Skip to content

West Virginia CDL study: Safe driving, vehicle control and cargo

Two decks cover this topic: safe driving and cargo with 77 questions, and rules and licensing with 40. Each has 10 free questions with explanations. The mountain and coal items sit in the first deck, so start there if you drive in the hills. Then try run 1.

1/10·0 done

Question Map

Correct Wrong Unseen

10 of 77 questions are free. The rest are in Pro.

Before descending a steep mountain grade on I-77 or I-64 in West Virginia, what should a CDL driver do?

Free Safe driving, vehicle control and cargo questions for the West Virginia CDL test

Plain-text version of this question set

  1. Before descending a steep mountain grade on I-77 or I-64 in West Virginia, what should a CDL driver do?

    • A. Shift into the highest gear possible
    • B. Test the brakes while speed is still low
    • C. Turn off the engine brake to save fuel
    • D. Increase speed to build momentum

    Hint: The preparation steps should happen while you still have full control and low speed, not after you are already descending.

    Explanation: Before descending a steep grade on West Virginia's interstate corridors like I-77 or I-64, test your brakes while your speed is still low. Shift to a low gear and use proper braking technique.

  2. In what order should you connect air lines when coupling a trailer?

    • A. Emergency line first, then service line
    • B. Both lines simultaneously
    • C. Only the service line is needed
    • D. Service line first, then emergency line

    Hint: Charge the line that feeds the trailer before the one that only works when you press the pedal.

    Explanation: The CDL manual's coupling sequence connects the tractor emergency air-line to the trailer emergency glad hand first, then the service air-line to the service glad hand.

  3. What should you do if your low air pressure warning comes on while driving?

    • A. Continue driving but avoid using the brakes until pressure rebuilds
    • B. Increase engine speed to help the compressor build pressure faster
    • C. Stop and safely park as soon as possible
    • D. Turn off the air dryer and switch to manual mode

    Hint: A low air pressure warning while driving requires immediate action to prevent complete brake failure.

    Explanation: If the low air pressure warning activates, you should stop and safely park as soon as possible. Continued driving risks losing braking ability entirely if pressure drops further, which would engage the spring brakes uncontrollably.

  4. The longer the combination vehicle, the more the trailer will off-track. What should a driver do when making a right turn with a long trailer?

    • A. Speed up through the turn to reduce off-tracking
    • B. Turn the steering wheel quickly to complete the turn faster
    • C. Turn from the far right lane to minimize the turning arc
    • D. Swing wide to the left before turning right

    Hint: Longer vehicles have more severe off-tracking, requiring a specific turning technique.

    Explanation: With longer combination vehicles, drivers should swing wide or use a jug handle turn, moving slightly to the left before turning right to give the trailer wheels room to clear the curb and any objects on the inside of the turn.

  5. Which of the following is an out-of-service condition that would prevent you from driving the vehicle?

    • A. A small crack in the windshield on the passenger side
    • B. Brake drums cracked through the wall
    • C. One burned-out clearance marker light
    • D. A missing mud flap on the rear axle

    Hint: Certain defects are so severe that the vehicle cannot legally be driven until they are repaired.

    Explanation: Cracked brake drums that have cracks extending through the drum wall are a critical out-of-service violation. The vehicle cannot be driven until the brake drums are replaced.

  6. What is the maximum weight allowed on a single axle under federal bridge law?

    • A. 20,000 lbs
    • B. 15,000 lbs
    • C. 34,000 lbs
    • D. 25,000 lbs

    Hint: Federal bridge law sets specific weight limits for individual axles to protect road infrastructure.

    Explanation: Federal bridge law limits a single axle to 20,000 lbs and a tandem axle to 34,000 lbs. The total gross vehicle weight is limited to 80,000 lbs on interstate highways.

  7. When transporting hazardous materials, placards must be placed on which sides of the vehicle?

    • A. Front and back only
    • B. Only on the side facing oncoming traffic
    • C. All four sides: front, rear, and both sides
    • D. Only on the rear of the vehicle

    Hint: Placards must be visible from all directions to warn emergency responders approaching from any angle.

    Explanation: Hazmat placards must be displayed on all four sides of the vehicle, front, rear, and both sides, so that they are visible from any direction. Each placard must be at least 10 3/4 inches square.

  8. At a railroad crossing, a bus carrying passengers must:

    • A. Stop between 15 and 50 feet from the nearest rail
    • B. Slow down to 10 mph and proceed if the tracks are clear
    • C. Only stop if warning lights are flashing
    • D. Honk the horn and proceed across quickly

    Hint: Buses carrying passengers must follow stricter rules at railroad crossings than regular vehicles.

    Explanation: Buses carrying passengers must stop at railroad crossings no closer than 15 feet and no farther than 50 feet from the nearest rail. The driver must look and listen for trains before crossing.

  9. When driving a large commercial vehicle down a long, steep downgrade, you should:

    • A. Place the vehicle in neutral to reduce wear on the engine
    • B. Ride the brakes continuously to maintain a safe speed
    • C. Use a low gear and apply brakes intermittently with firm pressure
    • D. Accelerate slightly to maintain momentum

    Hint: Going down a long grade in a heavy vehicle requires a specific technique to prevent brake failure from overheating.

    Explanation: On long downgrades, use a low gear to let the engine help slow the vehicle and apply brakes with firm, intermittent pressure. Riding the brakes continuously causes them to overheat and fade, potentially resulting in total brake failure.

  10. When stopping at a railroad crossing in a CMV that is required to stop, the driver must stop between what distances from the nearest rail?

    • A. 5 to 25 feet
    • B. 10 to 30 feet
    • C. 15 to 50 feet
    • D. 25 to 75 feet

    Hint: The stopping distance at railroad crossings has specific minimum and maximum limits.

    Explanation: Commercial vehicles required to stop at railroad crossings must stop no closer than 15 feet and no farther than 50 feet from the nearest rail. The driver must then look and listen for approaching trains before proceeding.

Of the 117 questions in this pool, 47 were written for West Virginia, the most state material of any section. Mountain driving dominates. You will be asked about crosswinds on the New River Gorge Bridge, what to do on narrow two-lane mountain roads, how to react to a tire blowout on one, when to pull off in mountain fog, and how to brake and choose a gear on long Appalachian downgrades.

Coal shows up twice: keeping a loose coal load from shifting, and the extra care a heavy coal load needs going downhill. Other state items cover the disqualification for leaving the scene of a crash in a CMV, the penalty for two serious violations within three years, which vehicles must stop at every railroad crossing, and the endorsement for tankers.

Securement has the most questions of any subtopic here, followed by disqualification. Do not treat the figures inside these questions as West Virginia law; many restate federal rules.

Key Topics

  • New River Gorge crosswinds and mountain roads
  • Coal loads and long downgrades
  • Disqualifications, including leaving the scene
  • Cargo securement
  • Hours of service and warning devices