Skip to content

New York CDL study: Safe driving, vehicle control and cargo

The pool comes as two decks: 74 safe driving and cargo cards and 43 rules and licensing cards, 10 free each. Read the New York questions on city routes and DWAI rules early, since a national guide skips them, then try General Knowledge run 1.

1/10·0 done

Question Map

Correct Wrong Unseen

10 of 74 questions are free. The rest are in Pro.

When coupling a tractor to a semi-trailer, the fifth wheel should be tilted:

Free Safe driving, vehicle control and cargo questions for the New York CDL test

Plain-text version of this question set

  1. When coupling a tractor to a semi-trailer, the fifth wheel should be tilted:

    • A. Up toward the front of the tractor
    • B. Level with the ground
    • C. It does not matter
    • D. Down toward the rear of the tractor

    Hint: The angle of the fifth wheel affects how the trailer kingpin engages during the coupling process.

    Explanation: The fifth wheel should be tilted down toward the rear of the tractor so it can engage the trailer kingpin properly during the coupling process.

  2. During a CDL pre-trip inspection, which of the following should be checked in the engine compartment?

    • A. Tire tread depth only
    • B. Seat belt condition
    • C. Oil, coolant, and belts/hoses
    • D. Dashboard warning lights only

    Hint: The engine compartment inspection covers fluid levels and component condition, not external features.

    Explanation: The engine compartment inspection includes checking oil level, coolant level, power steering fluid, condition of belts and hoses, and looking for leaks.

  3. What should you do if your low air pressure warning comes on while driving?

    • A. Continue driving but avoid using the brakes until pressure rebuilds
    • B. Increase engine speed to help the compressor build pressure faster
    • C. Stop and safely park as soon as possible
    • D. Turn off the air dryer and switch to manual mode

    Hint: A low air pressure warning while driving requires immediate action to prevent complete brake failure.

    Explanation: If the low air pressure warning activates, you should stop and safely park as soon as possible. Continued driving risks losing braking ability entirely if pressure drops further, which would engage the spring brakes uncontrollably.

  4. The longer the combination vehicle, the more the trailer will off-track. What should a driver do when making a right turn with a long trailer?

    • A. Speed up through the turn to reduce off-tracking
    • B. Turn the steering wheel quickly to complete the turn faster
    • C. Turn from the far right lane to minimize the turning arc
    • D. Swing wide to the left before turning right

    Hint: Longer vehicles have more severe off-tracking, requiring a specific turning technique.

    Explanation: With longer combination vehicles, drivers should swing wide or use a jug handle turn, moving slightly to the left before turning right to give the trailer wheels room to clear the curb and any objects on the inside of the turn.

  5. Which of the following is an out-of-service condition that would prevent you from driving the vehicle?

    • A. A small crack in the windshield on the passenger side
    • B. Brake drums cracked through the wall
    • C. One burned-out clearance marker light
    • D. A missing mud flap on the rear axle

    Hint: Certain defects are so severe that the vehicle cannot legally be driven until they are repaired.

    Explanation: Cracked brake drums that have cracks extending through the drum wall are a critical out-of-service violation. The vehicle cannot be driven until the brake drums are replaced.

  6. What is the maximum weight allowed on a single axle under federal bridge law?

    • A. 20,000 lbs
    • B. 15,000 lbs
    • C. 34,000 lbs
    • D. 25,000 lbs

    Hint: Federal bridge law sets specific weight limits for individual axles to protect road infrastructure.

    Explanation: Federal bridge law limits a single axle to 20,000 lbs and a tandem axle to 34,000 lbs. The total gross vehicle weight is limited to 80,000 lbs on interstate highways.

  7. When transporting hazardous materials, placards must be placed on which sides of the vehicle?

    • A. Front and back only
    • B. Only on the side facing oncoming traffic
    • C. All four sides: front, rear, and both sides
    • D. Only on the rear of the vehicle

    Hint: Placards must be visible from all directions to warn emergency responders approaching from any angle.

    Explanation: Hazmat placards must be displayed on all four sides of the vehicle, front, rear, and both sides, so that they are visible from any direction. Each placard must be at least 10 3/4 inches square.

  8. At a railroad crossing, a bus carrying passengers must:

    • A. Stop between 15 and 50 feet from the nearest rail
    • B. Slow down to 10 mph and proceed if the tracks are clear
    • C. Only stop if warning lights are flashing
    • D. Honk the horn and proceed across quickly

    Hint: Buses carrying passengers must follow stricter rules at railroad crossings than regular vehicles.

    Explanation: Buses carrying passengers must stop at railroad crossings no closer than 15 feet and no farther than 50 feet from the nearest rail. The driver must look and listen for trains before crossing.

  9. When driving a large commercial vehicle down a long, steep downgrade, you should:

    • A. Place the vehicle in neutral to reduce wear on the engine
    • B. Ride the brakes continuously to maintain a safe speed
    • C. Use a low gear and apply brakes intermittently with firm pressure
    • D. Accelerate slightly to maintain momentum

    Hint: Going down a long grade in a heavy vehicle requires a specific technique to prevent brake failure from overheating.

    Explanation: On long downgrades, use a low gear to let the engine help slow the vehicle and apply brakes with firm, intermittent pressure. Riding the brakes continuously causes them to overheat and fade, potentially resulting in total brake failure.

  10. When stopping at a railroad crossing in a CMV that is required to stop, the driver must stop between what distances from the nearest rail?

    • A. 5 to 25 feet
    • B. 10 to 30 feet
    • C. 15 to 50 feet
    • D. 25 to 75 feet

    Hint: The stopping distance at railroad crossings has specific minimum and maximum limits.

    Explanation: Commercial vehicles required to stop at railroad crossings must stop no closer than 15 feet and no farther than 50 feet from the nearest rail. The driver must then look and listen for approaching trains before proceeding.

Our New York pool for this test has 117 questions, and 47 of them are New York items. Several deal with driving in and around the city: following designated NYC truck routes, the hazmat loads barred from city tunnels, the overheight, overweight and hazmat limits at the George Washington Bridge, the congestion pricing zone in Manhattan, and the TWIC card for the Port of New York and New Jersey. Others cover the Thruway's commercial rules and NYS DOT oversize permits.

New York's alcohol rules get their own questions too: a DWAI conviction in a commercial vehicle counts the same as a DWI for CDL purposes, and a second offense means lifetime disqualification. Also expect the vehicles that must always stop at railroad crossings in New York.

The study cards split the pool into 74 safe driving and cargo questions and 43 rules and licensing questions, with 10 free in each.

Key Topics

  • NYC truck routes, tunnels and the George Washington Bridge
  • DWI and DWAI disqualifications in New York
  • Thruway rules, oversize permits and port access
  • CDL classes, endorsements and age limits
  • Cargo securement and weight distribution
  • Railroad crossings and emergencies