Skip to content

North Dakota CDL study: Safe driving, vehicle control and cargo

Two decks hold the 109 questions: 70 on safe driving and cargo and 39 on rules and licensing, 10 free in each. Start with safe driving, which carries most of the North Dakota winter questions, then try General Knowledge run 1.

1/10·0 done

Question Map

Correct Wrong Unseen

10 of 70 questions are free. The rest are in Pro.

At what psi should the air compressor governor cut-out pressure occur in a commercial vehicle?

Free Safe driving, vehicle control and cargo questions for the North Dakota CDL test

Plain-text version of this question set

  1. At what psi should the air compressor governor cut-out pressure occur in a commercial vehicle?

    • A. About 100 psi
    • B. About 150 psi
    • C. About 125 psi
    • D. About 175 psi

    Hint: The governor controls maximum air pressure by stopping the compressor at a specific threshold.

    Explanation: The air compressor governor should cut out at approximately 125 psi. The cut-in pressure is typically around 100 psi, when the compressor begins pumping air again.

  2. When coupling a tractor to a trailer, what should you check after locking the fifth wheel?

    • A. Tire pressure on the trailer
    • B. The fuel level in the tractor
    • C. That the kingpin is locked in with no gap
    • D. The trailer registration and lease documents

    Hint: The visual check ensures the mechanical coupling is fully engaged with no gaps.

    Explanation: After coupling, you must visually check that the fifth wheel jaws have closed around the kingpin shank with no space between the upper and lower fifth wheel.

  3. What should you do if your low air pressure warning comes on while driving?

    • A. Continue driving but avoid using the brakes until pressure rebuilds
    • B. Increase engine speed to help the compressor build pressure faster
    • C. Stop and safely park as soon as possible
    • D. Turn off the air dryer and switch to manual mode

    Hint: A low air pressure warning while driving requires immediate action to prevent complete brake failure.

    Explanation: If the low air pressure warning activates, you should stop and safely park as soon as possible. Continued driving risks losing braking ability entirely if pressure drops further, which would engage the spring brakes uncontrollably.

  4. The longer the combination vehicle, the more the trailer will off-track. What should a driver do when making a right turn with a long trailer?

    • A. Speed up through the turn to reduce off-tracking
    • B. Turn the steering wheel quickly to complete the turn faster
    • C. Turn from the far right lane to minimize the turning arc
    • D. Swing wide to the left before turning right

    Hint: Longer vehicles have more severe off-tracking, requiring a specific turning technique.

    Explanation: With longer combination vehicles, drivers should swing wide or use a jug handle turn, moving slightly to the left before turning right to give the trailer wheels room to clear the curb and any objects on the inside of the turn.

  5. Which of the following is an out-of-service condition that would prevent you from driving the vehicle?

    • A. A small crack in the windshield on the passenger side
    • B. Brake drums cracked through the wall
    • C. One burned-out clearance marker light
    • D. A missing mud flap on the rear axle

    Hint: Certain defects are so severe that the vehicle cannot legally be driven until they are repaired.

    Explanation: Cracked brake drums that have cracks extending through the drum wall are a critical out-of-service violation. The vehicle cannot be driven until the brake drums are replaced.

  6. What is the maximum weight allowed on a single axle under federal bridge law?

    • A. 20,000 lbs
    • B. 15,000 lbs
    • C. 34,000 lbs
    • D. 25,000 lbs

    Hint: Federal bridge law sets specific weight limits for individual axles to protect road infrastructure.

    Explanation: Federal bridge law limits a single axle to 20,000 lbs and a tandem axle to 34,000 lbs. The total gross vehicle weight is limited to 80,000 lbs on interstate highways.

  7. When transporting hazardous materials, placards must be placed on which sides of the vehicle?

    • A. Front and back only
    • B. Only on the side facing oncoming traffic
    • C. All four sides: front, rear, and both sides
    • D. Only on the rear of the vehicle

    Hint: Placards must be visible from all directions to warn emergency responders approaching from any angle.

    Explanation: Hazmat placards must be displayed on all four sides of the vehicle, front, rear, and both sides, so that they are visible from any direction. Each placard must be at least 10 3/4 inches square.

  8. At a railroad crossing, a bus carrying passengers must:

    • A. Stop between 15 and 50 feet from the nearest rail
    • B. Slow down to 10 mph and proceed if the tracks are clear
    • C. Only stop if warning lights are flashing
    • D. Honk the horn and proceed across quickly

    Hint: Buses carrying passengers must follow stricter rules at railroad crossings than regular vehicles.

    Explanation: Buses carrying passengers must stop at railroad crossings no closer than 15 feet and no farther than 50 feet from the nearest rail. The driver must look and listen for trains before crossing.

  9. When driving a large commercial vehicle down a long, steep downgrade, you should:

    • A. Place the vehicle in neutral to reduce wear on the engine
    • B. Ride the brakes continuously to maintain a safe speed
    • C. Use a low gear and apply brakes intermittently with firm pressure
    • D. Accelerate slightly to maintain momentum

    Hint: Going down a long grade in a heavy vehicle requires a specific technique to prevent brake failure from overheating.

    Explanation: On long downgrades, use a low gear to let the engine help slow the vehicle and apply brakes with firm, intermittent pressure. Riding the brakes continuously causes them to overheat and fade, potentially resulting in total brake failure.

  10. When stopping at a railroad crossing in a CMV that is required to stop, the driver must stop between what distances from the nearest rail?

    • A. 5 to 25 feet
    • B. 10 to 30 feet
    • C. 15 to 50 feet
    • D. 25 to 75 feet

    Hint: The stopping distance at railroad crossings has specific minimum and maximum limits.

    Explanation: Commercial vehicles required to stop at railroad crossings must stop no closer than 15 feet and no farther than 50 feet from the nearest rail. The driver must then look and listen for approaching trains before proceeding.

Our North Dakota General Knowledge pool has 109 questions, and 39 are built around this state. Winter driving takes several: pulling completely off the road when a blizzard drops visibility to near zero, how black ice forms, what goes in a winter emergency kit, and handling crosswinds on open prairie highways. Others are about North Dakota freight: oversize permits and route planning for oil field equipment in the Bakken, seasonal weight allowances that NDDOT may grant during grain harvest, how live cattle shift a trailer's weight, and the farm exemption within 150 miles of the farm.

Licensing questions cover ages, the X endorsement, DUI disqualifications, which documents you carry in the cab, and the serious traffic violations that can cost a CDL. One bank question gives a renewal period that does not match NDDOT's published rule, so go by the manual on renewal.

The study cards split the pool into 70 safe driving and cargo questions and 39 rules and licensing questions, 10 free in each.

Key Topics

  • Blizzards, black ice and prairie crosswinds
  • Bakken oil field loads and harvest season hauling
  • Farm exemptions and livestock
  • CDL classes, ages and DUI rules
  • Cargo securement and weight
  • Hours of service and emergency equipment