Skip to content

Oklahoma CDL study: Pre-Trip Inspection questions

This deck holds all 50 Oklahoma pre-trip questions, four written for Oklahoma, with 10 free. Read the cards in walk around order, engine to cab to rear, and say each check aloud. Then take pre-trip run 1. Missing a step? Repeat the deck.

1/10·0 done

Question Map

Correct Wrong Unseen

10 of 50 questions are free. The rest are in Pro.

During a CDL pre-trip inspection, what is the first thing you should check?

Free Pre-Trip Inspection questions questions for the Oklahoma CDL test

Plain-text version of this question set

  1. During a CDL pre-trip inspection, what is the first thing you should check?

    • A. Tire pressure on all axles
    • B. Fuel level
    • C. The last vehicle inspection report
    • D. Windshield wipers and washer fluid

    Hint: Before you look at the vehicle itself, check the paperwork from the previous driver.

    Explanation: The first step in a pre-trip inspection is to review the last vehicle inspection report to check for any issues that may not have been repaired.

  2. What is the minimum tread depth for front tires on a commercial vehicle in Oklahoma?

    • A. 4/32 of an inch
    • B. 2/32 of an inch
    • C. 6/32 of an inch
    • D. 8/32 of an inch

    Hint: Front tires have a deeper minimum than other tires because they handle steering.

    Explanation: Front tires on a commercial vehicle must have a minimum tread depth of 4/32 of an inch. Other tires must have at least 2/32 of an inch.

  3. During an air brake check on a dual air system, the air pressure should build from 85 to 100 psi within how long?

    • A. 60 seconds
    • B. 30 seconds
    • C. 90 seconds
    • D. 45 seconds

    Hint: During an air brake check, there is a specific time limit for the air pressure to build from 85 to 100 psi.

    Explanation: Air pressure in a dual air system should build from 85 to 100 psi within 45 seconds. If it takes longer, the air compressor or the system may have a problem.

  4. Per FMCSA, how often must a CDL driver inspect their commercial vehicle?

    • A. Once per week
    • B. Before every trip and after every trip
    • C. Only at the start of each day
    • D. Only when the vehicle has been flagged for a defect

    Hint: Inspection is not a one-time event; safety checks bracket every shift and continue while driving.

    Explanation: Federal regulations require a pre-trip inspection before driving, en-route monitoring, and a post-trip inspection with a written DVIR at the end of each day.

  5. When inspecting mirrors and windshield during the in-cab check, what is the standard requirement?

    • A. Mirrors must be tinted to reduce sun glare
    • B. Only the driver-side mirror must be checked
    • C. Windshields may have any size crack as long as it is not in the driver's line of sight
    • D. Mirrors and glass must be clean, adjusted, and undamaged

    Hint: If you cannot see clearly out of it, it is a defect.

    Explanation: All mirrors and glass surfaces must be clean and properly adjusted, with no damage or obstructions that impair the driver's view.

  6. While checking the wheels and rims, which of the following indicates a defect?

    • A. Cracked rims, missing or loose lug nuts, or rust trails
    • B. Lug nuts that are clean and tightened to the specified torque
    • C. A rim with a uniform painted finish
    • D. Wheel hubs that show no signs of oil leakage

    Hint: Rust streaks from lug nuts are a classic warning sign on the skills test.

    Explanation: Rim cracks, missing or loose lug nuts, and rust streaks radiating from lug nuts (which indicate the nut is loose and moving) are all defects requiring immediate attention.

  7. During a static air-leak test on a COMBINATION vehicle (tractor + trailer), the maximum allowable air-pressure loss with brakes released is:

    • A. 2 psi per minute
    • B. 4 psi per minute
    • C. 3 psi per minute
    • D. 6 psi per minute

    Hint: Combinations have more hoses, so they are allowed slightly more leakage.

    Explanation: A combination vehicle has more air lines and fittings, so the federal limit is 3 psi per minute (brakes released). Brakes applied raises it to 4 psi per minute.

  8. What component on a tractor-trailer fifth-wheel coupling locks around the kingpin?

    • A. The locking jaws
    • B. The release handle for the lock
    • C. The trailer skid plate
    • D. The frame mounting bracket

    Hint: Their name describes what they do.

    Explanation: The locking jaws inside the fifth wheel close around the kingpin to secure the trailer. After coupling, you must visually confirm the jaws are fully closed around the kingpin.

  9. Which color is the GLAD HAND coupler for the trailer SERVICE air line, and which color is the EMERGENCY (supply) line?

    • A. Service = red, Emergency = blue
    • B. Service = blue, Emergency = red
    • C. Service = green, Emergency = yellow
    • D. Service = yellow, Emergency = green

    Hint: Emergency is the color of an emergency light.

    Explanation: By convention, the service line is BLUE and the emergency (supply) line is RED. Crossing them prevents the trailer brakes from working correctly.

  10. What is required on the rear, sides, and front of most trailers for visibility?

    • A. Decorative paint and chrome trim
    • B. Only a single red reflector mounted in the center of the rear bumper
    • C. Reflective tape or reflectors plus working marker and clearance lights
    • D. Mud flaps only

    Hint: Reflective tape plus required lighting.

    Explanation: Trailers 80 inches or wider must have red-and-white conspicuity tape and marker/clearance/identification lights so they are visible at night and from the sides.

Of the 50 questions here, 45 cover the pre-trip itself: engine compartment, cab checks, lights, brakes, tires, coupling and the walk around. Four are written for Oklahoma. One asks where the inspection starts: with the last vehicle inspection report, to see what was flagged and not fixed. Another asks how front tire tread compares with the other tires, which need less. A third covers brake drums, where you look for cracks, dents and oil, and the fourth asks how many reflective triangles you must carry.

Timing matters. A full drive test usually takes about two hours, every failed test adds $4, and your passed sections and results last only as long as your permit. After you pass all three, the examiner stamps the DL18 certificate from your written test, and you take it to a Licensing Office to get the CDL. Inspect the vehicle you will test in, ahead of time, and say each item out loud as you go.

Key Topics

  • Oklahoma drive test sections and banked credit
  • Last inspection report and walk around
  • Tire tread, brake drums and warning triangles
  • Engine compartment and cab checks
  • Lights and brake inspection