# Connecticut CDL School Bus practice questions (free set) Plan your paperwork early. Approval letters expire after 90 days, and if you have lived in Connecticut less than five years you must bring certified driving and criminal histories from prior states. With a school bus employer letter, the DMV waives the knowledge, permit and skills test fees. A CDL renewal with a public passenger endorsement costs $118. Interactive version with answers, hints and explanations: https://dmv-iq.com/connecticut-cdl-school-bus-test/study/all-questions/ ## About the Connecticut CDL School Bus knowledge test - Issuing agency: DMV - Passing score: 80% - Source: the Connecticut Commercial Driver License Manual ## Topics covered - Connecticut S Public Passenger Endorsement - Background, DCF and sex offender checks - English-only school bus test, 16 of 20 - Danger zones and mirror setup - Loading, unloading and evacuation ## The 10 free questions This set has 40 questions in total; these 10 are free. The rest are in DMV IQ Pro. ### 1. Which area in front of the bus is especially dangerous because the driver cannot see it directly from the seat? - A. The stretch of roadway more than 25 feet ahead of the front bumper - B. Immediately in front of the bus - C. The paved shoulder running alongside the length of the bus - D. The area behind the rear bumper covered by the back-up camera Hint: A child standing right in front of the bumper may not be visible from the driver's seat. Explanation: Directly in front of the bus is a blind area where a small child can be hidden from the driver. Crossover mirrors and a careful visual sweep are required before the bus starts moving. ### 2. The alternating flashing RED lights and the extended stop arm of a school bus indicate that: - A. The bus is about to pull away from the stop and rejoin traffic - B. The bus has broken down and traffic should pass with care - C. The bus has been pulled over by police for a routine stop - D. The bus is loading or unloading and traffic must stop Hint: Red lights and stop arm = stopped for children = everyone else stops. Explanation: The red flashing lights and the extended stop arm signal that the bus is stopped to load or unload students. Other traffic must stop and remain stopped until the lights stop flashing and the stop arm is retracted. ### 3. Before activating the red flashing lights at a stop, the school bus driver should: - A. Open the entrance door first so waiting students can begin boarding straight away - B. Stop at least 10 feet from students, set the parking brake, then the red lights - C. Sound the horn to tell waiting students the bus has arrived - D. Drive past the stop once to clear traffic, then come back Hint: Bus stopped, parking brake on, then red lights, then door. Explanation: The procedure is to stop the bus a safe distance (at least 10 feet) from waiting students, set the parking brake, and then activate the red lights and stop arm before opening the door. ### 4. Students who must cross the roadway after exiting the bus should: - A. Walk behind the bus so the driver can watch them in the rear mirror - B. Walk 10 feet in front, then cross when signaled - C. Cross between parked cars where the gap in traffic is largest - D. Cross as quickly as possible without waiting for a signal Hint: Walk in front where the driver can see them, then cross on the driver's signal. Explanation: Crossing students should walk at least 10 feet ahead of the bus on the right side, far enough forward that the driver can see them, and cross only when the driver gives the agreed-upon signal that it is safe. ### 5. The crossing-control arm on a school bus is: - A. A device mounted on the rear of the bus to guide following traffic - B. A second stop arm at the rear, used on multi-lane roads only - C. A bar from the front bumper that keeps students away from the front - D. An item required on every school bus in every state without exception Hint: It pushes students forward, away from the front bumper and into the driver's view. Explanation: The crossing-control arm extends from the front bumper when the red lights are flashing. It forces students to walk far enough out in front of the bus that the driver can see them when they cross. ### 6. Adjusting outside flat and convex side mirrors before a school bus trip should be done: - A. At the bus barn at the start of each week, before the first route - B. Only when a passenger or monitor reports a visibility problem - C. Daily, before each trip, on level ground from the driving position - D. Never; the mirrors are pre-set at the factory and stay aligned Hint: Mirrors change with use - check them every trip. Explanation: Mirrors must be checked and adjusted daily, before each trip, with the bus on level ground and the driver seated in normal position so the danger zone, lane behind, and adjacent traffic are all visible. ### 7. The school bus driver's role in managing student behavior includes: - A. Ignoring disputes entirely so the driver is never distracted - B. Using firm physical discipline to restore order quickly and keep the route on time - C. Recognizing problems early, pulling over for minor issues, and reporting serious ones - D. Letting students sit wherever they like to reduce complaints Hint: Don't discipline while driving - pull over safely, then handle it. Report serious issues to the school. Explanation: Drivers should anticipate behavior issues, address minor problems by pulling over safely rather than disciplining while driving, and report serious incidents (fighting, bullying, harassment) to school authorities. ### 8. Under federal CDL rules, a school bus driver who transports 16 or more passengers (including the driver) generally needs: - A. A CDL with Passenger (P) and School Bus (S) endorsements - B. An ordinary Class D license, since the route is not interstate - C. A Passenger (P) endorsement alone, without the School Bus (S) - D. No CDL at all when driving entirely on private school property Hint: School bus = P + S, not just one or the other. Explanation: School bus drivers transporting 16 or more passengers (including the driver) need a CDL with both the Passenger (P) and School Bus (S) endorsements, plus the appropriate class for the bus. ### 9. Background check requirements for school bus drivers typically include: - A. A driving record check only, repeated once every five years - B. Fingerprinting only, held on file by the employing district - C. No background check at all, because holding the CDL is itself the screening - D. Criminal background check, disqualifying offenses, driving record Hint: It's more than just a clean driving record. Explanation: School bus drivers must pass criminal background checks (often fingerprint-based), driving record reviews, and they are disqualified for certain offenses per state and federal law. Many states also require child abuse and registry checks. ### 10. Minimum age requirements for school bus drivers: - A. Set at 18 nationwide by a single federal minimum age rule - B. Vary by state, typically 18 or 21, with 21 the federal interstate minimum - C. Set entirely by each school district, with no state or federal involvement - D. Set at 16 nationwide, matching the ordinary driving age Hint: There's a federal age for interstate (21) and a state-by-state age for intrastate. Explanation: Minimum ages vary by state for intrastate school bus operation, with 18 or 21 being most common. For interstate CDL operation, the federal minimum age is 21. ## More - [Connecticut CDL School Bus test](https://dmv-iq.com/connecticut-cdl-school-bus-test/) - [Connecticut CDL School Bus practice run 1](https://dmv-iq.com/connecticut-cdl-school-bus-test/test-1/) - [Connecticut CDL practice test](https://dmv-iq.com/connecticut-cdl-practice-test/) DMV IQ builds its CDL questions from each state's official CDL manual and the federal FMCSA rules.