Skip to content

New Hampshire CDL study: Safe driving, vehicle control and cargo

New Hampshire's 117 General Knowledge questions are split into two decks: 79 on safe driving and cargo, 38 on rules and licensing. Each deck shows 10 free with explanations. Finish one, then test it on General Knowledge run 1.

1/10·0 done

Question Map

Correct Wrong Unseen

10 of 79 questions are free. The rest are in Pro.

What wildlife hazard is most significant for CDL drivers in New Hampshire, particularly at dawn and dusk?

Free Safe driving, vehicle control and cargo questions for the New Hampshire CDL test

Plain-text version of this question set

  1. What wildlife hazard is most significant for CDL drivers in New Hampshire, particularly at dawn and dusk?

    • A. Bears crossing highways
    • B. Flocks of wild turkeys
    • C. Deer only during hunting season
    • D. Moose

    Hint: This animal is the largest land mammal in New Hampshire and stands so tall that headlights may not illuminate it effectively.

    Explanation: Moose are the most significant wildlife hazard in New Hampshire. An adult moose can weigh over 1,000 pounds and stands tall enough that headlights may not reflect off their eyes. Collisions are often fatal and most common at dawn and dusk.

  2. What emergency equipment must be carried on a commercial vehicle?

    • A. A cell phone and flashlight
    • B. Only a fire extinguisher
    • C. Extinguisher, warning devices, fuses
    • D. A first aid kit and jumper cables

    Hint: Federal regulations specify three categories of emergency equipment that must be on board.

    Explanation: Commercial vehicles must carry a properly charged fire extinguisher, three warning devices (reflective triangles or flares/fusees), and spare fuses (if the vehicle uses fuses). These are checked during pre-trip inspection.

  3. Air brakes have a delay before they begin working after you press the brake pedal. What causes this delay?

    • A. The hydraulic fluid must warm up before flowing
    • B. The brake controller must process the electronic signal
    • C. Air takes time to reach the brake chambers
    • D. The engine must disengage before brakes can be applied

    Hint: Unlike hydraulic brakes that respond instantly, air brakes have a physical delay caused by air travel time.

    Explanation: Air brakes have a brake lag of about half a second because it takes time for the air to travel through the lines to the brakes. This adds to the total stopping distance compared to hydraulic brakes.

  4. The longer the combination vehicle, the more the trailer will off-track. What should a driver do when making a right turn with a long trailer?

    • A. Speed up through the turn to reduce off-tracking
    • B. Turn the steering wheel quickly to complete the turn faster
    • C. Turn from the far right lane to minimize the turning arc
    • D. Swing wide to the left before turning right

    Hint: Longer vehicles have more severe off-tracking, requiring a specific turning technique.

    Explanation: With longer combination vehicles, drivers should swing wide or use a jug handle turn, moving slightly to the left before turning right to give the trailer wheels room to clear the curb and any objects on the inside of the turn.

  5. When inspecting tires during a pre-trip inspection, which condition would require the tire to be replaced before driving?

    • A. A minor scuff mark on the sidewall
    • B. Tread depth of less than 2/32 of an inch on a steer tire
    • C. A tread depth of 5/32 of an inch on a drive tire
    • D. Slightly uneven tread wear across the tire

    Hint: Steer tires have stricter tread depth requirements than drive or trailer tires because they control the vehicle's direction.

    Explanation: Front (steer) tires must have at least 4/32 of an inch tread depth and all other tires at least 2/32. A steer tire with less than 2/32 tread depth is well below the legal minimum and must be replaced immediately.

  6. What is the maximum weight allowed on a single axle under federal bridge law?

    • A. 20,000 lbs
    • B. 15,000 lbs
    • C. 34,000 lbs
    • D. 25,000 lbs

    Hint: Federal bridge law sets specific weight limits for individual axles to protect road infrastructure.

    Explanation: Federal bridge law limits a single axle to 20,000 lbs and a tandem axle to 34,000 lbs. The total gross vehicle weight is limited to 80,000 lbs on interstate highways.

  7. When transporting hazardous materials, placards must be placed on which sides of the vehicle?

    • A. Front and back only
    • B. Only on the side facing oncoming traffic
    • C. All four sides: front, rear, and both sides
    • D. Only on the rear of the vehicle

    Hint: Placards must be visible from all directions to warn emergency responders approaching from any angle.

    Explanation: Hazmat placards must be displayed on all four sides of the vehicle, front, rear, and both sides, so that they are visible from any direction. Each placard must be at least 10 3/4 inches square.

  8. Where must hazardous materials shipping papers be kept while driving?

    • A. In the glove compartment
    • B. In the trailer with the cargo
    • C. In a pouch on the driver's door
    • D. In a locked box mounted behind the cab

    Hint: Shipping papers for hazmat must be immediately accessible to the driver and to emergency responders.

    Explanation: Shipping papers for hazardous materials must be kept in a pouch on the driver's door or in clear view and within the driver's reach while the seat belt is fastened. This allows quick access in an emergency.

  9. When should a bus driver evacuate passengers?

    • A. When there is a fire or the bus cannot be safely moved
    • B. Whenever the bus breaks down
    • C. Only when instructed by emergency services
    • D. Only when the destination has been reached and the door cannot open

    Hint: Bus evacuation is a last resort that should only be initiated when remaining on the bus is more dangerous.

    Explanation: Passengers should be evacuated if there is a fire or danger of fire, or if the bus is in a position that makes staying inside dangerous and the bus cannot be safely moved.

  10. When driving a large commercial vehicle down a long, steep downgrade, you should:

    • A. Place the vehicle in neutral to reduce wear on the engine
    • B. Ride the brakes continuously to maintain a safe speed
    • C. Use a low gear and apply brakes intermittently with firm pressure
    • D. Accelerate slightly to maintain momentum

    Hint: Going down a long grade in a heavy vehicle requires a specific technique to prevent brake failure from overheating.

    Explanation: On long downgrades, use a low gear to let the engine help slow the vehicle and apply brakes with firm, intermittent pressure. Riding the brakes continuously causes them to overheat and fade, potentially resulting in total brake failure.

Of the 117 questions here, 47 are written for New Hampshire. Many deal with old roads and infrastructure. Covered bridges get a question on posted weight and height limits that keep big trucks off them, and another asks why you must know your total height before you set out. Narrow New England back roads need lower speed and yielding at tight spots, and a sharp curve after a hill crest means slowing before the curve, not in it.

Winter questions are everywhere: black ice, trailer skids on snow, the alcohol evaporator that keeps brake valves from icing, antifreeze checks, and clearing ice from the frame before you leave. The White Mountains add downgrade technique and gear choice. Others ask about moose at dawn and dusk, logging loads secured with stakes, chocks or cradles, E-ZPass tolls charged by axle, and fuel taxes in a state with no sales tax. The cards split the pool into 79 safe driving and cargo questions and 38 rules and licensing questions, 10 free in each.

Key Topics

  • Covered bridges and narrow New England roads
  • Winter driving, black ice and the alcohol evaporator
  • White Mountains grades and moose
  • Logging loads and cargo securement
  • CDL classes and New Hampshire ages
  • Alcohol limits and disqualifications