Georgia CDL study: Pre-Trip Inspection questions
This deck has 50 pre-trip questions for Georgia, 10 free with explanations, including 3 Georgia-written items. Go through it in walk-around order, front to back. Then take pre-trip run 1.
Free Pre-Trip Inspection questions questions for the Georgia CDL test
Plain-text version of this question set
During a vehicle inspection, you find a cracked windshield that impairs your vision. What should you do?
- A. Drive carefully to the nearest repair shop
- B. Do not drive until the windshield is repaired
- C. Cover the crack with tape and continue driving
- D. Report it at the end of your trip
Hint: Any defect that could compromise the driver's ability to see the road clearly is considered an out-of-service condition.
Explanation: A cracked windshield that impairs the driver's vision is an out-of-service condition. The vehicle must not be driven until it is repaired.
Which document must a CDL driver review before each trip in Georgia?
- A. The vehicle's original purchase agreement papers
- B. The vehicle's insurance policy
- C. The vehicle's emission test results
- D. The previous driver's inspection report (DVIR)
Hint: This document provides a record of any mechanical issues found by the previous driver.
Explanation: Before starting a trip, the driver must review the previous driver's vehicle inspection report (DVIR) and sign it to acknowledge awareness of any reported defects.
During an air brake check on a dual air system, the air pressure should build from 85 to 100 psi within how long?
- A. 60 seconds
- B. 30 seconds
- C. 90 seconds
- D. 45 seconds
Hint: During an air brake check, there is a specific time limit for the air pressure to build from 85 to 100 psi.
Explanation: Air pressure in a dual air system should build from 85 to 100 psi within 45 seconds. If it takes longer, the air compressor or the system may have a problem.
Which step of the FMCSA seven-step inspection is the parking brake and service brake test?
- A. Step 2 - Engine compartment
- B. Step 7 - Start the engine and check the brake system
- C. Step 3 - Start engine and inspect inside the cab
- D. Step 5 - Walk-around inspection
Hint: It is the last step, where you confirm the vehicle can stop and steer safely before pulling out.
Explanation: Step 7 is the final brake-system check. With the wheels chocked, you test the parking brake by tugging gently against it in gear, then test the service brake for stopping action and for pull. Steering wheel free play is checked earlier, in step 3, inside the cab.
Per FMCSA, how often must a CDL driver inspect their commercial vehicle?
- A. Once per week
- B. Before every trip and after every trip
- C. Only at the start of each day
- D. Only when the vehicle has been flagged for a defect
Hint: Inspection is not a one-time event; safety checks bracket every shift and continue while driving.
Explanation: Federal regulations require a pre-trip inspection before driving, en-route monitoring, and a post-trip inspection with a written DVIR at the end of each day.
When inspecting mirrors and windshield during the in-cab check, what is the standard requirement?
- A. Mirrors must be tinted to reduce sun glare
- B. Only the driver-side mirror must be checked
- C. Windshields may have any size crack as long as it is not in the driver's line of sight
- D. Mirrors and glass must be clean, adjusted, and undamaged
Hint: If you cannot see clearly out of it, it is a defect.
Explanation: All mirrors and glass surfaces must be clean and properly adjusted, with no damage or obstructions that impair the driver's view.
What is the minimum legal tread depth for STEERING (front) axle tires on a commercial motor vehicle?
- A. 4/32 inch
- B. 2/32 inch
- C. 6/32 inch
- D. 8/32 inch
Hint: Steering tires need DOUBLE the tread of other tires because they handle directional control.
Explanation: Steering-axle tires must have at least 4/32 inch of tread in every major groove.
While checking the wheels and rims, which of the following indicates a defect?
- A. Cracked rims, missing or loose lug nuts, or rust trails
- B. Lug nuts that are clean and tightened to the specified torque
- C. A rim with a uniform painted finish
- D. Wheel hubs that show no signs of oil leakage
Hint: Rust streaks from lug nuts are a classic warning sign on the skills test.
Explanation: Rim cracks, missing or loose lug nuts, and rust streaks radiating from lug nuts (which indicate the nut is loose and moving) are all defects requiring immediate attention.
During a static air-leak test on a COMBINATION vehicle (tractor + trailer), the maximum allowable air-pressure loss with brakes released is:
- A. 2 psi per minute
- B. 4 psi per minute
- C. 3 psi per minute
- D. 6 psi per minute
Hint: Combinations have more hoses, so they are allowed slightly more leakage.
Explanation: A combination vehicle has more air lines and fittings, so the federal limit is 3 psi per minute (brakes released). Brakes applied raises it to 4 psi per minute.
Which color is the GLAD HAND coupler for the trailer SERVICE air line, and which color is the EMERGENCY (supply) line?
- A. Service = red, Emergency = blue
- B. Service = blue, Emergency = red
- C. Service = green, Emergency = yellow
- D. Service = yellow, Emergency = green
Hint: Emergency is the color of an emergency light.
Explanation: By convention, the service line is BLUE and the emergency (supply) line is RED. Crossing them prevents the trailer brakes from working correctly.
This pool has 50 questions, nearly all on the pre-trip itself, with 3 written for Georgia. One asks what to do about a cracked windshield that blocks your view (do not drive until it is fixed). Another covers the low-pressure warning during the air brake check, and a third asks which document you review before each trip: the previous driver's inspection report.
Think of the test as a walk-around you narrate. Name each part, say what you are checking for, such as cracks, leaks, proper mounting or tread, and touch it. The engine compartment, steering, suspension, brakes, tires, lights and coupling devices are the usual sections, and the in-cab air brake check is where many drivers stumble.
If you test with a third-party examiner, allow 48 business hours before finishing your license at a DDS center. Knowledge test failures can also push back your skills retest date, so pass all written tests first. The DDS road test page has the scheduling tool.
Key Topics
- Georgia skills test booking, $50 fee and 72-hour notice
- Previous driver's inspection report
- Windshield and lights
- In-cab air brake check
- Tires, wheels and suspension