Skip to content

California CDL study: Pre-Trip Inspection questions

All 50 California pre-trip questions are in this deck, 10 free. Brakes and coupling are the largest groups, followed by the seven-step method. Study them in walk-around order, then try pre-trip run 1.

1/10·0 done

Question Map

Correct Wrong Unseen

10 of 50 questions are free. The rest are in Pro.

When checking slack adjusters on S-cam brakes during a California CDL pre-trip inspection, the push rod should not move more than approximately:

Free Pre-Trip Inspection questions questions for the California CDL test

Plain-text version of this question set

  1. When checking slack adjusters on S-cam brakes during a California CDL pre-trip inspection, the push rod should not move more than approximately:

    • A. Two inches
    • B. Half an inch
    • C. Three inches
    • D. One inch

    Hint: One inch of push rod travel is the maximum: more movement means the brakes are out of adjustment.

    Explanation: When you pull hard on each slack adjuster, it should not move more than about one inch where the push rod attaches. More movement indicates the brakes need adjustment.

  2. Which step of the FMCSA seven-step inspection is the parking brake and service brake test?

    • A. Step 2 - Engine compartment
    • B. Step 7 - Start the engine and check the brake system
    • C. Step 3 - Start engine and inspect inside the cab
    • D. Step 5 - Walk-around inspection

    Hint: It is the last step, where you confirm the vehicle can stop and steer safely before pulling out.

    Explanation: Step 7 is the final brake-system check. With the wheels chocked, you test the parking brake by tugging gently against it in gear, then test the service brake for stopping action and for pull. Steering wheel free play is checked earlier, in step 3, inside the cab.

  3. When inspecting mirrors and windshield during the in-cab check, what is the standard requirement?

    • A. Mirrors must be tinted to reduce sun glare
    • B. Only the driver-side mirror must be checked
    • C. Windshields may have any size crack as long as it is not in the driver's line of sight
    • D. Mirrors and glass must be clean, adjusted, and undamaged

    Hint: If you cannot see clearly out of it, it is a defect.

    Explanation: All mirrors and glass surfaces must be clean and properly adjusted, with no damage or obstructions that impair the driver's view.

  4. What is the minimum legal tread depth for STEERING (front) axle tires on a commercial motor vehicle?

    • A. 4/32 inch
    • B. 2/32 inch
    • C. 6/32 inch
    • D. 8/32 inch

    Hint: Steering tires need DOUBLE the tread of other tires because they handle directional control.

    Explanation: Steering-axle tires must have at least 4/32 inch of tread in every major groove.

  5. While checking the wheels and rims, which of the following indicates a defect?

    • A. Cracked rims, missing or loose lug nuts, or rust trails
    • B. Lug nuts that are clean and tightened to the specified torque
    • C. A rim with a uniform painted finish
    • D. Wheel hubs that show no signs of oil leakage

    Hint: Rust streaks from lug nuts are a classic warning sign on the skills test.

    Explanation: Rim cracks, missing or loose lug nuts, and rust streaks radiating from lug nuts (which indicate the nut is loose and moving) are all defects requiring immediate attention.

  6. During a static air-leak test on a COMBINATION vehicle (tractor + trailer), the maximum allowable air-pressure loss with brakes released is:

    • A. 2 psi per minute
    • B. 4 psi per minute
    • C. 3 psi per minute
    • D. 6 psi per minute

    Hint: Combinations have more hoses, so they are allowed slightly more leakage.

    Explanation: A combination vehicle has more air lines and fittings, so the federal limit is 3 psi per minute (brakes released). Brakes applied raises it to 4 psi per minute.

  7. Which color is the GLAD HAND coupler for the trailer SERVICE air line, and which color is the EMERGENCY (supply) line?

    • A. Service = red, Emergency = blue
    • B. Service = blue, Emergency = red
    • C. Service = green, Emergency = yellow
    • D. Service = yellow, Emergency = green

    Hint: Emergency is the color of an emergency light.

    Explanation: By convention, the service line is BLUE and the emergency (supply) line is RED. Crossing them prevents the trailer brakes from working correctly.

  8. What is required on the rear, sides, and front of most trailers for visibility?

    • A. Decorative paint and chrome trim
    • B. Only a single red reflector mounted in the center of the rear bumper
    • C. Reflective tape or reflectors plus working marker and clearance lights
    • D. Mud flaps only

    Hint: Reflective tape plus required lighting.

    Explanation: Trailers 80 inches or wider must have red-and-white conspicuity tape and marker/clearance/identification lights so they are visible at night and from the sides.

  9. What is the purpose of mud flaps (splash guards) on a tractor-trailer?

    • A. Decoration
    • B. To prevent water, mud, rocks, and debris from being thrown onto other vehicles
    • C. To improve fuel economy
    • D. To balance the trailer's weight evenly across both of the rear axle groups

    Hint: They keep the truck from throwing rocks and water at cars behind.

    Explanation: Mud flaps reduce spray and projectile debris from rear wheels. Most states require them; they must be properly mounted, not torn, not dragging on the ground, and the correct distance from the road surface.

  10. What is a Driver Vehicle Inspection Report (DVIR), and when must one be prepared?

    • A. A weekly summary of mileage and fuel use, prepared every Friday for the office
    • B. A document filed only when an accident occurs
    • C. A written report of vehicle condition and defects, done at each day's end
    • D. A fuel-purchase log; prepared at each fuel stop

    Hint: It is a daily written record of the vehicle's condition.

    Explanation: At the end of each driving day, you must write a DVIR for each vehicle you drove. It must list any defects that affect safe driving, or say that none were found.

If you fail any part of the skills test, the remaining parts are postponed. You get three tries on one application, and each failed segment counts toward those three. Each retest costs $46, though the handbook says retaking the vehicle inspection on the same application has no extra fee. Passed segments count only during the CLP's first 180 days, so renewing the permit means retaking them.

Our California pool has 50 pre-trip questions. Brakes and coupling lead with 9 each, then the seven-step method, the engine compartment and tires with 4 each, and air brake checks and in-cab checks with 3. Two are framed around California: how far a slack adjuster push rod should move and the pressure range where spring brakes should engage on the in-cab test.

California's General Knowledge pool adds pre-trip questions too, such as how many basic steps the inspection follows and which lights you must check.

Key Topics

  • California skills test booking and the ELP check
  • Three tries and the $46 retest fee
  • Seven-step inspection method
  • Brakes, slack adjusters and in-cab air test
  • Coupling, tires and lights