Montana CDL study: Safe driving, vehicle control and cargo
Two decks split Montana's 113 General Knowledge questions: 75 on safe driving and cargo, 38 on rules and licensing. Each deck shows 10 free, with the reason behind every answer. When a deck feels solid, check it on General Knowledge run 1.
Question Map
10 of 75 questions are free. The rest are in Pro.
Free Safe driving, vehicle control and cargo questions for the Montana CDL test
Plain-text version of this question set
What are 'glad hands' on a combination vehicle?
- A. The handles used to open the trailer doors
- B. The couplers that connect the air lines
- C. The levers that release the fifth wheel lock
- D. The hand grips beside the tractor steps
Hint: These coupling devices are named for the hand-clasping motion used when connecting the tractor's and trailer's air systems.
Explanation: Glad hands are the coupling devices used to connect the air lines between the tractor and trailer. They must be properly connected and sealed to maintain air brake pressure throughout the combination vehicle.
If a hazardous material spill occurs during transport on a Montana highway, what is the CDL driver's FIRST responsibility?
- A. Clean up the spill immediately
- B. Continue driving to the nearest truck stop
- C. Keep people away from the area and contact emergency services
- D. Wait for the carrier's dispatcher to provide instructions
Hint: The driver's first priority in a hazmat spill is protecting people, not cleaning up the material.
Explanation: The driver's first responsibility in a hazmat spill is to protect people by keeping them away from the area and immediately contacting emergency services. Provide the shipping papers and hazmat information to responders so they can handle the material safely.
Air brakes have a delay before they begin working after you press the brake pedal. What causes this delay?
- A. The hydraulic fluid must warm up before flowing
- B. The brake controller must process the electronic signal
- C. Air takes time to reach the brake chambers
- D. The engine must disengage before brakes can be applied
Hint: Unlike hydraulic brakes that respond instantly, air brakes have a physical delay caused by air travel time.
Explanation: Air brakes have a brake lag of about half a second because it takes time for the air to travel through the lines to the brakes. This adds to the total stopping distance compared to hydraulic brakes.
The longer the combination vehicle, the more the trailer will off-track. What should a driver do when making a right turn with a long trailer?
- A. Speed up through the turn to reduce off-tracking
- B. Turn the steering wheel quickly to complete the turn faster
- C. Turn from the far right lane to minimize the turning arc
- D. Swing wide to the left before turning right
Hint: Longer vehicles have more severe off-tracking, requiring a specific turning technique.
Explanation: With longer combination vehicles, drivers should swing wide or use a jug handle turn, moving slightly to the left before turning right to give the trailer wheels room to clear the curb and any objects on the inside of the turn.
When inspecting tires during a pre-trip inspection, which condition would require the tire to be replaced before driving?
- A. A minor scuff mark on the sidewall
- B. Tread depth of less than 2/32 of an inch on a steer tire
- C. A tread depth of 5/32 of an inch on a drive tire
- D. Slightly uneven tread wear across the tire
Hint: Steer tires have stricter tread depth requirements than drive or trailer tires because they control the vehicle's direction.
Explanation: Front (steer) tires must have at least 4/32 of an inch tread depth and all other tires at least 2/32. A steer tire with less than 2/32 tread depth is well below the legal minimum and must be replaced immediately.
What can happen if too much cargo weight is placed on the front axle of a truck?
- A. The rear tires will blow out
- B. The front tires can fail or steering can be impaired
- C. The vehicle will understeer and have difficulty turning
- D. The engine will overheat from the extra load
Hint: Overloading the front axle affects the most critical vehicle control system.
Explanation: Overloading the front axle can cause front tire failure and make steering extremely difficult or unresponsive. Proper weight distribution is essential for safe steering and braking.
What is the purpose of a header board (headache rack) on a flatbed truck?
- A. To provide a mounting point for clearance lights
- B. To reduce wind resistance and improve fuel economy
- C. To protect the cab from forward-shifting cargo
- D. To support tarps covering the load
Hint: The header board protects the cab from cargo that shifts forward during braking.
Explanation: A header board (headache rack) is mounted behind the cab to protect the driver from cargo that shifts forward during hard braking or a collision. It acts as a barrier between the cargo and the cab.
Where must hazardous materials shipping papers be kept while driving?
- A. In the glove compartment
- B. In the trailer with the cargo
- C. In a pouch on the driver's door
- D. In a locked box mounted behind the cab
Hint: Shipping papers for hazmat must be immediately accessible to the driver and to emergency responders.
Explanation: Shipping papers for hazardous materials must be kept in a pouch on the driver's door or in clear view and within the driver's reach while the seat belt is fastened. This allows quick access in an emergency.
How many passengers must a vehicle be designed to carry (including the driver) to require a CDL with a P endorsement?
- A. 16 or more
- B. 10 or more
- C. 12 or more
- D. 20 or more
Hint: The passenger threshold that triggers the CDL P endorsement requirement includes the driver in the count.
Explanation: A CDL with a Passenger (P) endorsement is required to operate any vehicle designed to carry 16 or more passengers, including the driver.
When driving a large commercial vehicle down a long, steep downgrade, you should:
- A. Place the vehicle in neutral to reduce wear on the engine
- B. Ride the brakes continuously to maintain a safe speed
- C. Use a low gear and apply brakes intermittently with firm pressure
- D. Accelerate slightly to maintain momentum
Hint: Going down a long grade in a heavy vehicle requires a specific technique to prevent brake failure from overheating.
Explanation: On long downgrades, use a low gear to let the engine help slow the vehicle and apply brakes with firm, intermittent pressure. Riding the brakes continuously causes them to overheat and fade, potentially resulting in total brake failure.
Montana roads shape 43 of the 113 questions here. You will be asked what to do about elk or bison in the road (brake firmly and stay in your lane, since swerving can roll the truck), how to handle black ice, and why bridges, overpasses and shaded curves freeze first. Mountain driving gets its own set: picking the low gear before the descent, not after, snub braking and brake fade on long grades, plus the steep grades, sharp curves and closures around Glacier National Park.
Farm freight shows up too. Grain shifts and raises the center of gravity, and live cattle move on their own, changing how the truck brakes and turns. Other questions cover the farm exemption, the MDT permit for oversize loads, and the old no-daytime-speed-limit days (today you follow posted limits). The study cards divide the pool into 75 safe driving and cargo questions and 38 rules and licensing questions, with 10 free in each deck.
Key Topics
- Montana mountain passes, black ice and wildlife
- Grain and cattle loads, oversize permits
- Type 1 and Type 2 licensing ages
- Cargo securement and weight distribution
- Hours of service and disqualifications
- Railroad crossings and emergencies