# Alabama CDL Pre-Trip Inspection practice questions (free set) This pool has 53 questions, 44 of them on the inspection itself and the rest on inspection rules and the air brake check. Eight are framed around Alabama. One asks what to do first when you begin an inspection, which is review the last inspection report. Others cover steering free play and linkage, the emergency equipment you must verify, the engine compartment fluids, slack adjuster travel, and the pressure build-up and leak-down figures for the air brake check. Interactive version with answers, hints and explanations: https://dmv-iq.com/alabama-cdl-pre-trip-inspection-test/study/all-questions/ ## About the Alabama CDL Pre-Trip Inspection knowledge test - Issuing agency: ALEA - Passing score: 80% - Source: the Alabama Commercial Driver License Manual ## Topics covered - Alabama skills test: ALEA offices, $20, modernized format - Reviewing the last inspection report first - Engine compartment and steering checks - Emergency equipment and lights - Air brake check and slack adjusters ## The 10 free questions This set has 53 questions in total; these 10 are free. The rest are in DMV IQ Pro. ### 1. During a pre-trip air brake inspection in Alabama, what should you check the slack adjusters for? - A. Rust on the adjuster body only - B. Tire pressure readings at each axle - C. Fuel line connections near the frame - D. Proper pushrod travel adjustment Hint: Slack adjusters are the link between the brake chamber and the brake shoes in an air brake system. Explanation: Slack adjusters must be checked for proper adjustment during pre-trip inspection. Excessive brake pushrod travel indicates the brakes need adjustment and may not stop the vehicle safely. ### 2. During an Alabama CDL pre-trip inspection, what is the minimum tread depth required for front tires? - A. 4/32 inch - B. 2/32 inch - C. 6/32 inch - D. 8/32 inch Hint: Front tires have a higher minimum tread depth requirement because they are critical for steering control. Explanation: Front tires on a commercial vehicle must have a minimum tread depth of 4/32 inch. Other tires must have at least 2/32 inch of tread depth. ### 3. During an air brake check on a dual air system, the air pressure should build from 85 to 100 psi within how long? - A. 60 seconds - B. 30 seconds - C. 90 seconds - D. 45 seconds Hint: During an air brake check, there is a specific time limit for the air pressure to build from 85 to 100 psi. Explanation: Air pressure in a dual air system should build from 85 to 100 psi within 45 seconds. If it takes longer, the air compressor or the system may have a problem. ### 4. Which step of the FMCSA seven-step inspection is the parking brake and service brake test? - A. Step 2 - Engine compartment - B. Step 7 - Start the engine and check the brake system - C. Step 3 - Start engine and inspect inside the cab - D. Step 5 - Walk-around inspection Hint: It is the last step, where you confirm the vehicle can stop and steer safely before pulling out. Explanation: Step 7 is the final brake-system check. With the wheels chocked, you test the parking brake by tugging gently against it in gear, then test the service brake for stopping action and for pull. Steering wheel free play is checked earlier, in step 3, inside the cab. ### 5. Per FMCSA, how often must a CDL driver inspect their commercial vehicle? - A. Once per week - B. Before every trip and after every trip - C. Only at the start of each day - D. Only when the vehicle has been flagged for a defect Hint: Inspection is not a one-time event; safety checks bracket every shift and continue while driving. Explanation: Federal regulations require a pre-trip inspection before driving, en-route monitoring, and a post-trip inspection with a written DVIR at the end of each day. ### 6. When inspecting mirrors and windshield during the in-cab check, what is the standard requirement? - A. Mirrors must be tinted to reduce sun glare - B. Only the driver-side mirror must be checked - C. Windshields may have any size crack as long as it is not in the driver's line of sight - D. Mirrors and glass must be clean, adjusted, and undamaged Hint: If you cannot see clearly out of it, it is a defect. Explanation: All mirrors and glass surfaces must be clean and properly adjusted, with no damage or obstructions that impair the driver's view. ### 7. During a static air-leak test on a COMBINATION vehicle (tractor + trailer), the maximum allowable air-pressure loss with brakes released is: - A. 2 psi per minute - B. 4 psi per minute - C. 3 psi per minute - D. 6 psi per minute Hint: Combinations have more hoses, so they are allowed slightly more leakage. Explanation: A combination vehicle has more air lines and fittings, so the federal limit is 3 psi per minute (brakes released). Brakes applied raises it to 4 psi per minute. ### 8. What component on a tractor-trailer fifth-wheel coupling locks around the kingpin? - A. The locking jaws - B. The release handle for the lock - C. The trailer skid plate - D. The frame mounting bracket Hint: Their name describes what they do. Explanation: The locking jaws inside the fifth wheel close around the kingpin to secure the trailer. After coupling, you must visually confirm the jaws are fully closed around the kingpin. ### 9. Which color is the GLAD HAND coupler for the trailer SERVICE air line, and which color is the EMERGENCY (supply) line? - A. Service = red, Emergency = blue - B. Service = blue, Emergency = red - C. Service = green, Emergency = yellow - D. Service = yellow, Emergency = green Hint: Emergency is the color of an emergency light. Explanation: By convention, the service line is BLUE and the emergency (supply) line is RED. Crossing them prevents the trailer brakes from working correctly. ### 10. What is the purpose of mud flaps (splash guards) on a tractor-trailer? - A. Decoration - B. To prevent water, mud, rocks, and debris from being thrown onto other vehicles - C. To improve fuel economy - D. To balance the trailer's weight evenly across both of the rear axle groups Hint: They keep the truck from throwing rocks and water at cars behind. Explanation: Mud flaps reduce spray and projectile debris from rear wheels. Most states require them; they must be properly mounted, not torn, not dragging on the ground, and the correct distance from the road surface. ## More - [Alabama CDL Pre-Trip Inspection test](https://dmv-iq.com/alabama-cdl-pre-trip-inspection-test/) - [Alabama CDL Pre-Trip Inspection practice run 1](https://dmv-iq.com/alabama-cdl-pre-trip-inspection-test/test-1/) - [Alabama CDL practice test](https://dmv-iq.com/alabama-cdl-practice-test/) DMV IQ builds its CDL questions from each state's official CDL manual and the federal FMCSA rules.