South Carolina CDL study: Pre-Trip Inspection questions
All 51 South Carolina pre-trip questions sit in one deck, and 10 are free. Read them in the order you would walk the truck, saying each check out loud as you will for the examiner. Then move to pre-trip run 1.
Free Pre-Trip Inspection questions questions for the South Carolina CDL test
Plain-text version of this question set
During an air brake check, the low air pressure warning should activate before the air pressure drops below what level?
- A. 40 psi
- B. 60 psi
- C. 50 psi
- D. 80 psi
Hint: The warning must activate well above the pressure at which spring brakes engage to give the driver time to respond.
Explanation: The low air pressure warning (buzzer or light) must come on before air pressure drops below 60 psi. This warns the driver that the air brake system is losing pressure.
What must a CDL driver do if the previous driver's vehicle inspection report notes a defect?
- A. Ignore it if the vehicle starts normally
- B. Sign the report and drive
- C. Verify the defect was repaired
- D. Call SCDMV for instructions
Hint: The current driver has a responsibility to verify the vehicle's condition before accepting it, regardless of what the previous driver reported.
Explanation: If the previous driver's report lists a defect, the current driver must verify that the defect has been repaired or certified by a mechanic as not needing repair before operating the vehicle.
During an air brake check on a dual air system, the air pressure should build from 85 to 100 psi within how long?
- A. 60 seconds
- B. 30 seconds
- C. 90 seconds
- D. 45 seconds
Hint: During an air brake check, there is a specific time limit for the air pressure to build from 85 to 100 psi.
Explanation: Air pressure in a dual air system should build from 85 to 100 psi within 45 seconds. If it takes longer, the air compressor or the system may have a problem.
Which step of the FMCSA seven-step inspection is the parking brake and service brake test?
- A. Step 2 - Engine compartment
- B. Step 7 - Start the engine and check the brake system
- C. Step 3 - Start engine and inspect inside the cab
- D. Step 5 - Walk-around inspection
Hint: It is the last step, where you confirm the vehicle can stop and steer safely before pulling out.
Explanation: Step 7 is the final brake-system check. With the wheels chocked, you test the parking brake by tugging gently against it in gear, then test the service brake for stopping action and for pull. Steering wheel free play is checked earlier, in step 3, inside the cab.
Per FMCSA, how often must a CDL driver inspect their commercial vehicle?
- A. Once per week
- B. Before every trip and after every trip
- C. Only at the start of each day
- D. Only when the vehicle has been flagged for a defect
Hint: Inspection is not a one-time event; safety checks bracket every shift and continue while driving.
Explanation: Federal regulations require a pre-trip inspection before driving, en-route monitoring, and a post-trip inspection with a written DVIR at the end of each day.
When inspecting mirrors and windshield during the in-cab check, what is the standard requirement?
- A. Mirrors must be tinted to reduce sun glare
- B. Only the driver-side mirror must be checked
- C. Windshields may have any size crack as long as it is not in the driver's line of sight
- D. Mirrors and glass must be clean, adjusted, and undamaged
Hint: If you cannot see clearly out of it, it is a defect.
Explanation: All mirrors and glass surfaces must be clean and properly adjusted, with no damage or obstructions that impair the driver's view.
What is the minimum legal tread depth for STEERING (front) axle tires on a commercial motor vehicle?
- A. 4/32 inch
- B. 2/32 inch
- C. 6/32 inch
- D. 8/32 inch
Hint: Steering tires need DOUBLE the tread of other tires because they handle directional control.
Explanation: Steering-axle tires must have at least 4/32 inch of tread in every major groove.
While checking the wheels and rims, which of the following indicates a defect?
- A. Cracked rims, missing or loose lug nuts, or rust trails
- B. Lug nuts that are clean and tightened to the specified torque
- C. A rim with a uniform painted finish
- D. Wheel hubs that show no signs of oil leakage
Hint: Rust streaks from lug nuts are a classic warning sign on the skills test.
Explanation: Rim cracks, missing or loose lug nuts, and rust streaks radiating from lug nuts (which indicate the nut is loose and moving) are all defects requiring immediate attention.
During a static air-leak test on a COMBINATION vehicle (tractor + trailer), the maximum allowable air-pressure loss with brakes released is:
- A. 2 psi per minute
- B. 4 psi per minute
- C. 3 psi per minute
- D. 6 psi per minute
Hint: Combinations have more hoses, so they are allowed slightly more leakage.
Explanation: A combination vehicle has more air lines and fittings, so the federal limit is 3 psi per minute (brakes released). Brakes applied raises it to 4 psi per minute.
Which color is the GLAD HAND coupler for the trailer SERVICE air line, and which color is the EMERGENCY (supply) line?
- A. Service = red, Emergency = blue
- B. Service = blue, Emergency = red
- C. Service = green, Emergency = yellow
- D. Service = yellow, Emergency = green
Hint: Emergency is the color of an emergency light.
Explanation: By convention, the service line is BLUE and the emergency (supply) line is RED. Crossing them prevents the trailer brakes from working correctly.
Nearly all of this pool's 51 questions cover the inspection itself: engine compartment, cab, lights, brakes and the walk-around. Four are South Carolina questions, on when the low air warning must come on, what to check under the hood, minimum tread on front tires, and what to do when the last driver's inspection report lists a defect (confirm it was repaired).
Failing a portion has a price and a wait. Each retest is $25, and you wait two business days after a first failure, seven calendar days after a second and 30 calendar days after a third or later. Passed portions can be banked while your CLP is valid, but only if all three parts are done with the same agency or company, so pick your tester with that in mind. SCDMV publishes the $25 figure for retests; ask your branch or third-party tester what the first test costs when you book. Interpreters are not allowed during third-party skills tests.
Key Topics
- South Carolina skills test booking and retest waits
- Engine compartment checks
- Low air warning and brake checks
- Tires, wheels and suspension
- Reviewing the previous inspection report