North Dakota CDL study: Pre-Trip Inspection questions
All 51 pre-trip questions are in one deck, 10 free. Read them in the order you would walk the truck, front to back, and say each check aloud. When the order feels automatic, try pre-trip run 1.
Free Pre-Trip Inspection questions questions for the North Dakota CDL test
Plain-text version of this question set
During a static air brake test on a combination vehicle, the air pressure should not drop more than how many psi in one minute with the engine off and brakes applied?
- A. 4 psi
- B. 2 psi
- C. 3 psi
- D. 5 psi
Hint: Applied is looser than released, and a combination is looser than a single. The applied combination limit is the highest of the four.
Explanation: With the system fully charged and the engine off, hold the foot brake down for one minute and watch the gauge. On this applied test the pressure may not drop more than 3 psi in a minute for a single vehicle or 4 psi for a combination vehicle. The released test, taken with the parking brake pushed in and the brakes off, is stricter: 2 psi for a single vehicle and 3 psi for a combination.
What is the minimum tread depth required for front tires on a commercial vehicle in North Dakota?
- A. 1/32 inch
- B. 4/32 inch
- C. 2/32 inch
- D. 6/32 inch
Hint: Front steering tires have a higher minimum tread depth than other tires because they are critical for steering control.
Explanation: Front steering tires must have at least 4/32 inch of tread depth. Other tires must have at least 2/32 inch. Proper tread depth is critical for North Dakota's winter conditions.
During an air brake check on a dual air system, the air pressure should build from 85 to 100 psi within how long?
- A. 60 seconds
- B. 30 seconds
- C. 90 seconds
- D. 45 seconds
Hint: During an air brake check, there is a specific time limit for the air pressure to build from 85 to 100 psi.
Explanation: Air pressure in a dual air system should build from 85 to 100 psi within 45 seconds. If it takes longer, the air compressor or the system may have a problem.
Which step of the FMCSA seven-step inspection is the parking brake and service brake test?
- A. Step 2 - Engine compartment
- B. Step 7 - Start the engine and check the brake system
- C. Step 3 - Start engine and inspect inside the cab
- D. Step 5 - Walk-around inspection
Hint: It is the last step, where you confirm the vehicle can stop and steer safely before pulling out.
Explanation: Step 7 is the final brake-system check. With the wheels chocked, you test the parking brake by tugging gently against it in gear, then test the service brake for stopping action and for pull. Steering wheel free play is checked earlier, in step 3, inside the cab.
When inspecting mirrors and windshield during the in-cab check, what is the standard requirement?
- A. Mirrors must be tinted to reduce sun glare
- B. Only the driver-side mirror must be checked
- C. Windshields may have any size crack as long as it is not in the driver's line of sight
- D. Mirrors and glass must be clean, adjusted, and undamaged
Hint: If you cannot see clearly out of it, it is a defect.
Explanation: All mirrors and glass surfaces must be clean and properly adjusted, with no damage or obstructions that impair the driver's view.
During a static air-leak test on a COMBINATION vehicle (tractor + trailer), the maximum allowable air-pressure loss with brakes released is:
- A. 2 psi per minute
- B. 4 psi per minute
- C. 3 psi per minute
- D. 6 psi per minute
Hint: Combinations have more hoses, so they are allowed slightly more leakage.
Explanation: A combination vehicle has more air lines and fittings, so the federal limit is 3 psi per minute (brakes released). Brakes applied raises it to 4 psi per minute.
What component on a tractor-trailer fifth-wheel coupling locks around the kingpin?
- A. The locking jaws
- B. The release handle for the lock
- C. The trailer skid plate
- D. The frame mounting bracket
Hint: Their name describes what they do.
Explanation: The locking jaws inside the fifth wheel close around the kingpin to secure the trailer. After coupling, you must visually confirm the jaws are fully closed around the kingpin.
Which color is the GLAD HAND coupler for the trailer SERVICE air line, and which color is the EMERGENCY (supply) line?
- A. Service = red, Emergency = blue
- B. Service = blue, Emergency = red
- C. Service = green, Emergency = yellow
- D. Service = yellow, Emergency = green
Hint: Emergency is the color of an emergency light.
Explanation: By convention, the service line is BLUE and the emergency (supply) line is RED. Crossing them prevents the trailer brakes from working correctly.
What is the purpose of mud flaps (splash guards) on a tractor-trailer?
- A. Decoration
- B. To prevent water, mud, rocks, and debris from being thrown onto other vehicles
- C. To improve fuel economy
- D. To balance the trailer's weight evenly across both of the rear axle groups
Hint: They keep the truck from throwing rocks and water at cars behind.
Explanation: Mud flaps reduce spray and projectile debris from rear wheels. Most states require them; they must be properly mounted, not torn, not dragging on the ground, and the correct distance from the road surface.
What is a Driver Vehicle Inspection Report (DVIR), and when must one be prepared?
- A. A weekly summary of mileage and fuel use, prepared every Friday for the office
- B. A document filed only when an accident occurs
- C. A written report of vehicle condition and defects, done at each day's end
- D. A fuel-purchase log; prepared at each fuel stop
Hint: It is a daily written record of the vehicle's condition.
Explanation: At the end of each driving day, you must write a DVIR for each vehicle you drove. It must list any defects that affect safe driving, or say that none were found.
Our North Dakota pre-trip pool has 51 questions, and 47 cover the inspection itself: engine compartment, cab, lights, brakes, coupling and the walk-around. Three are North Dakota questions: the most a combination may lose in a static air brake test, the minimum tread on front tires, and which lights you must check.
If your permit expires before you pass, state law lets NDDOT issue a letter of authority to drive to a driver license office, finish the road test and return home, or you can retake the knowledge test for another one-year permit.
On test day, say what you are checking and why: name the part, the condition you want, and the defect that would fail it. Cold-weather checks deserve attention in North Dakota, from draining air tanks to checking that lights are clear of snow and grime. Practice on the same vehicle you will test in.
Key Topics
- North Dakota road test and the modernized format
- Engine compartment and cab checks
- Air brake leakage test
- Tires and lights
- Coupling and walk-around