Massachusetts CDL study: Pre-Trip Inspection questions
This deck holds all 50 Massachusetts pre-trip questions, 10 free with explanations, including the state's own items on air leakage, tire tread and brake drums. Read them with a vehicle in front of you if you can, then take pre-trip run 1.
Free Pre-Trip Inspection questions questions for the Massachusetts CDL test
Plain-text version of this question set
Which of the following would be a reason to put a commercial vehicle out of service during an inspection?
- A. A small chip in the windshield that does not obstruct view
- B. A burned-out clearance light on the side of the trailer
- C. A slightly loose mirror bracket
- D. A brake drum with a visible crack
Hint: Critical brake component failures represent the most serious category of inspection defects requiring immediate action.
Explanation: A cracked brake drum is a critical safety defect that requires the vehicle to be put out of service immediately. The vehicle cannot be driven until the drum is replaced.
What color must the rear identification lights be on a commercial vehicle?
- A. Amber
- B. Red
- C. White
- D. Yellow
Hint: The color coding of vehicle lights follows a universal standard: the rear always uses the color associated with 'stop.'
Explanation: Rear identification lights on a commercial vehicle must be red. These three lights are mounted at the top center of the rear of the vehicle to indicate its width.
During an air brake check on a dual air system, the air pressure should build from 85 to 100 psi within how long?
- A. 60 seconds
- B. 30 seconds
- C. 90 seconds
- D. 45 seconds
Hint: During an air brake check, there is a specific time limit for the air pressure to build from 85 to 100 psi.
Explanation: Air pressure in a dual air system should build from 85 to 100 psi within 45 seconds. If it takes longer, the air compressor or the system may have a problem.
Which step of the FMCSA seven-step inspection is the parking brake and service brake test?
- A. Step 2 - Engine compartment
- B. Step 7 - Start the engine and check the brake system
- C. Step 3 - Start engine and inspect inside the cab
- D. Step 5 - Walk-around inspection
Hint: It is the last step, where you confirm the vehicle can stop and steer safely before pulling out.
Explanation: Step 7 is the final brake-system check. With the wheels chocked, you test the parking brake by tugging gently against it in gear, then test the service brake for stopping action and for pull. Steering wheel free play is checked earlier, in step 3, inside the cab.
Per FMCSA, how often must a CDL driver inspect their commercial vehicle?
- A. Once per week
- B. Before every trip and after every trip
- C. Only at the start of each day
- D. Only when the vehicle has been flagged for a defect
Hint: Inspection is not a one-time event; safety checks bracket every shift and continue while driving.
Explanation: Federal regulations require a pre-trip inspection before driving, en-route monitoring, and a post-trip inspection with a written DVIR at the end of each day.
When inspecting mirrors and windshield during the in-cab check, what is the standard requirement?
- A. Mirrors must be tinted to reduce sun glare
- B. Only the driver-side mirror must be checked
- C. Windshields may have any size crack as long as it is not in the driver's line of sight
- D. Mirrors and glass must be clean, adjusted, and undamaged
Hint: If you cannot see clearly out of it, it is a defect.
Explanation: All mirrors and glass surfaces must be clean and properly adjusted, with no damage or obstructions that impair the driver's view.
What is the minimum legal tread depth for STEERING (front) axle tires on a commercial motor vehicle?
- A. 4/32 inch
- B. 2/32 inch
- C. 6/32 inch
- D. 8/32 inch
Hint: Steering tires need DOUBLE the tread of other tires because they handle directional control.
Explanation: Steering-axle tires must have at least 4/32 inch of tread in every major groove.
While checking the wheels and rims, which of the following indicates a defect?
- A. Cracked rims, missing or loose lug nuts, or rust trails
- B. Lug nuts that are clean and tightened to the specified torque
- C. A rim with a uniform painted finish
- D. Wheel hubs that show no signs of oil leakage
Hint: Rust streaks from lug nuts are a classic warning sign on the skills test.
Explanation: Rim cracks, missing or loose lug nuts, and rust streaks radiating from lug nuts (which indicate the nut is loose and moving) are all defects requiring immediate attention.
During a static air-leak test on a COMBINATION vehicle (tractor + trailer), the maximum allowable air-pressure loss with brakes released is:
- A. 2 psi per minute
- B. 4 psi per minute
- C. 3 psi per minute
- D. 6 psi per minute
Hint: Combinations have more hoses, so they are allowed slightly more leakage.
Explanation: A combination vehicle has more air lines and fittings, so the federal limit is 3 psi per minute (brakes released). Brakes applied raises it to 4 psi per minute.
Which color is the GLAD HAND coupler for the trailer SERVICE air line, and which color is the EMERGENCY (supply) line?
- A. Service = red, Emergency = blue
- B. Service = blue, Emergency = red
- C. Service = green, Emergency = yellow
- D. Service = yellow, Emergency = green
Hint: Emergency is the color of an emergency light.
Explanation: By convention, the service line is BLUE and the emergency (supply) line is RED. Crossing them prevents the trailer brakes from working correctly.
Every attempt costs money. The $35 skills test fee is due again for each failure, rejection, late arrival or no-show, and for any cancellation or reschedule with less than 72 hours notice. You may attempt no more than 6 CDL skills tests in a 12-month period, so book only when you are ready. The RMV may also cancel a test when public schools in the test town close or open late. After you pass, you go to an RMV Service Center to have the license issued.
Six of the 50 questions are written for Massachusetts. They ask the allowed air leakage with the engine off and brakes applied on a combination vehicle, how long to wait after charging the system before that leak test, the minimum front tire tread, which brake drum defect puts a vehicle out of service, what to verify in the engine compartment, and the color of rear identification lights. Learn the air brake check as one sequence.
Key Topics
- Booking the State Police road test in Massachusetts
- Fees, the 72-hour rule and the 6-test limit
- Air leakage and brake checks
- Tires, wheels and brake drums
- Engine compartment and lights