Skip to content

Arkansas CDL study: Pre-Trip Inspection questions

All 50 Arkansas pre-trip questions are in this deck, 10 free. Nearly all cover the inspection walk-around, and 2 are framed around Arkansas. Study them in the order you would walk the truck, then try pre-trip run 1.

1/10·0 done

Question Map

Correct Wrong Unseen

10 of 50 questions are free. The rest are in Pro.

During a pre-trip inspection, what is the minimum tread depth for front tires on a commercial vehicle?

Free Pre-Trip Inspection questions questions for the Arkansas CDL test

Plain-text version of this question set

  1. During a pre-trip inspection, what is the minimum tread depth for front tires on a commercial vehicle?

    • A. 4/32 of an inch
    • B. 2/32 of an inch
    • C. 6/32 of an inch
    • D. 8/32 of an inch

    Hint: Front tires have stricter tread depth requirements because they carry the steering load.

    Explanation: Front tires must have a minimum tread depth of 4/32 of an inch. Other tires must have at least 2/32 of an inch.

  2. What must a CDL driver do if they find a defect during a pre-trip inspection?

    • A. Drive to the nearest repair shop
    • B. Report it and do not drive until repaired
    • C. Note it in the logbook and continue driving
    • D. Call their employer for instructions

    Hint: Safety-affecting defects create a legal obligation to stop driving until repairs are made.

    Explanation: If a safety-affecting defect is found during a pre-trip inspection, the driver must report it and not operate the vehicle until the defect is repaired.

  3. During an air brake check on a dual air system, the air pressure should build from 85 to 100 psi within how long?

    • A. 60 seconds
    • B. 30 seconds
    • C. 90 seconds
    • D. 45 seconds

    Hint: During an air brake check, there is a specific time limit for the air pressure to build from 85 to 100 psi.

    Explanation: Air pressure in a dual air system should build from 85 to 100 psi within 45 seconds. If it takes longer, the air compressor or the system may have a problem.

  4. Which step of the FMCSA seven-step inspection is the parking brake and service brake test?

    • A. Step 2 - Engine compartment
    • B. Step 7 - Start the engine and check the brake system
    • C. Step 3 - Start engine and inspect inside the cab
    • D. Step 5 - Walk-around inspection

    Hint: It is the last step, where you confirm the vehicle can stop and steer safely before pulling out.

    Explanation: Step 7 is the final brake-system check. With the wheels chocked, you test the parking brake by tugging gently against it in gear, then test the service brake for stopping action and for pull. Steering wheel free play is checked earlier, in step 3, inside the cab.

  5. When inspecting mirrors and windshield during the in-cab check, what is the standard requirement?

    • A. Mirrors must be tinted to reduce sun glare
    • B. Only the driver-side mirror must be checked
    • C. Windshields may have any size crack as long as it is not in the driver's line of sight
    • D. Mirrors and glass must be clean, adjusted, and undamaged

    Hint: If you cannot see clearly out of it, it is a defect.

    Explanation: All mirrors and glass surfaces must be clean and properly adjusted, with no damage or obstructions that impair the driver's view.

  6. While checking the wheels and rims, which of the following indicates a defect?

    • A. Cracked rims, missing or loose lug nuts, or rust trails
    • B. Lug nuts that are clean and tightened to the specified torque
    • C. A rim with a uniform painted finish
    • D. Wheel hubs that show no signs of oil leakage

    Hint: Rust streaks from lug nuts are a classic warning sign on the skills test.

    Explanation: Rim cracks, missing or loose lug nuts, and rust streaks radiating from lug nuts (which indicate the nut is loose and moving) are all defects requiring immediate attention.

  7. During a static air-leak test on a COMBINATION vehicle (tractor + trailer), the maximum allowable air-pressure loss with brakes released is:

    • A. 2 psi per minute
    • B. 4 psi per minute
    • C. 3 psi per minute
    • D. 6 psi per minute

    Hint: Combinations have more hoses, so they are allowed slightly more leakage.

    Explanation: A combination vehicle has more air lines and fittings, so the federal limit is 3 psi per minute (brakes released). Brakes applied raises it to 4 psi per minute.

  8. What component on a tractor-trailer fifth-wheel coupling locks around the kingpin?

    • A. The locking jaws
    • B. The release handle for the lock
    • C. The trailer skid plate
    • D. The frame mounting bracket

    Hint: Their name describes what they do.

    Explanation: The locking jaws inside the fifth wheel close around the kingpin to secure the trailer. After coupling, you must visually confirm the jaws are fully closed around the kingpin.

  9. Which color is the GLAD HAND coupler for the trailer SERVICE air line, and which color is the EMERGENCY (supply) line?

    • A. Service = red, Emergency = blue
    • B. Service = blue, Emergency = red
    • C. Service = green, Emergency = yellow
    • D. Service = yellow, Emergency = green

    Hint: Emergency is the color of an emergency light.

    Explanation: By convention, the service line is BLUE and the emergency (supply) line is RED. Crossing them prevents the trailer brakes from working correctly.

  10. What is a Driver Vehicle Inspection Report (DVIR), and when must one be prepared?

    • A. A weekly summary of mileage and fuel use, prepared every Friday for the office
    • B. A document filed only when an accident occurs
    • C. A written report of vehicle condition and defects, done at each day's end
    • D. A fuel-purchase log; prepared at each fuel stop

    Hint: It is a daily written record of the vehicle's condition.

    Explanation: At the end of each driving day, you must write a DVIR for each vehicle you drove. It must list any defects that affect safe driving, or say that none were found.

That Arkansas box says that when checking steering you must name the steering shaft, steering gear box, pitman arm, drag link, steering arm, tie rod, castle nut and cotter pins. It also lists frame check points. Learn the list in order and say each part out loud as you point to it.

From January 1, 2027, ASP stops banking skills test scores. If you pass the inspection and the control exercises but fail the road test, your retest starts again with the Vehicle Inspection Test. ASP does not publish a wait time or retest fee.

Our pool has 50 pre-trip questions, 47 on the inspection itself. Two are framed around Arkansas, asking about the front tire tread minimum and what you must do when you find a defect: report it and do not drive until it is repaired.

Key Topics

  • Arkansas steering parts to name on the inspection
  • ASP skills test sites and vehicle requirements
  • No banked scores from January 1, 2027
  • Tires, wheels and frame
  • Reporting defects