Arizona CDL study: Pre-Trip Inspection questions
This deck has all 52 Arizona pre-trip questions, 10 free. The walk-around dominates, and 6 questions are written for Arizona, from steering to exhaust leaks. Go through them in inspection order, then take pre-trip run 1.
Free Pre-Trip Inspection questions questions for the Arizona CDL test
Plain-text version of this question set
During an air brake check, the low air pressure warning should activate before the pressure drops below what level?
- A. 40 psi
- B. 50 psi
- C. 60 psi
- D. 80 psi
Hint: This warning gives the driver time to stop the vehicle safely before air pressure drops to a dangerous level.
Explanation: The low air pressure warning signal must come on before the air pressure drops below 60 psi in either the primary or secondary system.
During a CDL pre-trip inspection, what is the minimum tread depth for front tires?
- A. 2/32 inch
- B. 4/32 inch
- C. 6/32 inch
- D. 8/32 inch
Hint: Front tires have a stricter tread depth requirement than other tires because they are critical for steering.
Explanation: Front tires on a commercial vehicle must have a minimum tread depth of 4/32 inch. Other tires must have at least 2/32 inch.
Which step of the FMCSA seven-step inspection is the parking brake and service brake test?
- A. Step 2 - Engine compartment
- B. Step 7 - Start the engine and check the brake system
- C. Step 3 - Start engine and inspect inside the cab
- D. Step 5 - Walk-around inspection
Hint: It is the last step, where you confirm the vehicle can stop and steer safely before pulling out.
Explanation: Step 7 is the final brake-system check. With the wheels chocked, you test the parking brake by tugging gently against it in gear, then test the service brake for stopping action and for pull. Steering wheel free play is checked earlier, in step 3, inside the cab.
Per FMCSA, how often must a CDL driver inspect their commercial vehicle?
- A. Once per week
- B. Before every trip and after every trip
- C. Only at the start of each day
- D. Only when the vehicle has been flagged for a defect
Hint: Inspection is not a one-time event; safety checks bracket every shift and continue while driving.
Explanation: Federal regulations require a pre-trip inspection before driving, en-route monitoring, and a post-trip inspection with a written DVIR at the end of each day.
When inspecting mirrors and windshield during the in-cab check, what is the standard requirement?
- A. Mirrors must be tinted to reduce sun glare
- B. Only the driver-side mirror must be checked
- C. Windshields may have any size crack as long as it is not in the driver's line of sight
- D. Mirrors and glass must be clean, adjusted, and undamaged
Hint: If you cannot see clearly out of it, it is a defect.
Explanation: All mirrors and glass surfaces must be clean and properly adjusted, with no damage or obstructions that impair the driver's view.
While checking the wheels and rims, which of the following indicates a defect?
- A. Cracked rims, missing or loose lug nuts, or rust trails
- B. Lug nuts that are clean and tightened to the specified torque
- C. A rim with a uniform painted finish
- D. Wheel hubs that show no signs of oil leakage
Hint: Rust streaks from lug nuts are a classic warning sign on the skills test.
Explanation: Rim cracks, missing or loose lug nuts, and rust streaks radiating from lug nuts (which indicate the nut is loose and moving) are all defects requiring immediate attention.
During a static air-leak test on a COMBINATION vehicle (tractor + trailer), the maximum allowable air-pressure loss with brakes released is:
- A. 2 psi per minute
- B. 4 psi per minute
- C. 3 psi per minute
- D. 6 psi per minute
Hint: Combinations have more hoses, so they are allowed slightly more leakage.
Explanation: A combination vehicle has more air lines and fittings, so the federal limit is 3 psi per minute (brakes released). Brakes applied raises it to 4 psi per minute.
What component on a tractor-trailer fifth-wheel coupling locks around the kingpin?
- A. The locking jaws
- B. The release handle for the lock
- C. The trailer skid plate
- D. The frame mounting bracket
Hint: Their name describes what they do.
Explanation: The locking jaws inside the fifth wheel close around the kingpin to secure the trailer. After coupling, you must visually confirm the jaws are fully closed around the kingpin.
Which color is the GLAD HAND coupler for the trailer SERVICE air line, and which color is the EMERGENCY (supply) line?
- A. Service = red, Emergency = blue
- B. Service = blue, Emergency = red
- C. Service = green, Emergency = yellow
- D. Service = yellow, Emergency = green
Hint: Emergency is the color of an emergency light.
Explanation: By convention, the service line is BLUE and the emergency (supply) line is RED. Crossing them prevents the trailer brakes from working correctly.
What is the purpose of mud flaps (splash guards) on a tractor-trailer?
- A. Decoration
- B. To prevent water, mud, rocks, and debris from being thrown onto other vehicles
- C. To improve fuel economy
- D. To balance the trailer's weight evenly across both of the rear axle groups
Hint: They keep the truck from throwing rocks and water at cars behind.
Explanation: Mud flaps reduce spray and projectile debris from rear wheels. Most states require them; they must be properly mounted, not torn, not dragging on the ground, and the correct distance from the road surface.
This Arizona pool has 52 questions, 45 of them on the inspection walk-through and the rest on inspection items and the air brake check. Six are written for Arizona. They ask how often you must inspect, what to look for in the steering and exhaust systems, the front tire tread minimum, the low air warning point and the allowed air leakage rate.
The common failure is rushing. Examiners expect you to point to each part and say what you are checking for, such as cracks, leaks, missing bolts or wear. Practice in the same order every time so nothing is skipped.
MVD does not publish a retest rule for the skills test, so ask the tester what happens if you fail a part. Eligible service members and recent honorable veterans with two years of CMV experience can request a skills test waiver, which a commanding officer helps complete, but they still take the knowledge tests.
Key Topics
- Arizona skills test: MVD or third-party, you bring the vehicle
- Steering and exhaust checks
- Tires, wheels and suspension
- Air brake leakage and warning checks
- Engine compartment and in-cab items