Washington CDL study: Pre-Trip Inspection questions
This deck has all 51 pre-trip questions, with 10 free and explained. Most are walk-around items, so study by area: engine, cab, lights, tires, brakes, coupling. Then check recall with pre-trip run 1.
Free Pre-Trip Inspection questions questions for the Washington CDL test
Plain-text version of this question set
During a pre-trip inspection, what is the maximum allowable steering wheel free play (lash) for a commercial vehicle with power steering?
- A. 4 inches at the wheel rim
- B. 30 degrees of wheel movement
- C. About 10 degrees of movement
- D. No free play at all is acceptable
Hint: Excessive steering wheel play indicates worn steering components that could fail during driving.
Explanation: The maximum allowable steering wheel lash for power steering vehicles is approximately 10 degrees or about 2 inches of movement on a 20-inch steering wheel before the front wheels begin to turn.
During a pre-trip inspection of a combination vehicle, how do you test the trailer service brakes using the hand valve (trolley valve)?
- A. Pull the valve out at about 5 mph and check for braking response
- B. Push the valve in with the truck moving slowly and check for braking action
- C. The hand valve should never be used while moving
- D. Apply the hand valve only at highway speed
Hint: The hand valve (trolley valve) controls only the trailer brakes and is used specifically for this test.
Explanation: To test the trailer service brakes, drive the vehicle forward slowly (about 5 mph) and pull out the hand valve (trolley valve). You should feel the trailer brakes apply. The hand valve applies only trailer brakes.
During an air brake check on a dual air system, the air pressure should build from 85 to 100 psi within how long?
- A. 60 seconds
- B. 30 seconds
- C. 90 seconds
- D. 45 seconds
Hint: During an air brake check, there is a specific time limit for the air pressure to build from 85 to 100 psi.
Explanation: Air pressure in a dual air system should build from 85 to 100 psi within 45 seconds. If it takes longer, the air compressor or the system may have a problem.
When inspecting mirrors and windshield during the in-cab check, what is the standard requirement?
- A. Mirrors must be tinted to reduce sun glare
- B. Only the driver-side mirror must be checked
- C. Windshields may have any size crack as long as it is not in the driver's line of sight
- D. Mirrors and glass must be clean, adjusted, and undamaged
Hint: If you cannot see clearly out of it, it is a defect.
Explanation: All mirrors and glass surfaces must be clean and properly adjusted, with no damage or obstructions that impair the driver's view.
What is the minimum legal tread depth for STEERING (front) axle tires on a commercial motor vehicle?
- A. 4/32 inch
- B. 2/32 inch
- C. 6/32 inch
- D. 8/32 inch
Hint: Steering tires need DOUBLE the tread of other tires because they handle directional control.
Explanation: Steering-axle tires must have at least 4/32 inch of tread in every major groove.
While checking the wheels and rims, which of the following indicates a defect?
- A. Cracked rims, missing or loose lug nuts, or rust trails
- B. Lug nuts that are clean and tightened to the specified torque
- C. A rim with a uniform painted finish
- D. Wheel hubs that show no signs of oil leakage
Hint: Rust streaks from lug nuts are a classic warning sign on the skills test.
Explanation: Rim cracks, missing or loose lug nuts, and rust streaks radiating from lug nuts (which indicate the nut is loose and moving) are all defects requiring immediate attention.
During a static air-leak test on a COMBINATION vehicle (tractor + trailer), the maximum allowable air-pressure loss with brakes released is:
- A. 2 psi per minute
- B. 4 psi per minute
- C. 3 psi per minute
- D. 6 psi per minute
Hint: Combinations have more hoses, so they are allowed slightly more leakage.
Explanation: A combination vehicle has more air lines and fittings, so the federal limit is 3 psi per minute (brakes released). Brakes applied raises it to 4 psi per minute.
What component on a tractor-trailer fifth-wheel coupling locks around the kingpin?
- A. The locking jaws
- B. The release handle for the lock
- C. The trailer skid plate
- D. The frame mounting bracket
Hint: Their name describes what they do.
Explanation: The locking jaws inside the fifth wheel close around the kingpin to secure the trailer. After coupling, you must visually confirm the jaws are fully closed around the kingpin.
Which color is the GLAD HAND coupler for the trailer SERVICE air line, and which color is the EMERGENCY (supply) line?
- A. Service = red, Emergency = blue
- B. Service = blue, Emergency = red
- C. Service = green, Emergency = yellow
- D. Service = yellow, Emergency = green
Hint: Emergency is the color of an emergency light.
Explanation: By convention, the service line is BLUE and the emergency (supply) line is RED. Crossing them prevents the trailer brakes from working correctly.
What is a Driver Vehicle Inspection Report (DVIR), and when must one be prepared?
- A. A weekly summary of mileage and fuel use, prepared every Friday for the office
- B. A document filed only when an accident occurs
- C. A written report of vehicle condition and defects, done at each day's end
- D. A fuel-purchase log; prepared at each fuel stop
Hint: It is a daily written record of the vehicle's condition.
Explanation: At the end of each driving day, you must write a DVIR for each vehicle you drove. It must list any defects that affect safe driving, or say that none were found.
There are 51 questions in this pool. 47 deal with the walk-around itself, plus one each on brakes, steering, air brakes and general inspection. Three were written for Washington: what to look for on brake drums (cracks, grease, warping), how much steering wheel free play is acceptable with power steering, and how to test trailer service brakes with the hand valve at low speed. Learn the limits from the guide, not just from our questions.
Scores carry over for a while. Passed parts stay valid 180 days from the first component you pass, so a later fail on the road test does not wipe out a good pre-trip. Changing examiners after a first attempt, though, may mean paying again and redoing all three parts. After a full pass, DOL waits 24 hours before issuing the CDL.
Key Topics
- Washington drum, steering and hand valve checks
- Supplemental CDL Guide for skills
- Engine compartment and fluid leaks
- Tires, wheels and suspension
- In-cab air brake checks