# Florida CDL General Knowledge practice questions (free set) Forty-three of the 112 questions here are written for Florida. One asks what applies to truck drivers during a hurricane evacuation: follow emergency management directives. Another covers seaports such as Port Everglades and PortMiami, where port security rules, a TWIC card and designated routes apply. Others deal with the heat, which raises tire pressure and the risk of blowouts and heat illness, Florida's electronic toll roads, wet-road speed, and the farm vehicle exemption. Interactive version with answers, hints and explanations: https://dmv-iq.com/florida-cdl-general-knowledge-test/study/safe-driving-and-cargo/ ## About the Florida CDL General Knowledge knowledge test - Issuing agency: FLHSMV - Passing score: 80% - Source: the Florida CDL Handbook ## Topics covered - Hurricane evacuation rules for CMV drivers - Seaports, TWIC cards and port routing - Florida heat and tire blowouts - Under-21 intrastate restriction - Placards, securement and disqualifications ## The 10 free questions This set has 69 questions in total; these 10 are free. The rest are in DMV IQ Pro. ### 1. At what psi should the air compressor governor cut-out (stop pumping air) in a properly functioning air brake system? - A. 80-85 psi - B. 120-140 psi - C. 90-100 psi - D. 100-110 psi Hint: The governor regulates the maximum air pressure in the system to prevent damage from over-pressurization. Explanation: The air compressor governor should cut out at around 120-140 psi. At this pressure, the governor stops the compressor from pumping air. ### 2. When is it required to cover or secure loose cargo on an open flatbed trailer? - A. Only when traveling on interstate highways - B. At all times, to keep it from falling or spilling - C. Only during rain or other inclement weather conditions - D. Only when the load exceeds 10,000 pounds Hint: The requirement to secure loose cargo is not conditional on weather, speed, or load weight. Explanation: Loose cargo on open trailers must be covered or properly secured at all times to prevent it from falling, blowing, or spilling onto the roadway, which is a safety hazard and violation of Florida law. ### 3. The longer the combination vehicle, the more the trailer will off-track. What should a driver do when making a right turn with a long trailer? - A. Speed up through the turn to reduce off-tracking - B. Turn the steering wheel quickly to complete the turn faster - C. Turn from the far right lane to minimize the turning arc - D. Swing wide to the left before turning right Hint: Longer vehicles have more severe off-tracking, requiring a specific turning technique. Explanation: With longer combination vehicles, drivers should swing wide or use a jug handle turn, moving slightly to the left before turning right to give the trailer wheels room to clear the curb and any objects on the inside of the turn. ### 4. When inspecting tires during a pre-trip inspection, which condition would require the tire to be replaced before driving? - A. A minor scuff mark on the sidewall - B. Tread depth of less than 2/32 of an inch on a steer tire - C. A tread depth of 5/32 of an inch on a drive tire - D. Slightly uneven tread wear across the tire Hint: Steer tires have stricter tread depth requirements than drive or trailer tires because they control the vehicle's direction. Explanation: Front (steer) tires must have at least 4/32 of an inch tread depth and all other tires at least 2/32. A steer tire with less than 2/32 tread depth is well below the legal minimum and must be replaced immediately. ### 5. What is the maximum weight allowed on a single axle under federal bridge law? - A. 20,000 lbs - B. 15,000 lbs - C. 34,000 lbs - D. 25,000 lbs Hint: Federal bridge law sets specific weight limits for individual axles to protect road infrastructure. Explanation: Federal bridge law limits a single axle to 20,000 lbs and a tandem axle to 34,000 lbs. The total gross vehicle weight is limited to 80,000 lbs on interstate highways. ### 6. When transporting hazardous materials, placards must be placed on which sides of the vehicle? - A. Front and back only - B. Only on the side facing oncoming traffic - C. All four sides: front, rear, and both sides - D. Only on the rear of the vehicle Hint: Placards must be visible from all directions to warn emergency responders approaching from any angle. Explanation: Hazmat placards must be displayed on all four sides of the vehicle, front, rear, and both sides, so that they are visible from any direction. Each placard must be at least 10 3/4 inches square. ### 7. Where must hazardous materials shipping papers be kept while driving? - A. In the glove compartment - B. In the trailer with the cargo - C. In a pouch on the driver's door - D. In a locked box mounted behind the cab Hint: Shipping papers for hazmat must be immediately accessible to the driver and to emergency responders. Explanation: Shipping papers for hazardous materials must be kept in a pouch on the driver's door or in clear view and within the driver's reach while the seat belt is fastened. This allows quick access in an emergency. ### 8. If a hazardous material is leaking from your vehicle, what should you do first? - A. Continue driving to the nearest truck stop for help - B. Park the vehicle, secure the area, and keep people away - C. Try to identify and repair the leak - D. Call your dispatcher and wait for instructions Hint: A hazmat leak requires immediate containment actions focused on safety rather than cleanup. Explanation: If a hazmat leak is discovered, the driver should immediately park the vehicle away from populated areas, secure the scene, keep people away from the leak, and contact emergency services. ### 9. When should a bus driver evacuate passengers? - A. When there is a fire or the bus cannot be safely moved - B. Whenever the bus breaks down - C. Only when instructed by emergency services - D. Only when the destination has been reached and the door cannot open Hint: Bus evacuation is a last resort that should only be initiated when remaining on the bus is more dangerous. Explanation: Passengers should be evacuated if there is a fire or danger of fire, or if the bus is in a position that makes staying inside dangerous and the bus cannot be safely moved. ### 10. When driving a large commercial vehicle down a long, steep downgrade, you should: - A. Place the vehicle in neutral to reduce wear on the engine - B. Ride the brakes continuously to maintain a safe speed - C. Use a low gear and apply brakes intermittently with firm pressure - D. Accelerate slightly to maintain momentum Hint: Going down a long grade in a heavy vehicle requires a specific technique to prevent brake failure from overheating. Explanation: On long downgrades, use a low gear to let the engine help slow the vehicle and apply brakes with firm, intermittent pressure. Riding the brakes continuously causes them to overheat and fade, potentially resulting in total brake failure. ## More - [Florida CDL General Knowledge test](https://dmv-iq.com/florida-cdl-general-knowledge-test/) - [Florida CDL General Knowledge practice run 1](https://dmv-iq.com/florida-cdl-general-knowledge-test/test-1/) - [Florida CDL practice test](https://dmv-iq.com/florida-cdl-practice-test/) DMV IQ builds its CDL questions from each state's official CDL manual and the federal FMCSA rules.