Skip to content

Minnesota CDL study: Doubles/Triples questions

This deck holds all 46 Minnesota doubles and triples questions, 10 free with explanations, including the state question on trailer order. Coupling is more than a quarter of the deck, so start there. Then take doubles and triples run 1.

1/10·0 done

Question Map

Correct Wrong Unseen

10 of 46 questions are free. The rest are in Pro.

When driving double or triple trailers on I-94 or I-35 in Minnesota, where should the heaviest trailer be positioned?

Free Doubles/Triples questions questions for the Minnesota CDL test

Plain-text version of this question set

  1. When driving double or triple trailers on I-94 or I-35 in Minnesota, where should the heaviest trailer be positioned?

    • A. At the rear of the combination unit
    • B. Closest to the tractor, first position
    • C. In the middle position
    • D. Position does not matter at all

    Hint: Trailer positioning in a multi-trailer combination directly affects stability, with weight distribution being the key factor.

    Explanation: The heaviest trailer should always be positioned closest to the tractor (in the first position). This improves stability and handling, which is especially important on busy corridors like I-94 and I-35.

  2. A converter dolly used in doubles and triples is:

    • A. A piece of cargo-handling equipment carried under the trailer
    • B. A coupling device that converts a semitrailer to a full trailer
    • C. A storage container for spare tires
    • D. A type of brake controller

    Hint: It converts a semi into a full trailer.

    Explanation: A converter dolly is a coupling device of one or two axles and a fifth wheel by which a semitrailer can be coupled to the rear of a tractor-trailer combination, forming a double or triple bottom rig.

  3. When uncoupling a set of doubles, the FIRST step is usually to:

    • A. Disconnect the air lines
    • B. Pull the dolly away from the rear trailer
    • C. Park safely and apply the parking brakes
    • D. Lower the landing gear

    Hint: Stop motion first - then disassemble.

    Explanation: Before uncoupling, park the rig in a straight line on firm, level ground. Apply the parking brakes so the rig won't move.

  4. When making lane changes with doubles or triples, the driver should:

    • A. Make quick, sharp lane changes in order to clear the traffic
    • B. Use only the right lane
    • C. Make slow, gradual lane changes
    • D. Honk before each lane change

    Hint: Sudden inputs amplify down the train.

    Explanation: Steer gently and smoothly when pulling trailers. If you make a quick lane change, the crack-the-whip effect can turn the last trailer over.

  5. When making turns with a double or triple, the driver should:

    • A. Make sharper turns because the trailers will follow
    • B. Swing wide to allow for rear-trailer off-tracking
    • C. Cross the centerline to give more room
    • D. Always make a U-turn instead

    Hint: Rear trailers cut tighter than the tractor.

    Explanation: Doubles and triples have more off-tracking than single trailers, meaning the rear trailer follows a tighter path than the tractor. The driver must swing wider and watch the rear trailer to avoid hitting curbs, signs, or other vehicles.

  6. The supply (red) air line on a tractor-trailer combination:

    • A. Sends only electrical signals, and no air at all
    • B. Supplies the trailer tanks and emergency brakes
    • C. Carries diesel fuel back to the trailer tanks
    • D. Is optional on trailers under 40 feet long

    Hint: Red = emergency supply.

    Explanation: The supply line (red), or emergency line, supplies air to the trailer's air tanks and controls the emergency brakes. The service line (blue) carries air controlled by the foot brake or the trailer hand brake.

  7. If a converter dolly's air tank gauge shows low pressure, you should:

    • A. Drive at low speed to the next stop
    • B. Disconnect the air supply line
    • C. Ignore it - dolly air pressure is not important
    • D. Locate the cause before driving

    Hint: Low air = unsafe to drive.

    Explanation: If air pressure on a dolly's tank is low, find and fix the cause before driving. Low air pressure may indicate a leak that would prevent the dolly's brakes from working properly.

  8. When coupling a tractor to the lead trailer of a double, the fifth-wheel jaws should:

    • A. Close around the head of the kingpin but not the shank
    • B. Remain open until movement begins
    • C. Close around the shank of the kingpin
    • D. Lock only after the trailer is raised

    Hint: Around the shank, not just the head.

    Explanation: Check the fifth-wheel jaws have closed around the shank of the kingpin (not just the head). Use a flashlight if needed to look under the trailer.

  9. When pulling a double or triple, you notice the second trailer is swaying significantly. You should:

    • A. Accelerate to straighten it out
    • B. Slow gradually with the foot brake
    • C. Use the trailer hand valve to slow the rear
    • D. Apply the parking brake

    Hint: Smooth deceleration calms sway.

    Explanation: If a trailer begins to sway, do not use the trailer hand valve. Slow gradually with the foot brake and avoid sudden steering inputs to dampen the sway.

  10. When inspecting a double or triple, the dolly tow bar eye should be:

    • A. Cracked or worn, since that keeps them flexible
    • B. Rusted to indicate age
    • C. Free of cracks, with the pintle hook latched
    • D. Painted any color

    Hint: Cracks or unlatched hooks lead to breakaways.

    Explanation: Inspect the tow bar eye for cracks or other damage, and make sure the pintle hook is latched and the safety latch is closed. A failed pintle hook or damaged tow bar eye can cause the rear trailer to break loose.

One question in this pool is written for Minnesota: on its interstates, where should the heaviest trailer go? The answer applies everywhere: in the first position, closest to the tractor. A light trailer up front and a heavy one at the rear makes the rear trailer whip and roll in a quick lane change.

The rest of the pool is about the second hookup. Dollies get 4 questions, pintle hooks 3, and rearward amplification, uncoupling, configurations and air lines 2 each. Know how to position and lock the converter dolly, connect the lines, and check that air reaches the last trailer by opening its rear shut-off valve, listening, and closing it.

On slippery roads doubles lose grip and swing faster than a single trailer, so the pool asks about speed and following room. Minnesota winters make that more than theory.

Key Topics

  • No doubles on a Minnesota CLP
  • Heaviest trailer first on Minnesota interstates
  • Converter dolly and pintle hook
  • Air checks to the last trailer
  • Slippery roads and rearward amplification