: Going down a long grade in a heavy vehicle requires a specific technique to prevent brake failure from overheating.

    Explanation: On long downgrades, use a low gear to let the engine help slow the vehicle and apply brakes with firm, intermittent pressure. Riding the brakes continuously causes them to overheat and fade, potentially resulting in total brake failure.

Oregon material makes up 34 of the 104 questions in this pool. Some turn on state vocabulary and systems: Oregon calls impaired driving DUII, and heavy trucks pay a weight-mile tax based on weight and miles driven rather than a diesel fuel tax. Others put you on the road: picking a low gear before a Cascade or Siskiyou descent, heading for an escape ramp if air brakes fail, chaining up when ODOT activates requirements, and getting through security, weigh-ins and truck routes at the Port of Portland. Timber hauling shows up too, with tiedowns set by log length and stack.

The rest follows the federal manual. Watch the age trap: 18 is enough inside Oregon, but a load that began in another state counts as interstate even on Oregon roads, and that takes 21. The study cards split the pool into 70 safe driving and cargo questions and 34 on rules and licensing, 10 free in each.

Key Topics

  • Oregon DUII rules and the weight-mile tax
  • Cascade and Siskiyou grades, chains and escape ramps
  • Port of Portland and timber loads
  • Cargo securement and inspection
  • Disqualifications and hours of service
  • Placards, railroad crossings and emergencies