# Kentucky CDL Pre-Trip Inspection practice questions (free set) Drivers under 21 should know one more rule: Kentucky does not accept skills test scores from outside the state for applicants under 21 or anyone with a K restriction. Plan to test in Kentucky. Interactive version with answers, hints and explanations: https://dmv-iq.com/kentucky-cdl-pre-trip-inspection-test/study/all-questions/ ## About the Kentucky CDL Pre-Trip Inspection knowledge test - Issuing agency: KYTC / KSP - Passing score: 80% - Source: the Kentucky Commercial Driver's License Manual ## Topics covered - KSP skills test booking and retest fees - Air brake check and air loss - Tires, wheels and brakes - Defects and the DVIR - Inspection order ## The 10 free questions This set has 51 questions in total; these 10 are free. The rest are in DMV IQ Pro. ### 1. During an air brake check, what is the maximum air pressure leakage rate allowed for a combination vehicle with the engine off and brakes applied? - A. 2 psi in one minute - B. 3 psi in one minute - C. 5 psi in one minute - D. 4 psi in one minute Hint: Combination vehicles are allowed a slightly higher leakage rate than single vehicles due to their additional connections. Explanation: For combination vehicles, the air leakage rate should be no more than 4 psi in one minute with the engine off and brakes fully applied. For single vehicles, the limit is 3 psi. ### 2. What is the minimum tread depth for front tires on a commercial vehicle? - A. 4/32 inch - B. 1/32 inch - C. 2/32 inch - D. 6/32 inch Hint: Front tires have a higher tread depth requirement because they handle most steering and are critical for directional control. Explanation: Front tires on a commercial vehicle must have at least 4/32 inch tread depth. Other tires must have at least 2/32 inch. Tires with less tread must be replaced. ### 3. During an air brake check on a dual air system, the air pressure should build from 85 to 100 psi within how long? - A. 60 seconds - B. 30 seconds - C. 90 seconds - D. 45 seconds Hint: During an air brake check, there is a specific time limit for the air pressure to build from 85 to 100 psi. Explanation: Air pressure in a dual air system should build from 85 to 100 psi within 45 seconds. If it takes longer, the air compressor or the system may have a problem. ### 4. Per FMCSA, how often must a CDL driver inspect their commercial vehicle? - A. Once per week - B. Before every trip and after every trip - C. Only at the start of each day - D. Only when the vehicle has been flagged for a defect Hint: Inspection is not a one-time event; safety checks bracket every shift and continue while driving. Explanation: Federal regulations require a pre-trip inspection before driving, en-route monitoring, and a post-trip inspection with a written DVIR at the end of each day. ### 5. When inspecting mirrors and windshield during the in-cab check, what is the standard requirement? - A. Mirrors must be tinted to reduce sun glare - B. Only the driver-side mirror must be checked - C. Windshields may have any size crack as long as it is not in the driver's line of sight - D. Mirrors and glass must be clean, adjusted, and undamaged Hint: If you cannot see clearly out of it, it is a defect. Explanation: All mirrors and glass surfaces must be clean and properly adjusted, with no damage or obstructions that impair the driver's view. ### 6. What is the minimum legal tread depth for STEERING (front) axle tires on a commercial motor vehicle? - A. 4/32 inch - B. 2/32 inch - C. 6/32 inch - D. 8/32 inch Hint: Steering tires need DOUBLE the tread of other tires because they handle directional control. Explanation: Steering-axle tires must have at least 4/32 inch of tread in every major groove. ### 7. While checking the wheels and rims, which of the following indicates a defect? - A. Cracked rims, missing or loose lug nuts, or rust trails - B. Lug nuts that are clean and tightened to the specified torque - C. A rim with a uniform painted finish - D. Wheel hubs that show no signs of oil leakage Hint: Rust streaks from lug nuts are a classic warning sign on the skills test. Explanation: Rim cracks, missing or loose lug nuts, and rust streaks radiating from lug nuts (which indicate the nut is loose and moving) are all defects requiring immediate attention. ### 8. During a static air-leak test on a COMBINATION vehicle (tractor + trailer), the maximum allowable air-pressure loss with brakes released is: - A. 2 psi per minute - B. 4 psi per minute - C. 3 psi per minute - D. 6 psi per minute Hint: Combinations have more hoses, so they are allowed slightly more leakage. Explanation: A combination vehicle has more air lines and fittings, so the federal limit is 3 psi per minute (brakes released). Brakes applied raises it to 4 psi per minute. ### 9. Which color is the GLAD HAND coupler for the trailer SERVICE air line, and which color is the EMERGENCY (supply) line? - A. Service = red, Emergency = blue - B. Service = blue, Emergency = red - C. Service = green, Emergency = yellow - D. Service = yellow, Emergency = green Hint: Emergency is the color of an emergency light. Explanation: By convention, the service line is BLUE and the emergency (supply) line is RED. Crossing them prevents the trailer brakes from working correctly. ### 10. What is required on the rear, sides, and front of most trailers for visibility? - A. Decorative paint and chrome trim - B. Only a single red reflector mounted in the center of the rear bumper - C. Reflective tape or reflectors plus working marker and clearance lights - D. Mud flaps only Hint: Reflective tape plus required lighting. Explanation: Trailers 80 inches or wider must have red-and-white conspicuity tape and marker/clearance/identification lights so they are visible at night and from the sides. ## More - [Kentucky CDL Pre-Trip Inspection test](https://dmv-iq.com/kentucky-cdl-pre-trip-inspection-test/) - [Kentucky CDL Pre-Trip Inspection practice run 1](https://dmv-iq.com/kentucky-cdl-pre-trip-inspection-test/test-1/) - [Kentucky CDL practice test](https://dmv-iq.com/kentucky-cdl-practice-test/) DMV IQ builds its CDL questions from each state's official CDL manual and the federal FMCSA rules.