Connecticut CDL study: Pre-Trip Inspection questions
The deck covers all 50 Connecticut pre-trip questions, 10 free. Begin with brakes and coupling, the two biggest groups, then the seven-step method. Say each check aloud as you go, then try pre-trip run 1.
Free Pre-Trip Inspection questions questions for the Connecticut CDL test
Plain-text version of this question set
Which step of the FMCSA seven-step inspection is the parking brake and service brake test?
- A. Step 2 - Engine compartment
- B. Step 7 - Start the engine and check the brake system
- C. Step 3 - Start engine and inspect inside the cab
- D. Step 5 - Walk-around inspection
Hint: It is the last step, where you confirm the vehicle can stop and steer safely before pulling out.
Explanation: Step 7 is the final brake-system check. With the wheels chocked, you test the parking brake by tugging gently against it in gear, then test the service brake for stopping action and for pull. Steering wheel free play is checked earlier, in step 3, inside the cab.
When inspecting mirrors and windshield during the in-cab check, what is the standard requirement?
- A. Mirrors must be tinted to reduce sun glare
- B. Only the driver-side mirror must be checked
- C. Windshields may have any size crack as long as it is not in the driver's line of sight
- D. Mirrors and glass must be clean, adjusted, and undamaged
Hint: If you cannot see clearly out of it, it is a defect.
Explanation: All mirrors and glass surfaces must be clean and properly adjusted, with no damage or obstructions that impair the driver's view.
When checking the engine compartment for leaks, what do colored fluids on the ground typically indicate?
- A. Dark = oil; green or orange = coolant; red = transmission
- B. All puddles are just condensation from the air conditioner
- C. Color does not matter - just clean it up
- D. Only black puddles indicate a real problem
Hint: Color tells you which system is leaking - and which system is leaking tells you how urgent the repair is.
Explanation: Each fluid has a distinctive color. Identifying the leak source by color helps you decide whether the vehicle is safe to drive.
What is the minimum legal tread depth for STEERING (front) axle tires on a commercial motor vehicle?
- A. 4/32 inch
- B. 2/32 inch
- C. 6/32 inch
- D. 8/32 inch
Hint: Steering tires need DOUBLE the tread of other tires because they handle directional control.
Explanation: Steering-axle tires must have at least 4/32 inch of tread in every major groove.
While checking the wheels and rims, which of the following indicates a defect?
- A. Cracked rims, missing or loose lug nuts, or rust trails
- B. Lug nuts that are clean and tightened to the specified torque
- C. A rim with a uniform painted finish
- D. Wheel hubs that show no signs of oil leakage
Hint: Rust streaks from lug nuts are a classic warning sign on the skills test.
Explanation: Rim cracks, missing or loose lug nuts, and rust streaks radiating from lug nuts (which indicate the nut is loose and moving) are all defects requiring immediate attention.
During a static air-leak test on a COMBINATION vehicle (tractor + trailer), the maximum allowable air-pressure loss with brakes released is:
- A. 2 psi per minute
- B. 4 psi per minute
- C. 3 psi per minute
- D. 6 psi per minute
Hint: Combinations have more hoses, so they are allowed slightly more leakage.
Explanation: A combination vehicle has more air lines and fittings, so the federal limit is 3 psi per minute (brakes released). Brakes applied raises it to 4 psi per minute.
Which color is the GLAD HAND coupler for the trailer SERVICE air line, and which color is the EMERGENCY (supply) line?
- A. Service = red, Emergency = blue
- B. Service = blue, Emergency = red
- C. Service = green, Emergency = yellow
- D. Service = yellow, Emergency = green
Hint: Emergency is the color of an emergency light.
Explanation: By convention, the service line is BLUE and the emergency (supply) line is RED. Crossing them prevents the trailer brakes from working correctly.
What is required on the rear, sides, and front of most trailers for visibility?
- A. Decorative paint and chrome trim
- B. Only a single red reflector mounted in the center of the rear bumper
- C. Reflective tape or reflectors plus working marker and clearance lights
- D. Mud flaps only
Hint: Reflective tape plus required lighting.
Explanation: Trailers 80 inches or wider must have red-and-white conspicuity tape and marker/clearance/identification lights so they are visible at night and from the sides.
What is the purpose of mud flaps (splash guards) on a tractor-trailer?
- A. Decoration
- B. To prevent water, mud, rocks, and debris from being thrown onto other vehicles
- C. To improve fuel economy
- D. To balance the trailer's weight evenly across both of the rear axle groups
Hint: They keep the truck from throwing rocks and water at cars behind.
Explanation: Mud flaps reduce spray and projectile debris from rear wheels. Most states require them; they must be properly mounted, not torn, not dragging on the ground, and the correct distance from the road surface.
What is a Driver Vehicle Inspection Report (DVIR), and when must one be prepared?
- A. A weekly summary of mileage and fuel use, prepared every Friday for the office
- B. A document filed only when an accident occurs
- C. A written report of vehicle condition and defects, done at each day's end
- D. A fuel-purchase log; prepared at each fuel stop
Hint: It is a daily written record of the vehicle's condition.
Explanation: At the end of each driving day, you must write a DVIR for each vehicle you drove. It must list any defects that affect safe driving, or say that none were found.
This pool has 50 questions, and 1 is written for Connecticut: the allowed air loss per minute in a static leak check on a single vehicle. Brakes and coupling lead with 9 questions each, then the seven-step method, engine compartment and tires with 4 each, and the DVIR and in-cab checks with 3 each.
The Connecticut General Knowledge pool has more inspection questions worth reviewing here: what to look for in the engine compartment, how to test service brakes, and which lights to verify. Practice the seven-step method in the order you will use it: vehicle overview, engine compartment, start-up and in-cab checks, lights, walkaround, signal lights, then the brake checks. For each part, say what you check for out loud: mounted, secure, not cracked, not leaking.
Because one failed section sends you back for a full retest a week later, rehearse until the routine is automatic.
Key Topics
- Connecticut skills test: whole-test fail rule
- Test vehicle rules before you start
- Seven-step inspection method
- Brakes, coupling and air leak checks
- Lights, tires and the DVIR