Skip to content

Alaska CDL study: Safe driving, vehicle control and cargo

Two Alaska decks cover this test. Safe driving and cargo holds 75 questions and rules and licensing holds 39, with 10 free in each. Many Alaska-specific items on ice, cold and wildlife are in the first deck. After both, try run 1.

1/10·0 done

Question Map

Correct Wrong Unseen

10 of 75 questions are free. The rest are in Pro.

On Alaska's steep mountain grades, what is the correct technique to avoid brake fade when descending?

Free Safe driving, vehicle control and cargo questions for the Alaska CDL test

Plain-text version of this question set

  1. On Alaska's steep mountain grades, what is the correct technique to avoid brake fade when descending?

    • A. Ride the brakes continuously to maintain a slow speed
    • B. Use a low gear and apply brakes intermittently
    • C. Shift to neutral and use the brakes only when speed increases
    • D. Apply the parking brake to supplement the service brakes

    Hint: The correct technique uses the engine's compression to slow the vehicle, reserving brake application for speed control in intervals.

    Explanation: The proper technique is to select a low gear before descending and use the snub braking method: apply brakes firmly to reduce speed, then release to let them cool. Continuous braking causes fade.

  2. When uncoupling a tractor-trailer, what should you do before disconnecting the air lines?

    • A. Lower the landing gear
    • B. Remove the wheel chocks
    • C. Shift into high gear
    • D. Release the parking brake

    Hint: The landing gear must bear the trailer's weight before the tractor can safely pull away.

    Explanation: Before disconnecting air lines and pulling away, you must lower the landing gear to support the trailer's weight. This prevents the trailer nose from dropping to the ground.

  3. The longer the combination vehicle, the more the trailer will off-track. What should a driver do when making a right turn with a long trailer?

    • A. Speed up through the turn to reduce off-tracking
    • B. Turn the steering wheel quickly to complete the turn faster
    • C. Turn from the far right lane to minimize the turning arc
    • D. Swing wide to the left before turning right

    Hint: Longer vehicles have more severe off-tracking, requiring a specific turning technique.

    Explanation: With longer combination vehicles, drivers should swing wide or use a jug handle turn, moving slightly to the left before turning right to give the trailer wheels room to clear the curb and any objects on the inside of the turn.

  4. When inspecting tires during a pre-trip inspection, which condition would require the tire to be replaced before driving?

    • A. A minor scuff mark on the sidewall
    • B. Tread depth of less than 2/32 of an inch on a steer tire
    • C. A tread depth of 5/32 of an inch on a drive tire
    • D. Slightly uneven tread wear across the tire

    Hint: Steer tires have stricter tread depth requirements than drive or trailer tires because they control the vehicle's direction.

    Explanation: Front (steer) tires must have at least 4/32 of an inch tread depth and all other tires at least 2/32. A steer tire with less than 2/32 tread depth is well below the legal minimum and must be replaced immediately.

  5. What can happen if too much cargo weight is placed on the front axle of a truck?

    • A. The rear tires will blow out
    • B. The front tires can fail or steering can be impaired
    • C. The vehicle will understeer and have difficulty turning
    • D. The engine will overheat from the extra load

    Hint: Overloading the front axle affects the most critical vehicle control system.

    Explanation: Overloading the front axle can cause front tire failure and make steering extremely difficult or unresponsive. Proper weight distribution is essential for safe steering and braking.

  6. What is the purpose of a header board (headache rack) on a flatbed truck?

    • A. To provide a mounting point for clearance lights
    • B. To reduce wind resistance and improve fuel economy
    • C. To protect the cab from forward-shifting cargo
    • D. To support tarps covering the load

    Hint: The header board protects the cab from cargo that shifts forward during braking.

    Explanation: A header board (headache rack) is mounted behind the cab to protect the driver from cargo that shifts forward during hard braking or a collision. It acts as a barrier between the cargo and the cab.

  7. When transporting hazardous materials, placards must be placed on which sides of the vehicle?

    • A. Front and back only
    • B. Only on the side facing oncoming traffic
    • C. All four sides: front, rear, and both sides
    • D. Only on the rear of the vehicle

    Hint: Placards must be visible from all directions to warn emergency responders approaching from any angle.

    Explanation: Hazmat placards must be displayed on all four sides of the vehicle, front, rear, and both sides, so that they are visible from any direction. Each placard must be at least 10 3/4 inches square.

  8. Where must hazardous materials shipping papers be kept while driving?

    • A. In the glove compartment
    • B. In the trailer with the cargo
    • C. In a pouch on the driver's door
    • D. In a locked box mounted behind the cab

    Hint: Shipping papers for hazmat must be immediately accessible to the driver and to emergency responders.

    Explanation: Shipping papers for hazardous materials must be kept in a pouch on the driver's door or in clear view and within the driver's reach while the seat belt is fastened. This allows quick access in an emergency.

  9. When should a bus driver evacuate passengers?

    • A. When there is a fire or the bus cannot be safely moved
    • B. Whenever the bus breaks down
    • C. Only when instructed by emergency services
    • D. Only when the destination has been reached and the door cannot open

    Hint: Bus evacuation is a last resort that should only be initiated when remaining on the bus is more dangerous.

    Explanation: Passengers should be evacuated if there is a fire or danger of fire, or if the bus is in a position that makes staying inside dangerous and the bus cannot be safely moved.

  10. What following distance should a CMV driver maintain at speeds under 40 mph?

    • A. At least 2 seconds for any vehicle
    • B. At least 1 second per 10 feet of length
    • C. At least 4 seconds regardless of vehicle length
    • D. At least 1 car length for every 10 mph of speed

    Hint: CMV following distance calculations are based on vehicle length rather than car-lengths.

    Explanation: At speeds under 40 mph, CMV drivers should maintain at least 1 second of following distance for every 10 feet of vehicle length. For speeds over 40 mph, add an additional second.

This is our largest Alaska pool, 114 questions, and 44 of them are written for Alaska conditions. Expect questions on black ice, on how much to slow down on icy or snow-packed roads, on when tire chains are required, and on moose and caribou at dawn and dusk. Others ask what to carry on long remote routes, how to prepare a truck for extreme cold, why rural bridges deserve attention, and how to handle brake fade on steep mountain grades.

The pool splits into two cards: safe driving and cargo with 75 questions, and rules and licensing with 39. Operation and securement are the largest subtopics, followed by CDL classes and endorsements.

One thing to watch: several Alaska questions put a hazmat or passenger twist inside General Knowledge, such as where shipping papers go when you are behind the wheel or when bus riders hear about emergency exits. Read each scenario fully before answering.

Key Topics

  • Alaska winter driving: black ice, chains and extreme cold
  • Wildlife, remote highways and rural bridges
  • CDL classes and endorsements
  • Cargo securement and weight
  • Alcohol, out-of-service orders and disqualification
  • Hours of service and emergency equipment