Skip to content

South Dakota CDL study: Doubles/Triples questions

All 45 South Dakota doubles and triples questions sit in this deck, and 10 are free. Work through coupling first, since it is nearly a third of the pool. The real test is 20 questions. When the sequence is solid, take doubles and triples run 1.

1/10·0 done

Question Map

Correct Wrong Unseen

10 of 45 questions are free. The rest are in Pro.

A converter dolly used in doubles and triples is:

Free Doubles/Triples questions questions for the South Dakota CDL test

Plain-text version of this question set

  1. A converter dolly used in doubles and triples is:

    • A. A piece of cargo-handling equipment carried under the trailer
    • B. A coupling device that converts a semitrailer to a full trailer
    • C. A storage container for spare tires
    • D. A type of brake controller

    Hint: It converts a semi into a full trailer.

    Explanation: A converter dolly is a coupling device of one or two axles and a fifth wheel by which a semitrailer can be coupled to the rear of a tractor-trailer combination, forming a double or triple bottom rig.

  2. When uncoupling a set of doubles, the FIRST step is usually to:

    • A. Disconnect the air lines
    • B. Pull the dolly away from the rear trailer
    • C. Park safely and apply the parking brakes
    • D. Lower the landing gear

    Hint: Stop motion first - then disassemble.

    Explanation: Before uncoupling, park the rig in a straight line on firm, level ground. Apply the parking brakes so the rig won't move.

  3. When making lane changes with doubles or triples, the driver should:

    • A. Make quick, sharp lane changes in order to clear the traffic
    • B. Use only the right lane
    • C. Make slow, gradual lane changes
    • D. Honk before each lane change

    Hint: Sudden inputs amplify down the train.

    Explanation: Steer gently and smoothly when pulling trailers. If you make a quick lane change, the crack-the-whip effect can turn the last trailer over.

  4. The 'B-train' configuration uses:

    • A. Two dollies in series
    • B. A second fifth wheel on the lead trailer, no dolly
    • C. A single trailer
    • D. A flatbed trailer fitted with multiple cargo decks

    Hint: Built-in fifth wheel - no dolly.

    Explanation: A B-train has the second fifth wheel mounted on the frame of the lead trailer; the second trailer couples to it directly with its kingpin. No dolly is required between trailers.

  5. When making turns with a double or triple, the driver should:

    • A. Make sharper turns because the trailers will follow
    • B. Swing wide to allow for rear-trailer off-tracking
    • C. Cross the centerline to give more room
    • D. Always make a U-turn instead

    Hint: Rear trailers cut tighter than the tractor.

    Explanation: Doubles and triples have more off-tracking than single trailers, meaning the rear trailer follows a tighter path than the tractor. The driver must swing wider and watch the rear trailer to avoid hitting curbs, signs, or other vehicles.

  6. The supply (red) air line on a tractor-trailer combination:

    • A. Sends only electrical signals, and no air at all
    • B. Supplies the trailer tanks and emergency brakes
    • C. Carries diesel fuel back to the trailer tanks
    • D. Is optional on trailers under 40 feet long

    Hint: Red = emergency supply.

    Explanation: The supply line (red), or emergency line, supplies air to the trailer's air tanks and controls the emergency brakes. The service line (blue) carries air controlled by the foot brake or the trailer hand brake.

  7. If a converter dolly's air tank gauge shows low pressure, you should:

    • A. Drive at low speed to the next stop
    • B. Disconnect the air supply line
    • C. Ignore it - dolly air pressure is not important
    • D. Locate the cause before driving

    Hint: Low air = unsafe to drive.

    Explanation: If air pressure on a dolly's tank is low, find and fix the cause before driving. Low air pressure may indicate a leak that would prevent the dolly's brakes from working properly.

  8. When coupling a tractor to the lead trailer of a double, the fifth-wheel jaws should:

    • A. Close around the head of the kingpin but not the shank
    • B. Remain open until movement begins
    • C. Close around the shank of the kingpin
    • D. Lock only after the trailer is raised

    Hint: Around the shank, not just the head.

    Explanation: Check the fifth-wheel jaws have closed around the shank of the kingpin (not just the head). Use a flashlight if needed to look under the trailer.

  9. When pulling a double or triple, you notice the second trailer is swaying significantly. You should:

    • A. Accelerate to straighten it out
    • B. Slow gradually with the foot brake
    • C. Use the trailer hand valve to slow the rear
    • D. Apply the parking brake

    Hint: Smooth deceleration calms sway.

    Explanation: If a trailer begins to sway, do not use the trailer hand valve. Slow gradually with the foot brake and avoid sudden steering inputs to dampen the sway.

  10. When inspecting a double or triple, the dolly tow bar eye should be:

    • A. Cracked or worn, since that keeps them flexible
    • B. Rusted to indicate age
    • C. Free of cracks, with the pintle hook latched
    • D. Painted any color

    Hint: Cracks or unlatched hooks lead to breakaways.

    Explanation: Inspect the tow bar eye for cracks or other damage, and make sure the pintle hook is latched and the safety latch is closed. A failed pintle hook or damaged tow bar eye can cause the rear trailer to break loose.

Coupling leads this 45-question pool with 13 questions, so learn the full sequence for the second and third trailer: secure the dolly, back it under, lock the pintle hook, connect air and electrical, then test. Converter dollies follow with 4 and pintle hooks with 3. Rearward amplification, uncoupling, configurations and air lines each have 2.

Rearward amplification is the risk that grows with every trailer. A quick steering move at the tractor gets bigger at each unit, so the last trailer of a triple can swing or roll while the cab feels steady. Add the crosswinds on open plains and you have the reason the manual calls for steady steering and wide following distances.

The federal table entry also notes trailers of up to 28.5 feet each in South Dakota triples. Your T endorsement is the license part; the route and permit belong to the carrier.

Key Topics

  • Where triples run in South Dakota
  • Coupling the second and third trailer
  • Converter dollies and pintle hooks
  • Rearward amplification in crosswinds
  • Brake checks on long combinations