Skip to content

Mississippi CDL study: Safe driving, vehicle control and cargo

The 108 Mississippi General Knowledge questions are sorted into two decks, 73 on safe driving and cargo and 35 on rules and licensing. Each deck has 10 free questions with explanations. Work through one, then test yourself on General Knowledge run 1.

1/10·0 done

Question Map

Correct Wrong Unseen

10 of 73 questions are free. The rest are in Pro.

When driving a loaded commercial vehicle downhill, what is the recommended braking technique?

Free Safe driving, vehicle control and cargo questions for the Mississippi CDL test

Plain-text version of this question set

  1. When driving a loaded commercial vehicle downhill, what is the recommended braking technique?

    • A. Brake firmly, release, and repeat
    • B. Ride the brakes continuously all the way down
    • C. Only use the parking brake on downhills
    • D. Shift to neutral and coast downhill

    Hint: Continuous braking on long downhill grades causes a dangerous condition called brake fade.

    Explanation: The stab braking or controlled braking technique involves applying brakes to reduce speed below the safe speed, then releasing them to allow cooling, and repeating. Continuous braking causes brake fade from overheating.

  2. At highway speeds, a CMV driver should maintain a following distance of at least:

    • A. 2 seconds
    • B. 4 seconds
    • C. 10 seconds
    • D. 7 seconds

    Hint: Heavy commercial vehicles require significantly more following distance than passenger cars due to their stopping distance.

    Explanation: At speeds above 40 mph, CMV drivers should maintain a following distance of at least 7 seconds. This accounts for the longer stopping distance required by heavy commercial vehicles.

  3. Air brakes have a delay before they begin working after you press the brake pedal. What causes this delay?

    • A. The hydraulic fluid must warm up before flowing
    • B. The brake controller must process the electronic signal
    • C. Air takes time to reach the brake chambers
    • D. The engine must disengage before brakes can be applied

    Hint: Unlike hydraulic brakes that respond instantly, air brakes have a physical delay caused by air travel time.

    Explanation: Air brakes have a brake lag of about half a second because it takes time for the air to travel through the lines to the brakes. This adds to the total stopping distance compared to hydraulic brakes.

  4. The longer the combination vehicle, the more the trailer will off-track. What should a driver do when making a right turn with a long trailer?

    • A. Speed up through the turn to reduce off-tracking
    • B. Turn the steering wheel quickly to complete the turn faster
    • C. Turn from the far right lane to minimize the turning arc
    • D. Swing wide to the left before turning right

    Hint: Longer vehicles have more severe off-tracking, requiring a specific turning technique.

    Explanation: With longer combination vehicles, drivers should swing wide or use a jug handle turn, moving slightly to the left before turning right to give the trailer wheels room to clear the curb and any objects on the inside of the turn.

  5. When inspecting tires during a pre-trip inspection, which condition would require the tire to be replaced before driving?

    • A. A minor scuff mark on the sidewall
    • B. Tread depth of less than 2/32 of an inch on a steer tire
    • C. A tread depth of 5/32 of an inch on a drive tire
    • D. Slightly uneven tread wear across the tire

    Hint: Steer tires have stricter tread depth requirements than drive or trailer tires because they control the vehicle's direction.

    Explanation: Front (steer) tires must have at least 4/32 of an inch tread depth and all other tires at least 2/32. A steer tire with less than 2/32 tread depth is well below the legal minimum and must be replaced immediately.

  6. What is the maximum weight allowed on a single axle under federal bridge law?

    • A. 20,000 lbs
    • B. 15,000 lbs
    • C. 34,000 lbs
    • D. 25,000 lbs

    Hint: Federal bridge law sets specific weight limits for individual axles to protect road infrastructure.

    Explanation: Federal bridge law limits a single axle to 20,000 lbs and a tandem axle to 34,000 lbs. The total gross vehicle weight is limited to 80,000 lbs on interstate highways.

  7. When transporting hazardous materials, placards must be placed on which sides of the vehicle?

    • A. Front and back only
    • B. Only on the side facing oncoming traffic
    • C. All four sides: front, rear, and both sides
    • D. Only on the rear of the vehicle

    Hint: Placards must be visible from all directions to warn emergency responders approaching from any angle.

    Explanation: Hazmat placards must be displayed on all four sides of the vehicle, front, rear, and both sides, so that they are visible from any direction. Each placard must be at least 10 3/4 inches square.

  8. Where must hazardous materials shipping papers be kept while driving?

    • A. In the glove compartment
    • B. In the trailer with the cargo
    • C. In a pouch on the driver's door
    • D. In a locked box mounted behind the cab

    Hint: Shipping papers for hazmat must be immediately accessible to the driver and to emergency responders.

    Explanation: Shipping papers for hazardous materials must be kept in a pouch on the driver's door or in clear view and within the driver's reach while the seat belt is fastened. This allows quick access in an emergency.

  9. When should a bus driver evacuate passengers?

    • A. When there is a fire or the bus cannot be safely moved
    • B. Whenever the bus breaks down
    • C. Only when instructed by emergency services
    • D. Only when the destination has been reached and the door cannot open

    Hint: Bus evacuation is a last resort that should only be initiated when remaining on the bus is more dangerous.

    Explanation: Passengers should be evacuated if there is a fire or danger of fire, or if the bus is in a position that makes staying inside dangerous and the bus cannot be safely moved.

  10. When driving a large commercial vehicle down a long, steep downgrade, you should:

    • A. Place the vehicle in neutral to reduce wear on the engine
    • B. Ride the brakes continuously to maintain a safe speed
    • C. Use a low gear and apply brakes intermittently with firm pressure
    • D. Accelerate slightly to maintain momentum

    Hint: Going down a long grade in a heavy vehicle requires a specific technique to prevent brake failure from overheating.

    Explanation: On long downgrades, use a low gear to let the engine help slow the vehicle and apply brakes with firm, intermittent pressure. Riding the brakes continuously causes them to overheat and fade, potentially resulting in total brake failure.

Mississippi questions make up 38 of the 108. Expect a question on what to watch when crossing the Mississippi River bridges (weight, height, wind and lane width), what CDL drivers may be asked to do during a hurricane evacuation, and how to drive through the heavy rain and tropical storms common on the Gulf side. Freight questions cover securing logging loads on a flatbed, MDOT permits for oversize or overweight loads, and the farm exemption for cotton or catfish hauling close to the farm.

The licensing questions ask about a first DUI in a commercial vehicle, serious traffic violations that lead to disqualification, and out-of-service orders for hours-of-service violations. You will also see which vehicles must always stop at railroad crossings.

The study cards divide the pool into 73 safe driving and cargo questions and 35 rules and licensing questions, with 10 free in each.

Key Topics

  • Mississippi River bridges and hurricane evacuations
  • Logging loads and MDOT oversize permits
  • DUI and serious violation disqualifications
  • Cargo securement and weight distribution
  • Hours of service and out-of-service orders
  • Railroad crossings and rain driving