Skip to content

District of Columbia CDL study: Pre-Trip Inspection questions

This deck holds all 53 District pre-trip questions, 10 free. Read the eight D.C. items first, especially the air brake checks, then the general routine. Say every check out loud, then try pre-trip run 1.

1/10·0 done

Question Map

Correct Wrong Unseen

10 of 53 questions are free. The rest are in Pro.

What is the minimum pressure at which the air compressor governor should cut in to start building air pressure?

Free Pre-Trip Inspection questions questions for the District of Columbia CDL test

Plain-text version of this question set

  1. What is the minimum pressure at which the air compressor governor should cut in to start building air pressure?

    • A. 60 psi
    • B. 80 psi
    • C. 120 psi
    • D. 100 psi

    Hint: The governor regulates the air compressor to maintain proper system pressure.

    Explanation: The air compressor governor should cut in at approximately 100 psi to begin rebuilding air pressure. It should cut out at about 125 psi.

  2. How often must a commercial vehicle driver perform a pre-trip inspection?

    • A. Weekly
    • B. Daily, before driving
    • C. Monthly
    • D. Only after repairs

    Hint: Pre-trip inspections are a fundamental CDL driver responsibility.

    Explanation: Federal regulations require a pre-trip inspection before each trip or each driving day. The driver must be satisfied the vehicle is safe before operating it.

  3. During an air brake check on a dual air system, the air pressure should build from 85 to 100 psi within how long?

    • A. 60 seconds
    • B. 30 seconds
    • C. 90 seconds
    • D. 45 seconds

    Hint: During an air brake check, there is a specific time limit for the air pressure to build from 85 to 100 psi.

    Explanation: Air pressure in a dual air system should build from 85 to 100 psi within 45 seconds. If it takes longer, the air compressor or the system may have a problem.

  4. Per FMCSA, how often must a CDL driver inspect their commercial vehicle?

    • A. Once per week
    • B. Before every trip and after every trip
    • C. Only at the start of each day
    • D. Only when the vehicle has been flagged for a defect

    Hint: Inspection is not a one-time event; safety checks bracket every shift and continue while driving.

    Explanation: Federal regulations require a pre-trip inspection before driving, en-route monitoring, and a post-trip inspection with a written DVIR at the end of each day.

  5. When inspecting mirrors and windshield during the in-cab check, what is the standard requirement?

    • A. Mirrors must be tinted to reduce sun glare
    • B. Only the driver-side mirror must be checked
    • C. Windshields may have any size crack as long as it is not in the driver's line of sight
    • D. Mirrors and glass must be clean, adjusted, and undamaged

    Hint: If you cannot see clearly out of it, it is a defect.

    Explanation: All mirrors and glass surfaces must be clean and properly adjusted, with no damage or obstructions that impair the driver's view.

  6. What is the minimum legal tread depth for STEERING (front) axle tires on a commercial motor vehicle?

    • A. 4/32 inch
    • B. 2/32 inch
    • C. 6/32 inch
    • D. 8/32 inch

    Hint: Steering tires need DOUBLE the tread of other tires because they handle directional control.

    Explanation: Steering-axle tires must have at least 4/32 inch of tread in every major groove.

  7. While checking the wheels and rims, which of the following indicates a defect?

    • A. Cracked rims, missing or loose lug nuts, or rust trails
    • B. Lug nuts that are clean and tightened to the specified torque
    • C. A rim with a uniform painted finish
    • D. Wheel hubs that show no signs of oil leakage

    Hint: Rust streaks from lug nuts are a classic warning sign on the skills test.

    Explanation: Rim cracks, missing or loose lug nuts, and rust streaks radiating from lug nuts (which indicate the nut is loose and moving) are all defects requiring immediate attention.

  8. During a static air-leak test on a COMBINATION vehicle (tractor + trailer), the maximum allowable air-pressure loss with brakes released is:

    • A. 2 psi per minute
    • B. 4 psi per minute
    • C. 3 psi per minute
    • D. 6 psi per minute

    Hint: Combinations have more hoses, so they are allowed slightly more leakage.

    Explanation: A combination vehicle has more air lines and fittings, so the federal limit is 3 psi per minute (brakes released). Brakes applied raises it to 4 psi per minute.

  9. Which color is the GLAD HAND coupler for the trailer SERVICE air line, and which color is the EMERGENCY (supply) line?

    • A. Service = red, Emergency = blue
    • B. Service = blue, Emergency = red
    • C. Service = green, Emergency = yellow
    • D. Service = yellow, Emergency = green

    Hint: Emergency is the color of an emergency light.

    Explanation: By convention, the service line is BLUE and the emergency (supply) line is RED. Crossing them prevents the trailer brakes from working correctly.

  10. What is required on the rear, sides, and front of most trailers for visibility?

    • A. Decorative paint and chrome trim
    • B. Only a single red reflector mounted in the center of the rear bumper
    • C. Reflective tape or reflectors plus working marker and clearance lights
    • D. Mud flaps only

    Hint: Reflective tape plus required lighting.

    Explanation: Trailers 80 inches or wider must have red-and-white conspicuity tape and marker/clearance/identification lights so they are visible at night and from the sides.

Eight questions in this pool are written for D.C., more than in most topics. They cover what should happen when you pump the brake pedal to drop air pressure, the governor cut-in point, how fast pressure should build in a dual system, how often you must inspect, the emergency equipment you carry, front tire tread depth, how far back the farthest warning triangle goes on a two-lane road, and the DVIR you complete after the trip.

Most of the remaining questions cover the pre-trip routine itself. Practice in the order you will use at the lot: engine compartment, cab checks and start-up, lights, a walk around the vehicle front to back, then the air brake checks. For every part, name what you check for: mounted, secure, not cracked, not leaking.

A second failure costs you three months, so treat the first attempt as the one that counts.

Key Topics

  • D.C. road test lot, 30-day hold and retest waits
  • Air brake checks: warning, governor, build-up
  • Emergency equipment and warning triangles
  • Tire tread and the DVIR
  • Walkaround order and what to say