Hawaii CDL study: Pre-Trip Inspection questions
This deck holds 50 pre-trip questions for Hawaii, 10 free, with 4 Hawaii items on steering, tires, coolant and the last inspection report. Work through it front to back like a real walk-around, then take pre-trip run 1.
Free Pre-Trip Inspection questions questions for the Hawaii CDL test
Plain-text version of this question set
During a pre-trip inspection, what is the minimum tread depth required for front tires on a commercial vehicle?
- A. 2/32 of an inch
- B. 6/32 of an inch
- C. 4/32 of an inch
- D. 8/32 of an inch
Hint: Front tires have a higher tread depth requirement than other tires because they are critical for steering.
Explanation: Front tires must have a tread depth of at least 4/32 of an inch. Other tires must have at least 2/32 of an inch. Hawaii's frequent rain makes adequate tire tread especially important for traction.
Why is checking the coolant level especially important for commercial vehicles operating in Hawaii?
- A. Hawaii's cold mountain temperatures require extra antifreeze
- B. Hawaii's warm climate and steep grades cause overheating
- C. Salt air corrodes the radiator faster, requiring more coolant
- D. Hawaii law requires coolant checks before every trip
Hint: Hawaii's tropical climate combined with steep terrain creates a double challenge for engine cooling systems.
Explanation: Hawaii's warm tropical climate combined with steep volcanic mountain grades puts extra stress on cooling systems. Overheating is a significant concern when climbing and descending island terrain with heavy loads.
During an air brake check on a dual air system, the air pressure should build from 85 to 100 psi within how long?
- A. 60 seconds
- B. 30 seconds
- C. 90 seconds
- D. 45 seconds
Hint: During an air brake check, there is a specific time limit for the air pressure to build from 85 to 100 psi.
Explanation: Air pressure in a dual air system should build from 85 to 100 psi within 45 seconds. If it takes longer, the air compressor or the system may have a problem.
Which step of the FMCSA seven-step inspection is the parking brake and service brake test?
- A. Step 2 - Engine compartment
- B. Step 7 - Start the engine and check the brake system
- C. Step 3 - Start engine and inspect inside the cab
- D. Step 5 - Walk-around inspection
Hint: It is the last step, where you confirm the vehicle can stop and steer safely before pulling out.
Explanation: Step 7 is the final brake-system check. With the wheels chocked, you test the parking brake by tugging gently against it in gear, then test the service brake for stopping action and for pull. Steering wheel free play is checked earlier, in step 3, inside the cab.
Per FMCSA, how often must a CDL driver inspect their commercial vehicle?
- A. Once per week
- B. Before every trip and after every trip
- C. Only at the start of each day
- D. Only when the vehicle has been flagged for a defect
Hint: Inspection is not a one-time event; safety checks bracket every shift and continue while driving.
Explanation: Federal regulations require a pre-trip inspection before driving, en-route monitoring, and a post-trip inspection with a written DVIR at the end of each day.
When inspecting mirrors and windshield during the in-cab check, what is the standard requirement?
- A. Mirrors must be tinted to reduce sun glare
- B. Only the driver-side mirror must be checked
- C. Windshields may have any size crack as long as it is not in the driver's line of sight
- D. Mirrors and glass must be clean, adjusted, and undamaged
Hint: If you cannot see clearly out of it, it is a defect.
Explanation: All mirrors and glass surfaces must be clean and properly adjusted, with no damage or obstructions that impair the driver's view.
During a static air-leak test on a COMBINATION vehicle (tractor + trailer), the maximum allowable air-pressure loss with brakes released is:
- A. 2 psi per minute
- B. 4 psi per minute
- C. 3 psi per minute
- D. 6 psi per minute
Hint: Combinations have more hoses, so they are allowed slightly more leakage.
Explanation: A combination vehicle has more air lines and fittings, so the federal limit is 3 psi per minute (brakes released). Brakes applied raises it to 4 psi per minute.
What component on a tractor-trailer fifth-wheel coupling locks around the kingpin?
- A. The locking jaws
- B. The release handle for the lock
- C. The trailer skid plate
- D. The frame mounting bracket
Hint: Their name describes what they do.
Explanation: The locking jaws inside the fifth wheel close around the kingpin to secure the trailer. After coupling, you must visually confirm the jaws are fully closed around the kingpin.
Which color is the GLAD HAND coupler for the trailer SERVICE air line, and which color is the EMERGENCY (supply) line?
- A. Service = red, Emergency = blue
- B. Service = blue, Emergency = red
- C. Service = green, Emergency = yellow
- D. Service = yellow, Emergency = green
Hint: Emergency is the color of an emergency light.
Explanation: By convention, the service line is BLUE and the emergency (supply) line is RED. Crossing them prevents the trailer brakes from working correctly.
What is the purpose of mud flaps (splash guards) on a tractor-trailer?
- A. Decoration
- B. To prevent water, mud, rocks, and debris from being thrown onto other vehicles
- C. To improve fuel economy
- D. To balance the trailer's weight evenly across both of the rear axle groups
Hint: They keep the truck from throwing rocks and water at cars behind.
Explanation: Mud flaps reduce spray and projectile debris from rear wheels. Most states require them; they must be properly mounted, not torn, not dragging on the ground, and the correct distance from the road surface.
This pool has 50 questions, almost all on the walk-around, with 4 written for Hawaii. One asks what you check on the steering system: free play, the gear box and power steering fluid. Another covers the minimum front tire tread depth. A third asks why coolant matters here, since warm weather and steep grades make overheating more likely, and a fourth names your first step: review the last vehicle inspection report.
On the test, you describe each item as you inspect it: what it is, what you are checking for, such as leaks, cracks or loose mounts, and you point to it or touch it. Engine compartment, steering, suspension, brakes, wheels and tires, lights, and coupling devices on a combination are the standard sections.
Hawaii rules say the skills test examiner and applicant may not use another language. Practice saying each item in English until you can say it without pausing. The HDOT CDL manual lists the test rules.
Key Topics
- Hawaii's single skills appointment and time limits
- Reviewing the last inspection report
- Steering, tires and coolant
- In-cab air brake check
- Lights and coupling devices