Skip to content

New Jersey CDL study: Safe driving, vehicle control and cargo

Two decks cover this test: 63 safe driving and cargo cards and 47 rules and licensing cards, 10 free in each. Read the New Jersey road questions first, since they are the ones a federal study guide will not prepare you for, then try General Knowledge run 1.

1/10·0 done

Question Map

Correct Wrong Unseen

10 of 63 questions are free. The rest are in Pro.

When coupling a tractor to a trailer, what should you check after connecting the air lines?

Free Safe driving, vehicle control and cargo questions for the New Jersey CDL test

Plain-text version of this question set

  1. When coupling a tractor to a trailer, what should you check after connecting the air lines?

    • A. The fuel level in both saddle tanks
    • B. The tire pressure on all of the tractor tires
    • C. That the fifth wheel plate is greased
    • D. That the trailer brakes release with no leaks

    Hint: After connecting air lines, you need to verify both that air flows properly and that there are no leaks.

    Explanation: After connecting air lines, you should check that the trailer brakes release when you supply air and that there are no air leaks at the connections.

  2. What is the most common cause of a jackknife in a tractor-trailer combination?

    • A. Cargo loaded beyond the axle limits
    • B. Driving too slowly for conditions
    • C. Braking too hard on slippery surfaces
    • D. Using the engine brake on a downgrade

    Hint: The most common jackknife scenario involves a loss of traction at the drive wheels during hard braking.

    Explanation: The most common cause of a jackknife is braking too hard on slippery surfaces, which causes the drive wheels to lose traction and the trailer to swing around.

  3. What should you do if your low air pressure warning comes on while driving?

    • A. Continue driving but avoid using the brakes until pressure rebuilds
    • B. Increase engine speed to help the compressor build pressure faster
    • C. Stop and safely park as soon as possible
    • D. Turn off the air dryer and switch to manual mode

    Hint: A low air pressure warning while driving requires immediate action to prevent complete brake failure.

    Explanation: If the low air pressure warning activates, you should stop and safely park as soon as possible. Continued driving risks losing braking ability entirely if pressure drops further, which would engage the spring brakes uncontrollably.

  4. The longer the combination vehicle, the more the trailer will off-track. What should a driver do when making a right turn with a long trailer?

    • A. Speed up through the turn to reduce off-tracking
    • B. Turn the steering wheel quickly to complete the turn faster
    • C. Turn from the far right lane to minimize the turning arc
    • D. Swing wide to the left before turning right

    Hint: Longer vehicles have more severe off-tracking, requiring a specific turning technique.

    Explanation: With longer combination vehicles, drivers should swing wide or use a jug handle turn, moving slightly to the left before turning right to give the trailer wheels room to clear the curb and any objects on the inside of the turn.

  5. Which of the following is an out-of-service condition that would prevent you from driving the vehicle?

    • A. A small crack in the windshield on the passenger side
    • B. Brake drums cracked through the wall
    • C. One burned-out clearance marker light
    • D. A missing mud flap on the rear axle

    Hint: Certain defects are so severe that the vehicle cannot legally be driven until they are repaired.

    Explanation: Cracked brake drums that have cracks extending through the drum wall are a critical out-of-service violation. The vehicle cannot be driven until the brake drums are replaced.

  6. What is the maximum weight allowed on a single axle under federal bridge law?

    • A. 20,000 lbs
    • B. 15,000 lbs
    • C. 34,000 lbs
    • D. 25,000 lbs

    Hint: Federal bridge law sets specific weight limits for individual axles to protect road infrastructure.

    Explanation: Federal bridge law limits a single axle to 20,000 lbs and a tandem axle to 34,000 lbs. The total gross vehicle weight is limited to 80,000 lbs on interstate highways.

  7. When transporting hazardous materials, placards must be placed on which sides of the vehicle?

    • A. Front and back only
    • B. Only on the side facing oncoming traffic
    • C. All four sides: front, rear, and both sides
    • D. Only on the rear of the vehicle

    Hint: Placards must be visible from all directions to warn emergency responders approaching from any angle.

    Explanation: Hazmat placards must be displayed on all four sides of the vehicle, front, rear, and both sides, so that they are visible from any direction. Each placard must be at least 10 3/4 inches square.

  8. At a railroad crossing, a bus carrying passengers must:

    • A. Stop between 15 and 50 feet from the nearest rail
    • B. Slow down to 10 mph and proceed if the tracks are clear
    • C. Only stop if warning lights are flashing
    • D. Honk the horn and proceed across quickly

    Hint: Buses carrying passengers must follow stricter rules at railroad crossings than regular vehicles.

    Explanation: Buses carrying passengers must stop at railroad crossings no closer than 15 feet and no farther than 50 feet from the nearest rail. The driver must look and listen for trains before crossing.

  9. When driving a large commercial vehicle down a long, steep downgrade, you should:

    • A. Place the vehicle in neutral to reduce wear on the engine
    • B. Ride the brakes continuously to maintain a safe speed
    • C. Use a low gear and apply brakes intermittently with firm pressure
    • D. Accelerate slightly to maintain momentum

    Hint: Going down a long grade in a heavy vehicle requires a specific technique to prevent brake failure from overheating.

    Explanation: On long downgrades, use a low gear to let the engine help slow the vehicle and apply brakes with firm, intermittent pressure. Riding the brakes continuously causes them to overheat and fade, potentially resulting in total brake failure.

  10. When stopping at a railroad crossing in a CMV that is required to stop, the driver must stop between what distances from the nearest rail?

    • A. 5 to 25 feet
    • B. 10 to 30 feet
    • C. 15 to 50 feet
    • D. 25 to 75 feet

    Hint: The stopping distance at railroad crossings has specific minimum and maximum limits.

    Explanation: Commercial vehicles required to stop at railroad crossings must stop no closer than 15 feet and no farther than 50 feet from the nearest rail. The driver must then look and listen for approaching trains before proceeding.

Of those 110 questions, 40 are written for New Jersey. Expect questions on where trucks belong on the New Jersey Turnpike, where commercial traffic uses the outer truck lanes in the dual-roadway sections, and on the Garden State Parkway, which generally keeps commercial vehicles off. Others cover hazardous materials limits at the Holland and Lincoln Tunnels, checking height, weight and width before the George Washington Bridge, the TWIC card for secure areas at Port Newark, and the NJ DOT permit for oversize loads.

A second group tests licensing rules: which agency issues CDLs, what happens to your CDL if your medical certificate lapses, and when a crash must be reported to MVC. Watch the age questions: New Jersey licenses you at 18 for intrastate work, but crossing state lines takes 21. The study cards split the pool into 63 safe driving and cargo questions and 47 rules and licensing questions, with 10 free in each.

Key Topics

  • Turnpike truck lanes and Garden State Parkway limits
  • Holland and Lincoln Tunnel and Port Newark rules
  • CDL classes, endorsements and age limits
  • Cargo securement and weight distribution
  • Alcohol rules and disqualifications
  • Hours of service and emergencies