Arkansas CDL study: Safe driving, vehicle control and cargo
Two decks make up this Arkansas topic. Safe driving and cargo has 68 questions and rules and licensing has 41, with 10 free in each. Skids, jackknifes and emergencies sit mostly in the first. Study both, then try run 1.
Free Safe driving, vehicle control and cargo questions for the Arkansas CDL test
Plain-text version of this question set
What training is required for new CDL applicants in Arkansas under the Entry-Level Driver Training (ELDT) regulation?
- A. No formal training is required in Arkansas
- B. Training from an FMCSA-registered provider
- C. Online training from any provider
- D. Self-study using the Arkansas CDL manual
Hint: This training requirement was implemented to ensure all new CDL drivers receive standardized, quality instruction.
Explanation: Under ELDT regulations effective February 2022, new CDL applicants must complete training from a provider listed on the FMCSA Training Provider Registry.
When descending a steep grade in a commercial vehicle, what is the proper braking technique?
- A. Apply brakes continuously at light pressure
- B. Apply brakes hard at the top and release at the bottom
- C. Coast in neutral to save fuel
- D. Use the snub braking method
Hint: The correct technique involves intermittent braking that allows the brakes to cool between applications.
Explanation: Use the snub braking method: apply firm brake pressure to reduce speed by about 5 mph below your safe speed, then release brakes to allow them to cool. Repeat as needed.
What should you do if your low air pressure warning comes on while driving?
- A. Continue driving but avoid using the brakes until pressure rebuilds
- B. Increase engine speed to help the compressor build pressure faster
- C. Stop and safely park as soon as possible
- D. Turn off the air dryer and switch to manual mode
Hint: A low air pressure warning while driving requires immediate action to prevent complete brake failure.
Explanation: If the low air pressure warning activates, you should stop and safely park as soon as possible. Continued driving risks losing braking ability entirely if pressure drops further, which would engage the spring brakes uncontrollably.
The longer the combination vehicle, the more the trailer will off-track. What should a driver do when making a right turn with a long trailer?
- A. Speed up through the turn to reduce off-tracking
- B. Turn the steering wheel quickly to complete the turn faster
- C. Turn from the far right lane to minimize the turning arc
- D. Swing wide to the left before turning right
Hint: Longer vehicles have more severe off-tracking, requiring a specific turning technique.
Explanation: With longer combination vehicles, drivers should swing wide or use a jug handle turn, moving slightly to the left before turning right to give the trailer wheels room to clear the curb and any objects on the inside of the turn.
When inspecting tires during a pre-trip inspection, which condition would require the tire to be replaced before driving?
- A. A minor scuff mark on the sidewall
- B. Tread depth of less than 2/32 of an inch on a steer tire
- C. A tread depth of 5/32 of an inch on a drive tire
- D. Slightly uneven tread wear across the tire
Hint: Steer tires have stricter tread depth requirements than drive or trailer tires because they control the vehicle's direction.
Explanation: Front (steer) tires must have at least 4/32 of an inch tread depth and all other tires at least 2/32. A steer tire with less than 2/32 tread depth is well below the legal minimum and must be replaced immediately.
What is the purpose of a header board (headache rack) on a flatbed truck?
- A. To provide a mounting point for clearance lights
- B. To reduce wind resistance and improve fuel economy
- C. To protect the cab from forward-shifting cargo
- D. To support tarps covering the load
Hint: The header board protects the cab from cargo that shifts forward during braking.
Explanation: A header board (headache rack) is mounted behind the cab to protect the driver from cargo that shifts forward during hard braking or a collision. It acts as a barrier between the cargo and the cab.
When transporting hazardous materials, placards must be placed on which sides of the vehicle?
- A. Front and back only
- B. Only on the side facing oncoming traffic
- C. All four sides: front, rear, and both sides
- D. Only on the rear of the vehicle
Hint: Placards must be visible from all directions to warn emergency responders approaching from any angle.
Explanation: Hazmat placards must be displayed on all four sides of the vehicle, front, rear, and both sides, so that they are visible from any direction. Each placard must be at least 10 3/4 inches square.
Where must hazardous materials shipping papers be kept while driving?
- A. In the glove compartment
- B. In the trailer with the cargo
- C. In a pouch on the driver's door
- D. In a locked box mounted behind the cab
Hint: Shipping papers for hazmat must be immediately accessible to the driver and to emergency responders.
Explanation: Shipping papers for hazardous materials must be kept in a pouch on the driver's door or in clear view and within the driver's reach while the seat belt is fastened. This allows quick access in an emergency.
At a railroad crossing, a bus carrying passengers must:
- A. Stop between 15 and 50 feet from the nearest rail
- B. Slow down to 10 mph and proceed if the tracks are clear
- C. Only stop if warning lights are flashing
- D. Honk the horn and proceed across quickly
Hint: Buses carrying passengers must follow stricter rules at railroad crossings than regular vehicles.
Explanation: Buses carrying passengers must stop at railroad crossings no closer than 15 feet and no farther than 50 feet from the nearest rail. The driver must look and listen for trains before crossing.
When driving a large commercial vehicle down a long, steep downgrade, you should:
- A. Place the vehicle in neutral to reduce wear on the engine
- B. Ride the brakes continuously to maintain a safe speed
- C. Use a low gear and apply brakes intermittently with firm pressure
- D. Accelerate slightly to maintain momentum
Hint: Going down a long grade in a heavy vehicle requires a specific technique to prevent brake failure from overheating.
Explanation: On long downgrades, use a low gear to let the engine help slow the vehicle and apply brakes with firm, intermittent pressure. Riding the brakes continuously causes them to overheat and fade, potentially resulting in total brake failure.
Our Arkansas General Knowledge pool has 109 questions, 39 of them framed around Arkansas. Several cover penalties: the disqualification for a first DWI in a CMV, a second DWI, a DWI while hauling hazmat, and what happens if you drive while your CDL is out of service. Others ask about skids, including the most common cause and what to do when a trailer starts to skid, and about jackknifes, air brake lag, snub braking on grades, and what to do first after a crash.
The pool splits into two cards: safe driving and cargo with 68 questions, and rules and licensing with 41. CDL classes is the largest subtopic, followed by coupling, hours of service, general rules and securement.
A few questions in our Arkansas set describe rules differently from current DFA and ASP pages, such as how long a CLP lasts and who gives skills tests. For those, trust the agencies: DFA says a CLP is valid up to 1 year, and ASP gives skills tests at its own troop sites.
Key Topics
- Arkansas DWI and out-of-service penalties
- Skids, jackknifes and air brake lag
- CDL classes, permits and endorsements
- Cargo securement and weight
- Emergencies, crashes and vehicle fires
- Hours of service and speed management